Frigidaire Washer Belts

Frigidaire Appliance Parts
Shop By Part Type

Popular Frigidaire Washer Belts

Your Price
$19.32
  In Stock
Drive V-Belt
★★★★★
★★★★★
(24)
PartSelect Number PS1146950
Manufacturer Part Number 134511600
This rubber V-style drive belt slips on the motor pulley to bring the basket to the required speed. If you notice a burning rubber smell or grinding noises coming from your washer, your washer does not start, drain, spin properly (will not spin/spins slowly/will not agitate properly), or if your washer shakes or moves during the cycle; check your drive belt for signs of wear and tear. Replace the drive belt if you notice that the belt looks damaged. This OEM part is approximately 35 inches in length, and sold individually.
Fixes these symptoms
  • Burning smell
  • Noisy
  • Pumps but will not spin
  • See more...
Installation Instructions
rodney from fairfield bay, AR
replace broken drive belt
carefully pry up on front washer top to release plastic keeper pins,remove 2 phillips screws from beneath lower front washer panel,slightly lift upward on panel to release.remove old broken belt,push new belt beneath large tub pulley,put belt on small motor pulley,push back belt tension /idler arm,start belt on large tub pulley,turn tub pulley by hand to run belt on,release tension on idler arm.replace front panel and lower top.WALAAH!!!! you are done. Read more...
Your Price
$19.33
  On Order
Drive Belt - 6 ribs
★★★★★
★★★★★
(2)
PartSelect Number PS419285
Manufacturer Part Number 134051000
This is a drive belt for your washing machine. This part spins the basket in your appliance by connecting the drive motor to the drive system. You will need to replace the drive belt if your pumps are not spinning, your washer is not agitating, or you are noticing excess noise and/or a burning smell. This belt is black with six ribbings. To replace this part, you will need a Phillips screwdriver.
Fixes these symptoms
  • Burning smell
  • Noisy
  • Pumps but will not spin
  • See more...
Installation Instructions
Carmen from Foreston, MN
motor burned out, tub quit going around
First I turned off the water and disconnected the hoses. I took off the back panel and unscrewed the 4 bolts holding the motor in place. The grounding screw was impossible to remove, so I had to cut the wire off. Took out motor and disconnected the electrical connector. Put new motor in (ordered new belt, figuring it would need replacing - was still in excellent shape, but replaced it anyway), bolted in the motor (socket set works best on further away bolts, screwdriver for closer ones). Put the belt on the motor first and then pulled it up over the side of the tub and turned the tub to get it around the whole tub - took alittle bit of turning to get it on. Plugged in electrical connector and screwed grounding wire into hole. Replaced back panel and water hoses. Got a bit dirty and sweaty but not too hard to do it yourself, as I am a 48 yr woman and don't usually do this kind of thing. Read more...
Your Price
$48.55
  In Stock
Drive Belt
★★★★★
★★★★★
(2)
PartSelect Number PS1990787
Manufacturer Part Number 134051003
This drive belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear.
Fixes these symptoms
  • Burning smell
  • Noisy
  • Pumps but will not spin
  • See more...
Installation Instructions
Jeff from Thousand Oaks, CA
Door lock switch faulty preventing washer from spinning
Codes did not point directly to the door lock, so that was a 50/50 between door lock and control board. With top of washer removed door lock is just a couple screws and 3 electrical connections.

Belt was worn and frayed. Belt replacement was tricky because new belt was so tight. Used vice grips to lightly hold belt on pulley while using screwdriver through spokes into tub back to ratchet/control pulley. Not too bad.

Works like new!
Read more...
Your Price
$58.06
  On Order
Drive Belt
PartSelect Number PS2349239
Manufacturer Part Number 134616700
Your Price
$40.57
  Special Order
Dryer Drum Belt
PartSelect Number PS454127
Manufacturer Part Number 5303161099
This belt is flat with 3 ridges and length of 78.50” and width 1/4”.
Your Price
$23.27
  Special Order
V-Style Belt
PartSelect Number PS459613
Manufacturer Part Number 5303280326
This v-style belt or drive belt is designed for use in your washing machine. This part connects the drive motor to the drive system in the washer, which spins the basket. If you notice a burning smell when your washing machine is operating, or if your machine pumps but will not spin, you may have to replace the v-style belt. This part is cloth-covered. This product measures approximately 10 inches in diameter and is sold individually. This is an OEM part sourced directly from the manufacturer. Be sure to disconnect the power source from the washing machine before you begin this repair.
Fixes these symptoms
Installation Instructions
Kenneth from Baltimore, MD
belt worn causing machine to make all kinds of noise
pull up on top ,take two screws loose on front panel(pull off) vaccum old debri out,pull tension pulley back pull old belt off,holding tension pulley put new belt on .put front panel back on and snap top back down to secure.
working perfectly nice and quite !!!
Read more...
Your Price
$32.64
  Special Order
BELT
PartSelect Number PS12176483
Manufacturer Part Number 5304511359
Your Price
$97.89
  Special Order
BELT
PartSelect Number PS11699843
Manufacturer Part Number 132353120
Your Price
$35.71
  Special Order
BELT
PartSelect Number PS453067
Manufacturer Part Number 5302834353
Belt - "V" Shaped
PartSelect Number PS451040
Manufacturer Part Number 5300622451
This helps turn the pump and to help make the washer agitate properly. It is generally positioned between the motor and the pump.

Related Parts