My Orders
Inglis Washer Knobs
GET YOUR OFFICIAL Inglis PARTS TO ENSURE VICTORY
Popular Inglis Washer Knobs
This insert is sold individually. Knob not included. Knob is sold separately.
This insert is sold individually. Knob not included. Knob is sold separately.
Installation Instructions
Larry from HICKORY, NC
The main knob insert snapped.
Nothing to it. Just remember to put the insert in the knob, NOT on the selector stem. Line up the flat part of the insert with the flat part of the stem and push the knob in place.
Don NOT ram it on the selector stem. When it's seated, don't push any more. That's all there is to it. It works. If the pointer on the knob indicat ... Read more es the selector is lined up correctly, but it isn't, the problem is the selector, not the knob.
Don NOT ram it on the selector stem. When it's seated, don't push any more. That's all there is to it. It works. If the pointer on the knob indicat ... Read more es the selector is lined up correctly, but it isn't, the problem is the selector, not the knob.
Read less
This control knob is for dryers.
Control knob lets you control cycle settings.
Remove the knob by pulling it straight off its post.
This control knob is for dryers.
Control knob lets you control cycle settings.
Remove the knob by pulling it straight off its post.
Installation Instructions
JEFFREY from MODESTO, CA
The broke of the knob and had to replace the whole mother board and the knob
I had to remove the whole top of the washer and unplugged all the wire to the board. Getting the board out was the hardest thing to do because no screws it was clamped in place. Once I figured how to unclamped the thing without breaking it, it was relatively simple and to only 15 min to button it back up.
This knob has been redesigned and now comes with metal threads.
This knob has been redesigned and now comes with metal threads.
Installation Instructions
Joe from Covington, GA
Washer would not wash on "normal" cycle. Had to play with the knob to get it to run at all. Washer would not drain properly either.
I unplugged the washer from the electrical outlet.
I then removed the drain hose from the wall drain to allow me to turn the washer to gain access to the the back panel.
From the front, I then removed the plastic timer knob from the timer by unscrewing it. Then I pulled the plastic plate with the arrow on it to re ... Read more move it. This exposed the screws that attached the timer to the control panel. I left them attached.
I then removed the two screws on the bottom of the front of the control panel (on each end) that attach the control panel to the washer.
I then went to the rear of the washer and removed the two screws on the top of the rear of the control panel.
I went back to the front and pulled the control panel forward and up to release it from the washer.
I then removed the two screws (that were under the plastic plate) that attached the timer to the panel and removed the timer from the panel.
Then I unplugged the wiring harness from the timer and removed the timer completely.
From there I reversed the procedure to install the new timer and knob.
I then removed the drain hose from the wall drain to allow me to turn the washer to gain access to the the back panel.
From the front, I then removed the plastic timer knob from the timer by unscrewing it. Then I pulled the plastic plate with the arrow on it to re ... Read more move it. This exposed the screws that attached the timer to the control panel. I left them attached.
I then removed the two screws on the bottom of the front of the control panel (on each end) that attach the control panel to the washer.
I then went to the rear of the washer and removed the two screws on the top of the rear of the control panel.
I went back to the front and pulled the control panel forward and up to release it from the washer.
I then removed the two screws (that were under the plastic plate) that attached the timer to the panel and removed the timer from the panel.
Then I unplugged the wiring harness from the timer and removed the timer completely.
From there I reversed the procedure to install the new timer and knob.
Read less
Sold individually. This knob accepts a D-shaped shaft.
Sold individually. This knob accepts a D-shaped shaft.
This knob accepts a double-flat shaft.
This knob accepts a double-flat shaft.
MAKE THIS REPAIR A GUARANTEED WIN
OVER 2 MILLION PARTS TO ENSURE VICTORY
Introducing a genuine OEM part specifically suited to boost the performance of a variety of Whirlpool appliances--the KNOB. This piece allows you to control the cycle settings on your dryer with ease. Its unique size and shape are tailor-made to fit specific Whirlpool models seamlessly. If you wish to replace your current one, the process is easy - simply pull the knob directly off its post. For an enhancement to your appliance that ensures precision, go for the KNOB! IMPORTANT: Before placing an online order, kindly verify if this is the correct part for your specific Whirlpool model.
Introducing a genuine OEM part specifically suited to boost the performance of a variety of Whirlpool appliances--the KNOB. This piece allows you to control the cycle settings on your dryer with ease. Its unique size and shape are tailor-made to fit specific Whirlpool models seamlessly. If you wish to replace your current one, the process is easy - simply pull the knob directly off its post. For an enhancement to your appliance that ensures precision, go for the KNOB! IMPORTANT: Before placing an online order, kindly verify if this is the correct part for your specific Whirlpool model.
Sold individually.
Sold individually.
Installation Instructions
gloria from dupont, WA
The washing machine know brokw
While my friends were visiting, they broke the knob off my washer. Now I am no good at repairs of any type, so my initial reaction was to get a new washer. Instead I went on the website and found a new knob. The website made it easy to match model numbers and get the exact knob. I got it in the mail ASAP and I just pushed it on. This
... Read more
may not sound like an impressive repair story but trust me, it was a lot for me. I saved myself $400.
Read less
