EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

Frigidaire Refrigerator Electronics

Popular Frigidaire Refrigerator Electronics

If your refrigerator is not cooling, a failed compressor run capacitor may be the cause. This OEM capacitor helps the compressor start and supports its operation in refrigerators and freezers. It has a capacitance of 15 MFD, so check fit against your appliance model before ordering. A quarter-inch socket or nut driver is listed for replacement.
If your refrigerator is not cooling, a failed compressor run capacitor may be the cause. This OEM capacitor helps the compressor start and supports its operation in refrigerators and freezers. It has a capacitance of 15 MFD, so check fit against your appliance model before ordering. A quarter-inch socket or nut driver is listed for replacement.
What this part fixes:
  • Clicking sound
  • Doesn’t stop running
  • Freezer section too warm
Installation Instructions
James from Navarre, FL
After getting wiring diagram off internet it was diagnosed as freezer stuck in defrost mode, temp alarm on, but fan running.
Turned gray knob on defrost timer (located bottom left back of freezer) past defrost position to verify compressor would run...it would not, but fan would run. Tested run capacitor...found borderline defective (weak, wrong value ohm meter kick). Just to be sure, removed interior shelves and interior rear and gasket to check heater at 20 ohms as OK and removed thermostat and verified contact closure after exposure in another freezer....re-installed, hooked heater back up and re-installed interior rear panel. Replaced defrost timer by unplugging 4-pin connector, then removed 2 screws that hold it to the bracket. Installed new one in reverse order. Then removed wire bail holding run capacitor to compressor plug assembly, removed run capacitor, plugged in new one. Turned on freezer......now making ice and holding cold temperature and cycling properly between freeze and defrost modes. Two problems made this repair a bit more difficult. This is the second time that defrost timer has failed...only got 3 years from last one.
Steady compressor operation relies on the electrical support provided by this refrigerator run capacitor. It creates a phase shift in the motor circuit to help the compressor run as designed while circulating refrigerant through the cooling system. A failed capacitor may contribute to unusual humming, difficulty starting, or reduced cooling performance. Replacing a faulty capacitor helps restore proper electrical conditions for compressor operation. The component stores electrical energy and can retain a charge after power is disconnected, requiring care during handling and replacement. This is an OEM part sourced directly from the manufacturer.
Steady compressor operation relies on the electrical support provided by this refrigerator run capacitor. It creates a phase shift in the motor circuit to help the compressor run as designed while circulating refrigerant through the cooling system. A failed capacitor may contribute to unusual humming, difficulty starting, or reduced cooling performance. Replacing a faulty capacitor helps restore proper electrical conditions for compressor operation. The component stores electrical energy and can retain a charge after power is disconnected, requiring care during handling and replacement. This is an OEM part sourced directly from the manufacturer.
What this part fixes:
  • Clicking sound
  • Doesn’t stop running
  • Freezer section too warm
Installation Instructions
Jim Meeks from Wimberly, TX
The controller (current relay) burned up
1. Unhooked a retaining wire that secures the controller to the compressor terminal box. 2. removed destroyed part. 3. Got the model and serial numbers and got online. 4. Ordered part 5. Waited a couple of weeks to get part 6. Found that the manufacturer had daisy chained a bunch of components together with some funny deep socket plugs that by themselves are not routinely found so rather than buy a laundry list of unnecessary parts to get the aforementioned plus and make my customer wait a couple of more weeks I chose to connect the wires to a couple of high temperature female stainless steel quick connectors and feed the wires directly into the controller. Fortunately the controller had the polarity marked on the housing. (L for Line was the hot lead and C was for common the neutral lead) Failure to follow proper polarity will damage the part and could kill the compressors's start wimding.
$42.83
In Stock
A run capacitor supports motor operation in refrigerator and freezer systems. This OEM replacement is rated 12 µF, 250 VAC at 50/60 Hz. Check your appliance model number to confirm fit.
A run capacitor supports motor operation in refrigerator and freezer systems. This OEM replacement is rated 12 µF, 250 VAC at 50/60 Hz. Check your appliance model number to confirm fit.
This refrigerator run capacitor is a 220-volt, 12-microfarad component designed to support the compressor motor by providing continuous current to its windings. By regulating electrical flow, it helps the appliance maintain proper cooling performance and prevents issues such as excessive run time or temperature fluctuations. If your refrigerator or freezer is struggling to start or maintain its temperature, replacing the run capacitor may restore efficient operation. Always unplug the appliance before installation.
This refrigerator run capacitor is a 220-volt, 12-microfarad component designed to support the compressor motor by providing continuous current to its windings. By regulating electrical flow, it helps the appliance maintain proper cooling performance and prevents issues such as excessive run time or temperature fluctuations. If your refrigerator or freezer is struggling to start or maintain its temperature, replacing the run capacitor may restore efficient operation. Always unplug the appliance before installation.
What this part fixes:
  • Freezer section too warm
  • Fridge and Freezer are too warm
  • Fridge too warm
Installation Instructions
eric from inglewood, TN
Faulty Controller and Possibly Capacitor
After building a test box and determining the Controller was bad simply ordered parts and installed. Installation was a little difficult due to locking spades on electrical connections.

Unplug all power from freezer. Remove Bail wire from controller capacitor unit and remove from compressor by pulling STRAIGHT from compressor body to avoid bending contacts.

Use a very small instrumentation screwdriver to release locking spade on yellow and white wires. To unlock slide screwdriver in slot along wire entry to controller body while gently pulling on wire. Note position of wires and replace on new unit in same position/order. Plug new run capacitor into new controller being careful to orient capacitor to proper position (hole matches guide on controller unit). Plug newly installed controller and capacitor into condensor and replace bail wire.

Make sure timer is not in defrost mode - manually advance timer if necessary to ensure timer is in run mode. Turn temperature control to coldest setting. Plug in and hopefully enjoy the humming noise of your newly repaired and operational compressor and freezer.
$28.37
In Stock
Original Equipment Manufacturer

MAKE THIS REPAIR A GUARANTEED WIN

OVER 2 MILLION PARTS TO ENSURE VICTORY

$39.43
In Stock
$40.57
In Stock
$96.55
Special Order
$78.26
Special Order
$115.85
In Stock

More Frigidaire Refrigerator Parts

People often need to fix these common parts