Back
Back
Keep typing for more specific results...

Amana Microwave Parts

Popular Amana Microwave Parts

Your Price
$8.37
   In Stock
Amana Microwave Light Bulb (40w)
★★★★★
★★★★★
174 Reviews
PartSelect Number PS2376034
Manufacturer Part Number 8206232A
This 40w light bulb is a replacement bulb constructed of glass and metal. It is an easy-to-install electrical part which produces 40w of light. If the bulb won't light up then it may be broken and should be replaced. The bulb attaches directly to an appropriate light socket and has a small screw-in base. To access the exterior light bulb, you will need to remove the panel on the bottom of the microwave using a Phillips screwdriver. If your exterior light bulb has not been changed before, it is probably held in place with some silicone. You will need to cut away this silicone to remove the old bulb. If you cannot access the silicone with a utility knife, it can be removed using dental floss. Once the silicone is removed, simply unscrew the old bulb, and replace it with the new one. Be sure to disconnect the power to the microwave before you begin this repair. This light bulb measures about 1 1/8 inches. We do not recommend using a higher-wattage bulb for this appliance, and can only recommend this specific bulb. If fixing the bulb does not solve your microwave light issue, it's possibly a problem with the socket, which means the socket and/or board will need to be replaced. This can be a more dangerous repair, so consult your user manual or a technician before attempting.
Installation Instructions
Chris from Cedar Hill, TX
Burned out light under microwave and Filters needed changing
I just removed the multiple screws which held the hood cover on. I then attempted to remove the light bulbs from the socket. This proved impossible because the bulbs were so fragile from the heat and grease build up. To make this task much easier and probably safer, just replace the bulb housing and light bulb. The bulb housing unplugs very easily. Just replace it then screw your new bulb in. P.S. Be sure to unplug appliance before you start.

The filters are very easy to replace. No tools needed.

