KitchenAid Range Seals and Gaskets

Your Price

$11.14

KitchenAid Range Light Gasket

★★★★★

5 Reviews

PartSelect Number PS11740863

Manufacturer Part Number WP3184533

This part creates a seal around the light lens and bulb.

Installation Instructions

David from Westminster, CO

Fiber Gasket around Pyrex Light Lens was mis-shaped

All I had to do was unscrew the pyrex lens over the oven light and then remove the old gasket and replace it with the new one. Worked like a champ! Read more...

Your Price

$97.28

KitchenAid Range Inner Door Glass Gasket

PartSelect Number PS11747159

Manufacturer Part Number WP9755177

This part creates a seal around the inner door glass.

Installation Instructions

Don W. from Longmont, CO

Glass window shattered when touch by cold food

Never repaired an oven before, I just used a screwdriver and went slowly taking this over door apart to replace this glass. I just took piece by piece apart until the glass came out and retraced my steps to install the new glass. Sure glad I did this myself, a new convection oven stove would easily set me back 1,500.00 and......save a bundle on service call fees. Read more...

Your Price

$35.28

KitchenAid Range Gas Valve/Switch Seal Cover

PartSelect Number PS11740880

Manufacturer Part Number WP3188425

Part is located on top of the igniter switch that's next to the gas valve. Helps regulate gas flow and the amount of normal leakage that may occur.

Your Price

$91.25

KitchenAid Range GASKT-DOOR

PartSelect Number PS11742631

Manufacturer Part Number WP4455380

Your Price

$6.60

KitchenAid Range Switch Gasket

PartSelect Number PS11743885

Manufacturer Part Number WP71002569

Your Price

$8.71

KitchenAid Range SEAL-STRIP

PartSelect Number PS11746321

Manufacturer Part Number WP854334

Installation Instructions

Jimmy from Stratford, TX

The coils would freeze up and it wouldn't cool.

I removed the screws on the covers and remove them, then taken the screws from the timer, the temperature control just set in there, then pulled out a lttle ways and disconnected the wires and then removed. Installed the new ones. I taken the back panel off and removed the clip and pulled the defrost heater out a ways and removed the wires and removed the defrost heater. Installed the new defrost heater and clip and the covers. Read more...