3VET2 Whirlpool Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Broken filler tube at threaded connection
4 of 5 people
found this instruction helpful.
-
Matthew from Phoenix, AZ
- Really Easy
- 15 - 30 mins
-
Pliers, Screw drivers
After discovering that the water noise was coming from the rear of the refridgerator upon pulling it foward I discivered the connection line had broken. So i got a phillips screw driver and removed the the two mounting screws and saw it was one piece. I easliy found the part on PartSelect website and once I got I merely swaped them out
... Read more
and it works good as new!
Read less
Was this helpful?
Thank you for voting!
Filler tube broken and old tube frozen over
4 of 5 people
found this instruction helpful.
-
Alan from Chino, CA
- Really Easy
- Less than 15 mins
-
Nutdriver, Pliers, Screw drivers
this is a snap! 2 screws an a nut to tighten and it works like a charm. the filler tube in my Kenmore refer had broken off in the back. ( really bad location to put this in the beginning) if you push the refer to close to the wall you can break it off easily. remove the water line by loosing the nut and remove the hose from the fill tube
... Read more
( This assumes you have already turned of the water supply or you are standing in a large puddle)remove the 2 screws that hold the filler tube in place. pull out the old filler tube in and slightly upright motion. replace the new fill tube into the same hole and replace the screws. replace the hose and tighten the nut, turn the water back on and check for leaks your done !!
doesn't that feel great?
doesn't that feel great?
Read less
Was this helpful?
Thank you for voting!
Refrigerator light would not turn on.
5 of 8 people
found this instruction helpful.
-
Suzanne from STERLING HTS, MI
- Really Easy
- Less than 15 mins
-
Nutdriver
I first replaced the switch and had no results, I then ordered the Light Socket Kit, and because I had the experience of removing the panel to replace the switch, it took a few minutes to remove the two screws behind the panel, removing the temperature control knobs and then releasing the face plate which is secured by tabs at the bottom.
... Read more
The kit came with extra connectors in case they were needed, but they were not in my case and so I pulled off the wires, pushed the old socket out and the new one in. Attaching the wires to the correct pins, I screwed in the light bulb to be sure that the fix was correct and determining that, I replaced the screws that held the panel in place. Voila, I'm a happy camper who found some outdated jars in the back corners of the newly lighted shelves.
Read less
Was this helpful?
Thank you for voting!
Crisper Glass Shelf
5 of 9 people
found this instruction helpful.
-
Andrea J from Davenport, FL
- Really Easy
- Less than 15 mins
Took the glass shelf out of the fridge in our rental home to clean and it just shattered in our hands. Did a search online and found part select, phoned to make sure I was looking at the correct part, the lady on the phone was very helpful. I ordered the shelf using the next day service as we were returning home to the UK within 3 days so
... Read more
did not want to take the chance of not receiving it before we left. I got the notification the part had been dispatched, the part was delivered early next morning. Took the shelf out the package and placed in the tray, job done!. Great service will definately use again, have book marked the site.
Read less
Was this helpful?
Thank you for voting!
the meat drawer was broken.
3 of 3 people
found this instruction helpful.
-
Doris from SAN ANTONIO, TX
- Really Easy
- Less than 15 mins
I was prepared for the part not to fit because it's a 23-year-old fridge, but it fit perfectly, no issues whatsoever. I plan to buy a crisper drawer as well. Glad I found this vendor.
Was this helpful?
Thank you for voting!
Installed new glass crisper
3 of 3 people
found this instruction helpful.
-
Rebecca from WEST JORDAN, UT
- Very Easy
- Less than 15 mins
Open your door as far as it will go. Line it up with the plastic holder should just slide into place.
Was this helpful?
Thank you for voting!
Raplaced switch
5 of 9 people
found this instruction helpful.