Hope this helps.
Read more...
Your Price
$15.68
   In Stock
Amana Microwave Charcoal Filter
★★★★★
★★★★★
34 Reviews
PartSelect Number PS1871363
Manufacturer Part Number 8206230A
This Charcoal Filter traps grease from your oven's exhaust to help prevent it from entering the vent, which could cause damage over time. If the exhaust fan on your microwave is not working, you may need to replace your charcoal filter. This charcoal filter is located within the intake grille of your microwave, which will need to be unscrewed and opened to gain access to the filter. The manufacturer recommends that you change your charcoal filter every six months. This filter measures 5 inches by 5.375 inches by 0.375 inches. Be sure to measure your current filter to assure correct replacement. This product is sold individually. We recommend the use of gloves during installation to protect your hands from messy grease during your repair. You should also unplug your appliance at the electrical outlet or switch it off at the breaker. Using a Phillips screwdriver, unthread the screws securing the grill. Open the door and slide the grill to the left and lift it up to remove it. This will allow access to the filter so it can be either replaced or cleaned. Remember to insert the tabs of the grill into the frame and slide it to the right when you are done. To finish, shut the oven door and secure the grill with the screws.
Fixes these symptoms
Installation Instructions
Richard from San Antonio, TX
Mounting brackets are fragile and plastic support is easily broken
Replaced the intake grille. The grille should be removed prior to cleaning. The entire part is plastic and easily broken so that the two tabs for the mounting screws are shattered and will not hold the part in place. If one attempts to clean the grille using only a moderate amount of pressure with a cloth the fragile plastic will break. The part is poorly designed. When the vent is removed to replace the charcoal filter, one may discover that the grille has already been broken in a previous cleaning operation. Read more...
Your Price
$27.25
   In Stock
Amana Microwave Grease Filter
★★★★★
★★★★★
68 Reviews
PartSelect Number PS3650910
Manufacturer Part Number W10208631A
This Grease Filter is constructed of Acrylonitrile Butadiene Styrene and is used to trap grease and help eliminate odors from the exhaust air while cooking. It attaches onto the exhaust and is rated as easy to install. The part is 12 15/16" x 5 3/4", and comes in silver. Refer to your make and model number to ensure this part is right for you. If the exhaust fan of your appliance is not working, this part is the most likely cause. This part is sold individually, and it should be noted that many microwaves require two filters, so you may need to replace both at the same time by purchasing two of this part. You should consider gloves during this simple repair (which requires no tools) to save yourself from getting greasy hands.
Fixes these symptoms
Installation Instructions
Robert from AURORA, CO
KMHS120ESS REQUIRES two charcoal filters
BEWARE: KMHS120ESS takes two charcoal filters. This site doesn't tell you that! I only figured it out after ordering one, receiving it, and removing the vent cover to replace it. So then I had to order another one and pay for shipping a second time (which cost almost as much as the filter itself). C'mon PartSelect, why are these not sold in a pair? Read more...
Your Price
$9.95
   In Stock
Amana Microwave Door Switch
★★★★★
★★★★★
22 Reviews
PartSelect Number PS10057151
Manufacturer Part Number W10727360
This three-terminal switch fits your microwave door. This part is mostly black in color and is about 1.5 inches with metal terminals. You might need to replace this part if your microwave is not heating properly or if it runs for a few seconds but turns off.
Fixes these symptoms
  • Doesn’t shut off
  • Door not closing properly
  • No heat
  • See more...
Installation Instructions
Mark from HOMER GLEN, IL
Door switch inconsistent operation for Open/Close sensing.
Ordered top & bottom micro-switches and mounting plate parts. Internet reviews could not find specifics if the issue was due to a top/bottom or combination of micro-switch or mounting plate failure. Pulled the plug. Removed the top vent assembly cover held in by 2 Phillips screws inside the vent. Removed the control panel held in by 1 Phillip screw at the top vent assembly area. Lifted control panel upward to release the catch and moved it off to the side - didn't disconnect any leads. Used a Torx bit to remove the door switch mounting plates at the front and pulled the plates through the opening from the control panel. Documented the wire color code connections, the top plate uses 2 micro's with one using both the closed & open contact. Installed the respective micros on the mounting plates and worked backwards with the wiring and removal steps. Once completed, the open/close sensing has worked every time. Read more...
Your Price
$30.95
   In Stock
Amana Microwave Door Interlock Switch
★★★★★
★★★★★
12 Reviews
PartSelect Number PS2361111
Manufacturer Part Number W10269458
This door interlock switch is a genuine replacement part designed for use in microwaves. It serves a critical safety function by preventing the microwave from operating when the door is open. Because proper operation of the microwave’s shielding and interlock system is essential for user safety, this part should be installed by a qualified service technician. After installation, the interlock switches and microwave shielding must be thoroughly tested to ensure the appliance meets safety standards.
Fixes these symptoms
  • Doesn’t shut off
  • Door not closing properly
  • No heat
  • See more...
Installation Instructions
Mark from HOMER GLEN, IL
Door switch inconsistent operation for Open/Close sensing.
