Official Roper Microwave Parts | Order Today, Ships Today | PartSelect

Popular Roper Microwave Parts

Your Price
$5.06
Light Bulb - 40W
(103)
PartSelect Number PS2376034
Manufacturer Part Number 8206232A
This exterior light bulb for your microwave is 40W and has a small screw-in base. To access the exterior light bulb, you will need to remove the panel on the bottom of the microwave using a Phillips screwdriver. If your exterior light bulb has not been changed before, it is probably held in place with some silicone. You will need to cut away this silicone to remove the old bulb. If you cannot access the silicone with a utility knife, it can be removed using dental floss. Once the silicone is removed, simply unscrew the old bulb, and replace it with the new one. Be sure to disconnect the power to the microwave before you begin this repair.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
Chris from Cedar Hill, TX says,

Burned out light under microwave and Filters needed changing
I just removed the multiple screws which held the hood cover on. I then attempted to remove the light bulbs from the socket. This proved impossible because the bulbs were so fragile from the heat an...read more

Your Price
$58.34
Glass Cooking Tray
(18)
PartSelect Number PS373741
Manufacturer Part Number 4393799
This a genuine OEM microwave cooking tray. It is also known as a microwave turntable or microwave plate. The function of the tray is to hold and rotate food items while the appliance is in use to ensure the food is being heated evenly. This cooking tray is made of transparent glass, and may need to be replaced if the tray is cracked or broken. A broken tray may prevent it from rotating if the three partial circles on the bottom of the tray will not connect to the turntable driver. This part is sold individually and is approximately 12 inches in diameter. It is recommended to check the drive coupling, or turntable driver, if tray is not turning.
Fixes these symptoms
Tray won’t turn


Installation Instructions
Eric from Durango, CO says,

Too much heat caused the turntable to shatter and the table support ring to melt.
Washed the turntable and placed it in the microwave....read more

Your Price
$9.84
Turntable Support Ring
(14)
PartSelect Number PS11756971
Manufacturer Part Number WPW10654906
This support ring sits underneath the glass turntable tray.
Fixes these symptoms
Noisy
Tray won’t turn


Installation Instructions
Eric from Durango, CO says,

Too much heat caused the turntable to shatter and the table support ring to melt.
Washed the turntable and placed it in the microwave....read more

Your Price
$8.98
Fuse
(5)
PartSelect Number PS1960938
Manufacturer Part Number W10138793
If your microwave is not turning on it could be due to your fuse needing to be replaced. This part protects the microwave by shutting it off if there is an electrical surge. This fuse is just over an inch long, is metallic on both ends and ceramic in the middle. Before beginning this repair, unplug the appliance and wait a few minutes before starting. Remove the outer cabinet which is held in place with two screws. You will then locate the power cord which will lead you to the fuse holder. Determine if the fuse has blown. Using an ohmmeter, you should be able to figure out if it has blown. A proper reading is zero ohms, if it reads as anything else then your fuse has in fact blown. Simply snap the old fuse out of place and place the new one in.
Fixes these symptoms
No heat
Won’t turn on


Installation Instructions
Daniel from DECATUR, GA says,

Microwave wouldn't turn on and found breaker been tripped and then microwave wouldn't turn on at all.
Read some instructions and easily found the fuse. Replaced it. Still didn't work. Took control panel off to check door switches. Nothing I read mentioned a second fuse. Tested and it to had blown. Ord...read more

Your Price
$21.51
Grease Filter
(11)
PartSelect Number PS1847969
Manufacturer Part Number 6802A
If the microwave exhaust fan is not circulating air properly, there could be an issue with the grease filter. A dirty filter will cause your microwave to run less efficiently and can alter the taste or smell of your food. Filters should be changed every six months for maximum performance. These silver, aluminum filters are sold separately, and are approximately 13 3/8 inches long x 5 7/8 inches wide. Measure your current filter to assure correct replacement. Check your grease filters regularly for particles and grease buildup to see if cleaning is necessary. If there is any visible damage to the filter, it should be replaced straight away.
Fixes these symptoms
Exhaust fan not working


Installation Instructions
Joseph from Las Vegas, NV says,

Dirty Grease Filter
Slide grease filter about 1/2 inch to right (or left) using the d-ring attached to one side and then pull down and out. Push charcoal filter frame slightly to rear and pry down from front. Install...read more

