My Orders
KitchenAid Washer Dispensers
GET YOUR OFFICIAL KitchenAid PARTS TO ENSURE VICTORY
Popular KitchenAid Washer Dispensers
This part holds the bleach until it is ready to be released into the cycle.
This part holds the bleach until it is ready to be released into the cycle.
Installation Instructions
RICHARD from PHILA, PA
Replace Water Pump Coupling
Removed casing tip over washer disconnected water pump. Disconnected motor then replace coupling then reassemble motor then replaced water pump.
This fabric softener dispenser releases softener at the proper time during the wash cycle to ensure even distribution. It helps prevent residue buildup on clothing and supports consistent fabric care. Replacing a cracked or clogged dispenser restores proper dispensing and improves wash results.
This fabric softener dispenser releases softener at the proper time during the wash cycle to ensure even distribution. It helps prevent residue buildup on clothing and supports consistent fabric care. Replacing a cracked or clogged dispenser restores proper dispensing and improves wash results.
Installation Instructions
Hazel from Bemidji, MN
need to have a fabric softner dispenser
the first order was ordered wrong for me and the part was to big so I had to send it back and order another. The second dispenser was the right one and went on well to the machine. Just had to put it on the machine by hand.
Use this dispenser for your direct drive washing machine.
Use this dispenser for your direct drive washing machine.
What this part fixes:
- Does not dispense fabric softener or detergent
- Will not agitate
- Will not drain
Installation Instructions
Dennis from Port Orchard, WA
No fabric softener dispenser
Pop the center cap off the agitator and snap the dispenser in. Easy as 1-2-3.
This part is the replacement detergent dispenser drawer for your washer. It is made of white plastic and is approximately 11 inches long, 6 inches wide, and 5 inches deep. The detergent dispenser is filled with detergent, which it dispenses during the wash cycle. If a lot of detergent remains in the dispenser after the wash cycle, your clothes aren’t getting clean, or you notice a crack or a break in the dispenser itself, it may need to be replaced. This is an OEM part sourced directly from the manufacturer, and is sold individually.
This part is the replacement detergent dispenser drawer for your washer. It is made of white plastic and is approximately 11 inches long, 6 inches wide, and 5 inches deep. The detergent dispenser is filled with detergent, which it dispenses during the wash cycle. If a lot of detergent remains in the dispenser after the wash cycle, your clothes aren’t getting clean, or you notice a crack or a break in the dispenser itself, it may need to be replaced. This is an OEM part sourced directly from the manufacturer, and is sold individually.
Installation Instructions
Geof from Garner, NC
Detergent leaking under Dispenser Drawer down front of Washer
Secondary problem was bleach being siphoned from dispenser prematurely when drawer slid in. Replaced Drawer, Detergent Container and Bleach Siphon parts. Appears to have been a change in the siphon design when compared to the original factory part. 5 loads completed since replacement of these parts with no premature siphon of bleach or
... Read more
leakage down the front of the washer.
Read less
Dispenser actuator attaches to the top of the dispenser and helps direct water to the detergent, bleach or fabric softener cups.
Dispenser actuator attaches to the top of the dispenser and helps direct water to the detergent, bleach or fabric softener cups.
MAKE THIS REPAIR A GUARANTEED WIN
OVER 2 MILLION PARTS TO ENSURE VICTORY
Installation Instructions
Geof from Garner, NC
Detergent leaking under Dispenser Drawer down front of Washer
Secondary problem was bleach being siphoned from dispenser prematurely when drawer slid in. Replaced Drawer, Detergent Container and Bleach Siphon parts. Appears to have been a change in the siphon design when compared to the original factory part. 5 loads completed since replacement of these parts with no premature siphon of bleach or
... Read more
leakage down the front of the washer.
Read less
Installation Instructions
Dante from ARCADIA, FL
Rusted hose clips and surfaces inside the washer.
Replacing the dispenser was easy and could have been done with very little disassembly, but I didn't even know the dispenser was broken or caused the rust. After I opened the console and removed the cabinet, I also had to take the top off the cabinet to clean out the rust, wire brush it and Rustoleum it. I also replaced all rusted clamp
... Read more
s. When I reassembled everything, I could not keep the piece the front end hose (for fabric softener) from dropping out of the bottom of the dispenser. The parts diagram didn't show the blue piece or hose clamp. The answer "expert" was useless. I ordered the dispenser because my only option was to replace the old washer. When it came, I found that piece was held up by GLUE. When that glue failed, there was nothing to keep it up to the bottom of the dispenser. When it dropped down on the top of the basket, it sprayed the pre-mixing water all around, instead of into the dispenser to pre-mix with softener. THAT'S what rusted all the other parts. I'm sure the prior owners never even knew it was broken.
Read less
Used with the detergent dispenser.
Used with the detergent dispenser.
Installation Instructions
Frederick W from FLETCHER, OK
Leaking bellow on my front loader..
Followed the most helpful video.with some system differences. Had quite a bit of fitment challenge with the inner bellow sealing process...finally used dish soap to help 'stretch' the thing on.Works fine now thanks.
