My Orders
Inglis Washer Dispensers
GET YOUR OFFICIAL Inglis PARTS TO ENSURE VICTORY
Popular Inglis Washer Dispensers
This is a shift actuator, and is designed for use in washing machines. This shift actuator is made to change the mode of the motor between spin and agitate, as well as communicate with the control board how fast the washer is spinning. If the shift actuator in your washer is broken or bad, it can lead to the washer not spinning or agitating correctly and may even show an error code related to that. This shift actuator is made mostly of plastic but does feature a 120V/60HZ/2.8W motor. This actuator is an OEM part and is sold individually.
This is a shift actuator, and is designed for use in washing machines. This shift actuator is made to change the mode of the motor between spin and agitate, as well as communicate with the control board how fast the washer is spinning. If the shift actuator in your washer is broken or bad, it can lead to the washer not spinning or agitating correctly and may even show an error code related to that. This shift actuator is made mostly of plastic but does feature a 120V/60HZ/2.8W motor. This actuator is an OEM part and is sold individually.
Installation Instructions
Steven from COHOES, NY
Machine would stop at spin cycle
After disconnecting water lines and power, tip machine onto its back. The actuator is located under the drum. Remove the cover over the motor/ drive belt. Actuator is located by the transmission and held on by several screws. Unplug the wiring harness and remove three screws with Phillips screwdriver. Install new actuator..
This part holds the bleach until it is ready to be released into the cycle.
This part holds the bleach until it is ready to be released into the cycle.
Installation Instructions
RICHARD from PHILA, PA
Replace Water Pump Coupling
Removed casing tip over washer disconnected water pump. Disconnected motor then replace coupling then reassemble motor then replaced water pump.
This fabric softener dispenser releases softener at the proper time during the wash cycle to ensure even distribution. It helps prevent residue buildup on clothing and supports consistent fabric care. Replacing a cracked or clogged dispenser restores proper dispensing and improves wash results.
This fabric softener dispenser releases softener at the proper time during the wash cycle to ensure even distribution. It helps prevent residue buildup on clothing and supports consistent fabric care. Replacing a cracked or clogged dispenser restores proper dispensing and improves wash results.
Installation Instructions
Hazel from Bemidji, MN
need to have a fabric softner dispenser
the first order was ordered wrong for me and the part was to big so I had to send it back and order another. The second dispenser was the right one and went on well to the machine. Just had to put it on the machine by hand.
This parts fits on top of the agitator.
This parts fits on top of the agitator.
Installation Instructions
Glenn from Merrick, NY
Top part of agitator was not locking in and turning
Remove top "cap" on agitator to expose the bolt that holds the agitator to the drum shaft. Undo the bolt and pull out the agitator. Disassemble, toss the old parts and install the new parts in reverse order. Repair took less than 5 minutes and we can now do full loads of laundry again!
Use this dispenser for your direct drive washing machine.
Use this dispenser for your direct drive washing machine.
What this part fixes:
- Does not dispense fabric softener or detergent
- Will not agitate
- Will not drain
Installation Instructions
Dennis from Port Orchard, WA
No fabric softener dispenser
Pop the center cap off the agitator and snap the dispenser in. Easy as 1-2-3.
MAKE THIS REPAIR A GUARANTEED WIN
OVER 2 MILLION PARTS TO ENSURE VICTORY
This detergent dispenser drawer is designed to hold and release laundry detergent, fabric softener, and bleach at the correct time during the wash cycle. It ensures proper distribution of cleaning agents for optimal washing performance. A faulty drawer can cause issues such as improper dispensing, leaks, or detergent residue on clothes. Replacing this part restores efficient operation and prevents messes. Installation requires basic hand tools and some disassembly of the washer—always disconnect power before starting.
This detergent dispenser drawer is designed to hold and release laundry detergent, fabric softener, and bleach at the correct time during the wash cycle. It ensures proper distribution of cleaning agents for optimal washing performance. A faulty drawer can cause issues such as improper dispensing, leaks, or detergent residue on clothes. Replacing this part restores efficient operation and prevents messes. Installation requires basic hand tools and some disassembly of the washer—always disconnect power before starting.
Installation Instructions
William from Laramie, WY
broke the soap drawer on the machine
pulled the old drawer out
unclipped the good parts that were attached to the broken drawer by the plastic clips holding them
clipped the good parts onto the new part
replaced the drawer back in the machine
works like new
unclipped the good parts that were attached to the broken drawer by the plastic clips holding them
clipped the good parts onto the new part
replaced the drawer back in the machine
works like new
Detergent Cover
Detergent Cover
