Kenmore Microwave Motors
Find your part
Enter your model number or a part number and click "Search"Here is an example model number plate:


Popular Kenmore Microwave Motors
Your Price
$59.97
Drive Motor
PartSelect Number PS237772
Manufacturer Part Number WB26X10038
This is a microwave turntable drive motor. This is a genuine OEM replacement part. It accepts a D-shaped drive shaft. The drive motor is located under the glass microwave turntable, and allows the turntable plate to rotate while the appliance is in use. Your drive motor might be broken if it is noisy or does not turn at all. Be sure to disconnect power to the microwave before starting this repair. Simply unscrew the bottom plate and the drive motor of your microwave, disconnect the wires, and install the replacement part. This drive shaft is 21 volts, is about 2 inches in diameter, and is made of metal.
Fixes these symptoms
- Noisy
- Tray won’t turn
- Won’t turn on
- See more...
Installation Instructions
GERRY from BONITA SPRINGS, FL
Your Price
$15.53
Motor, AC Synchronous
PartSelect Number PS3529216
Manufacturer Part Number 6549W1S013H
If the turntable on your microwave does not rotate, or you can hear a grinding noise, the problem may be with the motor. The motor is typically located below the floor of the oven, and is accessed through the bottom. The motor is normally held in place with a retaining screw and will have two wires attached to it as well. If the motor is making a grinding noise it will need to be replaced. If the motor does not turn, you can check for voltage or continuity with a multi-meter. Make sure the power is disconnected from your microwave before beginning this repair.
Fixes these symptoms
- Tray won’t turn
- See more...
Installation Instructions
Susan from HENDERSON, NV
microwave dish would not move back and forth
unscrewed the bottom of the microwave and unplugged old part then took the screw out and put new one in. Super easy!
Read more...
Your Price
$18.44
Motor, AC Synchronous
than unplug 2 wires to the motor and unscrewed 2 screws, replaced the old motor with the new one and also the coupler. and so far no noise. easy fix. Thanks Read more...
PartSelect Number PS3529217
Manufacturer Part Number 6549W1S013K
Fixes these symptoms
- Tray won’t turn
- See more...
Installation Instructions
George from RICHMOND HTS, OH
Was making a noise when turning around
I removed the bottom plate which had 9 screws. than unplug 2 wires to the motor and unscrewed 2 screws, replaced the old motor with the new one and also the coupler. and so far no noise. easy fix. Thanks Read more...
Your Price
$52.69
MOTOR
PartSelect Number PS12071283
Manufacturer Part Number 5304509440
Fixes these symptoms
- Tray won’t turn
- See more...
Your Price
$48.51
Turntable Motor
PartSelect Number PS979515
Manufacturer Part Number 5304440021
This turntable motor is used in microwaves. This is what rotates the glass tray so that your food is heatied evenly. The specs for this synchronous motor are 120 Volts, 60Hz, 3rpm, and 2.1 Watts. It features two 3/16-inch male spade terminals, which is what attaches to the internal wiring of your appliance. The motor also includes mounting holes; there are two mount holes on either side of the part. This replacement motor is approximately two inches in diameter, and it is sold individually. Before you attempt this repair make sure you unplug your microwave.
Fixes these symptoms
- Tray won’t turn
- See more...
Installation Instructions
steve from New Bern, NC
Turntable stoped working
Removed the 3 screws to drop the lower panel and, removeed the turn table plate and ring. Then removed the 2 screws holding the motor, the 2 wires attached to the motor and removed the old motor.Replaced the new motor in the reverse order. DO NOT FORGET TO UNPLUG THE MICROWAVE FIRST.
Read more...
Your Price
$84.97
Turntable Motor
I got the oven out, rolled it on it's side and found the plate to access the motor. The plate is located on the bottom/underside of the unit. The plate is nothing more than a section of the underside of the metal housing that has been cut-out as an access point. This "cut-out" is not complete - that is, not completely cut out so as to all the plate to stay in place without the need for screws, etc, until you actually have to use it. I used a pair of dykes to cut the couple of points still connecting this plate, removed the two phillips screws to remove the motor, disconnected the two wires connected, then reversed to complete the repair. You then flip the cut-out plate over/rotate it, and some screw holes line up. Find a couple of small screws, and re-attach the plate to cover the motor.
