Amana Range Hinges

Your Price

$58.76

Amana Range Door Hinge - Active With Spring

★★★★★

14 Reviews

PartSelect Number PS11752376

Manufacturer Part Number WPW10299224

This is a door hinge active with spring, for your range. The hinge controls the opening and closing of the oven door. If your oven door seems to be sticking, you may want to consider replacing this part. We recommend replacing both hinges at the same time. This model is roughly 9.5 inches long, f4 inches wide, and almost 1inch thick.

Fixes these symptoms

Door won’t close
See more...

Installation Instructions

Charles from PAYETTE, ID

DOOR HINGE BROKEN, NOT SUPPORTING DOOR

Followed youtube instructions: lifted clips on door hinges, removed door. removed screws, removed rear cover, replaced right hinge. reassembled door. caution: door handle will fall off when top two screws are removed. Alignment of screws is some what difficult, requires awl.
Replace door, return locking clips to forward position, check door for operation. Read more...

Your Price

$61.99

Amana Range Door Hinge - Left or Right Side

★★★★★

4 Reviews

PartSelect Number PS2087906

Manufacturer Part Number 74010546

This door hinge can be used for the left or right side. As per the manufacturer if the hinges have never been replaced on the appliance, they suggest to replace the door hinge receptacle kit.

Fixes these symptoms

Door won’t close
See more...

Installation Instructions

Norman from Brockton, MA

I leaned on the door and broke the hindge

I had a lot of trouble unlocking the door hindge you must pull the door out to change the hinge they are on the hinge and slide foward then pull the door up and out lay the door flat on a table cover the table with a towel so you don't scrach either one. Unscrew 6 screws on the door cover. 3 on top 3 on bottom take the cover off the hinges are exposed there 3 screws on the hinge 1 on the front and 2 on the bottom replace hinges install face insert door and lock the hinge it's all done. I wish I had these directions Read more...

Your Price

$83.11

Amana Range Door Hinge - Left or Right Side

★★★★★

3 Reviews

PartSelect Number PS2088468

Manufacturer Part Number 74011142

Sold individually.

Fixes these symptoms

Door won’t close
See more...

Installation Instructions

Patrick from MORAGA, CA

Two digits on the touch pad didn't work "9" & "0". Went to utube and they said hinges go bad causing heat to leak affecting touch pad

Pull range out 6 inches. Open door to 45 degrees and pull up to remove door. Remove both side plates, two screws each side. Remove both hinges by loosening two small bolts on the front of range that connect to the hinges. Place new hinges in place. Bolt hinges using bolts you removed, replace side panels. Slide door on hinges and push back range. Read more...

Your Price

$56.73

Amana Range Door Hinge - Passive Without Spring

★★★★★

2 Reviews

PartSelect Number PS11752379

Manufacturer Part Number WPW10299227

Fixes these symptoms

Door won’t close
See more...

Videos!

Your Price

$97.84

Amana Range Door Hinge - Left or Right Side

★★★★★

6 Reviews

PartSelect Number PS11744424

Manufacturer Part Number WP74011141

This hinge can be used for either the left or the right side of the oven door. Sold individually.

Fixes these symptoms

Door won’t close
See more...

Installation Instructions

Lar from Cary, NC

Oven Door hinge broke

0. Throw oven circuit breaker 1. Open oven door and slide/lift door off of hinge posts 2. Remove oven drawer 3. Slide oven out from between cabinets and turn so that the back is accessible. 4. remove Phillips screws holding the cover-rear and side panel to the stove. Note which screws have pan heads and which are hex head. 5. remove stove elements and pans 6. Raise stove Top Assembly and release ceramic element sockets from their clips. 7. Push the supports for the Top Assembly fornt and back to release them from their sockets so that the Top Assembly can be lifted to near vertical. 8. Remove the hex head screw holding the Control Panel End Cap to the side panel. (Steps 5-7 might be avoided if you have a small socket wrench that can get to this screw without removing the elements.) 9. Remove the other screws holding the top of the side panel to the "Box Burner" pan that sits under the Top Assembly. 10. Pull side panel slightly away from the oven and lift it to disconnect it from the posts that hold the side panel to the front of the oven. 11. Remove the two screws on the front of the oven that hold the hing mechanism. 12. tilt and remove the hinge. 13. Open the replacement hinge so that it can fit through the hinge opening in the front of the oven. 14. Reassemble. Read more...

Videos!

Your Price

$103.21

Amana Range Door Hinge - Left or Right Side

★★★★★

3 Reviews

PartSelect Number PS11744423

Manufacturer Part Number WP74011140

Each hinge is sold seperately.

Fixes these symptoms

Door won’t close
See more...

Installation Instructions

James from Elmont, NY

broken door hinge

unplug unit remove rear panel screws lift up stove top remove top two screws remove panel remove two hinge screws remove replace hinge and follow in reverse order Read more...

Your Price

$46.14

Amana Range Door Hinge - Active

★★★★★

2 Reviews

PartSelect Number PS11752377

Manufacturer Part Number WPW10299225

Used for white and black models.

Fixes these symptoms

Door won’t close
See more...

Your Price

$14.91

Amana Range Hinge Receptacle

PartSelect Number PS11744396

Manufacturer Part Number WP74010551

Fixes these symptoms

Door won’t close
See more...

Your Price

$115.74

Amana Range Door Hinge - Kit of 2

PartSelect Number PS3504027

Manufacturer Part Number W10347466

Fixes these symptoms

Door won’t close
See more...

Installation Instructions

Ross A from Sugar City, ID

Oven door would not close completely

Open door 1/4 an slide the little latches on each hinge toward you. This will lock them in place. Close the door a little and lift it up. The door will slide out. Lay it face down on a table and undo all the screws. Do not remove the glass, frame etc. Slide old hinge out and new one in being careful not to slide the glass and frame out of alignment. It is a pain to get it all back together if you take every part out. Just do the hinges. Screw it back together. Reverse the door removal process by lowering the hinges into the oven receiver from a 75% closed position. Once in place, open the oven about halfway and slide the locks forward. This will allow the door to close completely. Note: Three hinges came with my set. Not sure what the third odd one is for. Read more...