One of eight clips broke off of the agitator assy allowing the assembly to come lose on heavy loads.
I replaced the coupling by only having to remove one bolt with a socket wrench. Once replaced I installed the new assy over the coupling making sure ro align the splines then pushing down until the as...read more

Bought used, realized did not have a detergent dispenser.
Found this part online. I just sets inside, did not click in like the bleach and fabric softener inserts. Think is ok, seems to work...read more

Top part of agitator was not locking in and turning
Remove top "cap" on agitator to expose the bolt that holds the agitator to the drum shaft. Undo the bolt and pull out the agitator. Disassemble, toss the old parts and install the new parts in reverse...read more

Replace Water Pump Coupling
Removed casing tip over washer disconnected water pump. Disconnected motor then replace coupling then reassemble motor then replaced water pump. ...read more

Somehow or another, the plastic cup inside vanished.
This was a really easy replacement job. All I had to do was twist the old Fabric Softener Dispenser to the left to unlock it, pull it off, and put the replacement on....read more

Fabric softener dispenser tub broke and would not stay on agitator shall.
Made sure the inner tub was sealed on main tub and snapped back in its place. You must make sure it completely snaps down and does not come off. Listen for the locking sound, then pull with a little ...read more

Broken Face Clips on dispenser drawer
I unclipped the old drawer parts from the broken drawer and replaced the old parts onto the new drawer and slid the whole drawer back in the washing machine. It took longer to type this that it did to...read more