Quick Question!

Have you ever purchased from PartSelect.com before?

Models > MHE10RXB0

MHE10RXB0 Roper Microwave - Overview

Get Parts and Repair Help for MHE10RXB0

If you know the microwave repair part you need, you can browse the list of all parts on the MHE10RXB0, or you can search by name or part description. You can also find your part by where it is located on the MHE10RXB0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. We’ve also included any installation videos we have for MHE10RXB0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.42

Light Bulb - 40W

The 40W lightbulb is found in the interior of your microwave, which will need to be replaced if you have noticed the light is no longer coming on after opening the door. The light ...

Order within the next 1 hr and 38 mins and your part ships today!
$2.85

Top Mounting Screw

This screw is sold individually.

Order within the next 1 hr and 38 mins and your part ships today!
$2.96

SCREW

Sold individually.

Order within the next 1 hr and 38 mins and your part ships today!
$52.10

Door Interlock Switch Kit

This part is a genuine manufacturer door interlock switch kit, also known as primary micro switch or microwave switch kit, for a microwave. The function of this part is to sense when the door of the microwave is open or closed. If the part is defective, the microwave will not start or will start when door is open. This kit contains two 15 Amp, 125/250 Volt switches with 3/16 inch terminals. Be sure to disconnect power to microwave before replacing part. Use extreme caution when replacing microwave parts, as high-voltage capacitors can retain an electrical charge when unplugged.

Order within the next 1 hr and 38 mins and your part ships today!
$3.12

Screw

Sold Individually.

Order within the next 1 hr and 38 mins and your part ships today!
$4.88

SCREW

Order within the next 1 hr and 38 mins and your part ships today!
$11.05

Grease Filter

Sold individually. This metallic vent hood filter collects grease particles in the air from cooking.

Order within the next 1 hr and 38 mins and your part ships today!
$44.81

Door Handle Assembly

Order within the next 1 hr and 38 mins and your part ships today!
$6.42

FUSE

Order within the next 1 hr and 38 mins and your part ships today!
$42.27

Door Handle Assembly

Screws are NOT included.

Order within the next 1 hr and 38 mins and your part ships today!

Common Symptoms of the MHE10RXB0

[Viewing 1 of 1]
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave worked intermittently depending on how door was closed

  • Customer: Robert from Bainbridge Island, WA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 63 of 74 people found this instruction helpful
Remove top grille (2 screws), undo control panel (1 screw). Tilt down control panel, switches are on the left. There are actually three switches that are involved with the door, two horizontally mounted, one vertically mounted. This would be an EASY REPAIR, but it took me a while to figure out which of the three switches was bad, and also took a while to ... read more

Microwave went dead while in use.

  • Customer: Keith from Georgetown, TX
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 31 of 37 people found this instruction helpful
1. removed vent across the top to gain excess to Screw holding control in place. 2. Removed control panel to access Fuse. 3. Remover fuse after pulling plug. 4.Tested fuse for continuity with volt ohm meter noting no continuity.5. Orderd new fuse. 6. receeived new fuse and installed infuse holder.7. plugged microwave plug back in receptical and tested unit n... read more

burned out bulb

  • Customer: john from plainfield, IL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 20 of 27 people found this instruction helpful
removed two screws,lowered the glass shield,removed the burned out bulb and replaced it with the new one. I ordered the bulb from parts select and recieved it two days later. It was a pleasure to deal with them, and certainly use them again. read more