The actual fix is really easy, again, once you figure out the simple way to remove the oven. I am an idiot, so you will probably find this much easier. I could probably do this repair now, after my experience, in less than 30 minutes (probably less than 15 minutes). I probably save a couple hundred $ by doing it myself so was well worth the time to do it. Good luck. Read more...
PartSelect Number PS391978
Manufacturer Part Number 8183954
This motor is used to rotate the cooking tray.
Fixes these symptoms
- Tray won’t turn
- See more...
Installation Instructions
Todd from San Bernardino, CA
Microwave turntable does not work
My unit is a wall mount/cabinet/built-in model. The repair is actually fairly simple once you determine that the actual microwave is just a component of the entire unit, and that it (the microwave) can be easily removed from the unit. I did not figure this out until after I removed the entire unit (disconnect the power supply, lift the entire bulky, heavy unit out of the cramped space in the cabinet, etc). Once I got it out I figured out how easy it is to remove the actual oven - a couple of screws, literally. The unit is a bit bulky, but not particularly heavy and is quite manageable. I did this entire process alone.I got the oven out, rolled it on it's side and found the plate to access the motor. The plate is located on the bottom/underside of the unit. The plate is nothing more than a section of the underside of the metal housing that has been cut-out as an access point. This "cut-out" is not complete - that is, not completely cut out so as to all the plate to stay in place without the need for screws, etc, until you actually have to use it. I used a pair of dykes to cut the couple of points still connecting this plate, removed the two phillips screws to remove the motor, disconnected the two wires connected, then reversed to complete the repair. You then flip the cut-out plate over/rotate it, and some screw holes line up. Find a couple of small screws, and re-attach the plate to cover the motor.
The actual fix is really easy, again, once you figure out the simple way to remove the oven. I am an idiot, so you will probably find this much easier. I could probably do this repair now, after my experience, in less than 30 minutes (probably less than 15 minutes). I probably save a couple hundred $ by doing it myself so was well worth the time to do it. Good luck. Read more...
Your Price
$62.43
Turntable Motor - 120v
PartSelect Number PS1961310
Manufacturer Part Number W10143959
This motor rotates the glass turntable in the microwave.
Fixes these symptoms
- Noisy
- Tray won’t turn
- See more...
Installation Instructions
duane from san diego, CA
Fire in microwave melted several parts
Remove the filters and use a Torx driver to remove two screws holding the motor. The wires on on the motor are held in place by a plastic clamp that must be pried open on one side. That's all it takes to replace the drive motor. Everything else that makes the turntable spin lifts off from inside the microwave.
Read more...
Your Price
$41.20
Motor, AC Synchronous
PartSelect Number PS3529223
Manufacturer Part Number 6549W1S018C
Fixes these symptoms
- Tray won’t turn
- See more...
Your Price
$40.83
Related Parts
- All Kenmore Microwave parts
- Kenmore Microwave Brackets and Flanges
- Kenmore Microwave Caps and Lids
- Kenmore Microwave Circuit Boards and Touch Pads
- Kenmore Microwave Doors
- Kenmore Microwave Ducts and Vents
- Kenmore Microwave Electronics
- Kenmore Microwave Elements and Burners
- Kenmore Microwave Fans and Blowers
- Kenmore Microwave Filters
- Kenmore Microwave Fuses
- Kenmore Microwave Glass Tray and Supports
- Kenmore Microwave Grates
- Kenmore Microwave Grilles and Kickplates
- Kenmore Microwave Handles
- Kenmore Microwave Hardware
- Kenmore Microwave Insulations
- Kenmore Microwave Knobs
- Kenmore Microwave Latches
- Kenmore Microwave Lights and Bulbs
- Kenmore Microwave Panels
- Kenmore Microwave Racks
- Kenmore Microwave Seals and Gaskets
- Kenmore Microwave Springs and Shock Absorbers
- Kenmore Microwave Switches
- Kenmore Microwave Thermostats
- Kenmore Microwave Trays and Shelves
- Kenmore Microwave Trims