Ordered top & bottom micro-switches and mounting plate parts. Internet reviews could not find specifics if the issue was due to a top/bottom or combination of micro-switch or mounting plate failure. Pulled the plug. Removed the top vent assembly cover held in by 2 Phillips screws inside the vent. Removed the control panel held in by 1 Phillip screw at the top vent assembly area. Lifted control panel upward to release the catch and moved it off to the side - didn't disconnect any leads. Used a Torx bit to remove the door switch mounting plates at the front and pulled the plates through the opening from the control panel. Documented the wire color code connections, the top plate uses 2 micro's with one using both the closed & open contact. Installed the respective micros on the mounting plates and worked backwards with the wiring and removal steps. Once completed, the open/close sensing has worked every time. Read more...
Your Price
$44.95
   In Stock
Amana Microwave Turntable Motor
★★★★★
★★★★★
35 Reviews
PartSelect Number PS11755189
Manufacturer Part Number WPW10466420
As per manufacturer this no longer comes with the Spacer.
Fixes these symptoms
Installation Instructions
Michael from YUMA, AZ
Rattling noise when turn table was in motion
Unplug any appliance before any work is done. The microwave is a hanging unit under kitchen cabinets. First I removed the turn table, rollers, and connector by lifting them out. Second I removed all the attaching Phillips head screws that hold the bottom cover on. Once removed the cover will hang and give access to the drive motor gear assembly. It's held in place by 2 torques head screws. Remove these, lower the motor, and disconnect the 2 wires that plug onto it. A small pick or similar tool is needed to release the connectors latches. reassemble in reverse. Read more...
Your Price
$11.95
   In Stock
Amana Microwave Locker
★★★★★
★★★★★
8 Reviews
PartSelect Number PS3522838
Manufacturer Part Number 4026W2A019A
The locker, or door latch assembly fits to the inside of the microwave door, and keeps the door closed. If the door on your microwave oven doesn’t appear to close properly, you may have a problem with the door latch assembly. This locker is made of plastic and measures 7 inches long x 2 inches wide. If either of the hooks is broken or does not have any spring tension, you may need to replace the assembly.
Fixes these symptoms
Installation Instructions
Dave from FOREST, VA
Door locker snapped off
Unplugged the microwave. I opened the door. I used a butter knife to pop the bezel off the inside of the door. I pushed the locker up and to the left and used the butter knife to pry it loose. Disconnected the locker from the spring, and reversed for the installation. Read more...
Your Price
$49.93
   In Stock
Amana Microwave Glass Turntable Tray
★★★★★
★★★★★
28 Reviews
PartSelect Number PS12745298
Manufacturer Part Number W11402532
The turntable tray rotates in the centre of the microwave to help ensure the food cooks evenly.
Fixes these symptoms
Installation Instructions
Eric from MYRTLE BEACH, SC
Broken glass tray-cook
Put New tray in convection microwave,closed door and it was done. Read more...
Your Price
$48.95
   In Stock
Amana Microwave Vent Grille
★★★★★
★★★★★
32 Reviews
PartSelect Number PS2361025
Manufacturer Part Number W10259625
This part mounts on the top of the microwave above the door.
Fixes these symptoms
Installation Instructions
Richard from San Antonio, TX
Mounting brackets are fragile and plastic support is easily broken
Replaced the intake grille. The grille should be removed prior to cleaning. The entire part is plastic and easily broken so that the two tabs for the mounting screws are shattered and will not hold the part in place. If one attempts to clean the grille using only a moderate amount of pressure with a cloth the fragile plastic will break. The part is poorly designed. When the vent is removed to replace the charcoal filter, one may discover that the grille has already been broken in a previous cleaning operation. Read more...
Your Price
$14.65
   In Stock
Amana Microwave Mounting Plate
★★★★★
★★★★★
7 Reviews
PartSelect Number PS12074431
Manufacturer Part Number W11025649
This mounting plate is sourced directly from the original manufacturer for use with microwaves. It is a metal plate designed to support a microwave by attaching the microwave to the wall studs. If the mounting plate wears down or becomes damaged, it will cause the microwave to tilt and become unstable, potentially damaging the appliance and the wall it is attached to. Therefore, it is important to replace the plate promptly. First disconnect the microwave from the power source and locate the fasteners that hold the mounting plate. Detach the old plate and align the new one with the existing mounting holes. Secure the plate and check that the microwave is stable and unmoving.
Installation Instructions
rebecca from LA CANADA FLT, CA
Demo stove exhaust fan and tile backsplash, install over range microwave, rotate exhaust fan and adjust exhaust plenum.
Whirlpool Microwave was purchased as used item, so installation in a new location required purchase of mounting template, wall bracket, mounting hardware. Granite backsplash cut out using wet/dry diamond blade and Ryobi 6.5 inch saw. Microwave exhaust fan removed and rotated for upward exhaust using modified exhaust plenum from existing stove exhaust hood. Installation of Microwave was the simplest part of the job. All mounting materials worked as required. A list of the materials provided in the hardware mount kit would be helpful, I would not have had to order the top mount screws separately if it was clear that they were included in the kit. Otherwise, no complaints. Read more...

Amana Microwave Appliance Types

Related Amana Microwave Parts

Popular Amana Microwave Models

Below are the most popular Amana Microwave models we have. Enter your model number in the search box to find your model.