Hotpoint Range Brackets and Flanges

Your Price

$19.01

BRACKET ANTI-TIP Assembly

★★★★★

2 Reviews

PartSelect Number PS2364689

Manufacturer Part Number WB02K10254

Your Price

$15.05

Single Heating Element Support Clip

★★★★★

7 Reviews

PartSelect Number PS243701

Manufacturer Part Number WB2X9719

The metallic clip, or also known as a broil element support, is for a oven element on a range. This part holds the broil element in place on top of the oven. If your support clip is broken then this replacement should be the solution. The tools needed for this project are slip joint pliers. For safety precautions, make sure to unplug your range from the power source, or shut off the house circuit breaker before starting this project. Refer to the installation instructions for best results and accuracy.

Fixes these symptoms

Element will not heat
See more...

Installation Instructions

Paul from Canton, NY

broiling element had burned through, req. its replacement

First I removed the two screws that hold the element in place. I also removed a screw that held one end of a support bracket. I then pulled the element out about 3 inches and disconnected the two wires. Reversing these steps, I finished the element's replacement.

I had noticed that the former element was sagging at the front end. I installed the additional clips (not original) on each forward end of the element for additional support. Read more...

Your Price

$34.84

Anti-Tip Bracket

PartSelect Number PS241371

Manufacturer Part Number WB2K20

Includes screw.

Your Price

$26.39

Broil Element Support

PartSelect Number PS241927

Manufacturer Part Number WB2X1452

This part supports the broil element in the oven.

Installation Instructions

Donna from Sinking Spring, PA

Still need an other nut to keep broiler support inplcae. Support bar did not come with new screws so I must locate one new one.

I took out the old broiler support bar, but it was being held by one screw. I did install the new bar with one screw, but I need to obtain a second screw. I still have not located a second screw, but it is inplace. Read more...