Your Price
$14.74
Grease Filter
(8)
PartSelect Number PS364628
Manufacturer Part Number 4358853
This is a vent hood grease filter manufactured for a variety of microwave models. It is made entirely of metal with a built-in tab for easy installation and removal. The vent hood filter collects grease particles that are in the exhaust air from cooking. Be sure to keep your filter clean. A clogged or dirty filter is a fire hazard and can cause your appliance to run inefficiently. This filter is approximately 7.5 inches wide and 5 inches deep. This replacement part is a genuine OEM part, is sourced from the original manufacturer, and is sold separately.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
Audrey from White Plains, NY says,

I Had A Hard Time Finding This Filter
I pulled out the old filters and just put in the new ones with ease, it was that simple. No screws was needed. ...read more

Your Price
$13.61
Charcoal Filter
(22)
PartSelect Number PS1871363
Manufacturer Part Number 8206230A
The charcoal filter in your microwave is designed to improve air circulation and eliminate odors while cooking. If the exhaust fan on your microwave is not working, you may need to replace your charcoal filter. This charcoal filter is located within the intake grille of your microwave, which will need to be unscrewed and opened to gain access to the filter. The manufacturer recommends that you change your charcoal filter every six months. This filter measures 5 inches by 5.375 inches by 0.375 inches. Be sure to measure your current filter to assure correct replacement. This product is sold individually.
Fixes these symptoms
Exhaust fan not working


Installation Instructions
Richard from San Antonio, TX says,

Mounting brackets are fragile and plastic support is easily broken
Replaced the intake grille. The grille should be removed prior to cleaning. The entire part is plastic and easily broken so that the two tabs for the mounting screws are shattered and will not hold ...read more

Your Price
$59.93
Door Interlock Switch Kit
(3)
PartSelect Number PS373050
Manufacturer Part Number 4392027
This part is a genuine manufacturer door interlock switch kit, also known as primary micro switch or microwave switch kit, for a microwave. The function of this part is to sense when the door of the microwave is open or closed. If the part is defective, the microwave will not start or will start when door is open. This kit contains two 15 Amp, 125/250 Volt switches with 3/16 inch terminals. Be sure to disconnect power to microwave before replacing part. Use extreme caution when replacing microwave parts, as high-voltage capacitors can retain an electrical charge when unplugged. NOTE: This kit includes 2 single pole, double throw (SPDT) micro switches. As per the manufacture for the secondary interlock switch order part # 56001100.
Fixes these symptoms
Won’t turn on


Installation Instructions
Robert from Bainbridge Island, WA says,

Microwave worked intermittently depending on how door was closed
Remove top grille (2 screws), undo control panel (1 screw). Tilt down control panel, switches are on the left. There are actually three switches that are involved with the door, two horizontally mou...read more

Your Price
$7.77
Light Bulb - 120V 25W
(8)
PartSelect Number PS11747806
Manufacturer Part Number WPA3073101
This light bulb is a 120 volt, 25 watt incandescent appliance light bulb with a small base screw-in that fits in a variety of appliances such as microwaves, refrigerators, freezers, cooktops, or stoves. Its purpose is to light up the appliance when the door is open. This is a genuine OEM part. You may need to replace the light bulb if the existing bulb is burnt out or broken. This light bulb is sold individually and is a common wear part, it is recommended to order a spare.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
Arau from Haverhill, MA says,

The door was crocked and wouldn't shut properly
Everything was easy. I read one of your other reviews and it gave me the confidence to try it myself. First i toke off the cap at the top of the door then the three screws. I lifted the door off so i ...read more

Your Price
$13.99
H.V. Diode
(5)
PartSelect Number PS11755602
Manufacturer Part Number WPW10492276
This diode, or high voltage diode, is used in microwaves. It is an electrical current control device that ensures power flows in one direction and not the other way. If your microwave produces no heat, heats inconsistently, or gets noisy, replacing this part can be the solution. The tools needed for this replacement are a nutdriver, pliers, and screwdrivers. First remove the microwave cover, then remove the old part by disconnecting the small thermostat. Replace with the new diode. Remember to use the diagram provided by the manufacturer for more instructions.
Fixes these symptoms
No heat
Noisy


Installation Instructions
kelvin from san diego, CA says,

no heat
this problem started two months ago when my micro quit heating up, after all the research most agreed it was the magnetron. taking the micowave apart is not to difficult just make sure you bag all the...read more