-
Winston A from Brooklyn, NY
- Really Easy
- Less than 15 mins
-
Pliers
Repair went well,took about five to ten minutes to disconnect the power from the fridge removed the defective switch installed the new one ,reconnected the power,,,and Let there be light and there was light!
Was this helpful?
Thank you for voting!
broken self
4 of 6 people
found this instruction helpful.
-
JAMES from HILTON, NY
- Very Easy
- Less than 15 mins
This was a simple install. I just replaced the glass shelf on the sliding shelf bracket.
Was this helpful?
Thank you for voting!
Drawer broken
3 of 3 people
found this instruction helpful.
-
Terry from PLAINVILLE, CT
- Very Easy
- Less than 15 mins
Replaced the drawer
Was this helpful?
Thank you for voting!
Installing old ice maker in new freezer
3 of 3 people
found this instruction helpful.
-
Harry from Ten Mile, TN
- Really Easy
- 15 - 30 mins
-
Screw drivers
I was able to transfer my old ice maker from my old Roper Refrigerator/Freezer into my new Whirlpool Sidekick Freezer. Everything transferred directly except for the water fill tube. I ordered one on line and simply cut it to the right length, removed the cover plate inside the freezer compartment and the little sticker from the outside.
... Read more
Inserted tube and fastened in place with two screws (not provided but was able to use the screws that were in the holes inside the freezer before the ice maker went in. Works great. By not buying the ice maker with the freezer I saved a hundred bucks or so.
Read less
Was this helpful?
Thank you for voting!
lights wouldn't come on/work in refrigerator
4 of 6 people
found this instruction helpful.
-
Jane from Albuquerque, NM
- Easy
- 15 - 30 mins
-
Pliers, Screw drivers, Socket set
Referencing the info/schematics you have on your website, I unscrewed/unattached top-front panel (carefully), from behind the panel you have to detach the wires (2) from the switch, pushed "in" the switch to remove, put in new switch and attach wires to test BEFORE remounting panel. Tada!! Thank you PartSelect! You saved me at least $80..
... Read more
.would have been at least $100 to have a repair person come to the house!
Read less
Was this helpful?
Thank you for voting!
Refrigerator Trim was Bent
3 of 3 people
found this instruction helpful.
-
Jeffrey from Houston, TX
- Really Easy
- Less than 15 mins
Ordered the new part, it was the perfect size and slipped right on to the existing brackets.
Was this helpful?
Thank you for voting!
Replaced broken shelf supports
4 of 6 people
found this instruction helpful.
-
Cheryl from Los Angeles, CA
- Really Easy
- Less than 15 mins
Took out old pieces and popped new ones in, just like that!
Was this helpful?
Thank you for voting!
Broken crisper drawer rail
3 of 3 people
found this instruction helpful.
-
David from TEMPLE, TX
- Really Easy
- Less than 15 mins
Ordered it, received it in due time and it was very easy to replace. As of right now I'm very pleased. Thanks
Was this helpful?
Thank you for voting!
freezing everything
3 of 3 people
found this instruction helpful.
-
Darcie from VINELAND, NJ
- Difficult
- 30 - 60 mins
Removed old gasket. Wiped everything down. Popped in new gasket.
It was a little tedious, but it went in easy enough. Some reviews said the new gasket was kinked and bent. Mine I am happy to say was smooth. Some things are still getting quite cold like vegetables and ginger ale.(almost freezing). But it is way better than it was. Sa ... Read more ved us from having to purchase another refrigerator. The fellow who helped me made it easy to order and everything went smoothly. I appreciate the help and patience you provided.
I
It was a little tedious, but it went in easy enough. Some reviews said the new gasket was kinked and bent. Mine I am happy to say was smooth. Some things are still getting quite cold like vegetables and ginger ale.(almost freezing). But it is way better than it was. Sa ... Read more ved us from having to purchase another refrigerator. The fellow who helped me made it easy to order and everything went smoothly. I appreciate the help and patience you provided.
I
Read less
Was this helpful?
Thank you for voting!