Kenmore Microwave Doors
Find your part
Enter your model number or a part number and click "Search"Here is an example model number plate:
Popular Kenmore Microwave Doors
Your Price
$34.25
Microwave Door Interlock Switch
PartSelect Number PS2361111
Manufacturer Part Number W10269458
This door interlock switch is for microwaves.
Door interlock switch prevents the microwave from starting when the door is open.
Because the microwave shielding and interlock switches must be properly tested following the door interlock switch replacement, a service technician should install this part.
Fixes these symptoms
- Doesn’t shut off
- Door not closing properly
- Won’t turn on
- See more...
Installation Instructions
Mark from HOMER GLEN, IL
Door switch inconsistent operation for Open/Close sensing.
Ordered top & bottom micro-switches and mounting plate parts. Internet reviews could not find specifics if the issue was due to a top/bottom or combination of micro-switch or mounting plate failure. Pulled the plug. Removed the top vent assembly cover held in by 2 Phillips screws inside the vent. Removed the control panel held in by 1 Phillip screw at the top vent assembly area. Lifted control panel upward to release the catch and moved it off to the side - didn't disconnect any leads. Used a Torx bit to remove the door switch mounting plates at the front and pulled the plates through the opening from the control panel. Documented the wire color code connections, the top plate uses 2 micro's with one using both the closed & open contact. Installed the respective micros on the mounting plates and worked backwards with the wiring and removal steps. Once completed, the open/close sensing has worked every time.
Read more...
Your Price
$113.96
Outer Door Frame - White
Installed handle to new frame. Removed old window and shield. Installed old window and shield into new frame.
Installed assembly to front of microwave with two screws.
Trick is to make sure new frame hooks to door by the hinge side. Read more...
PartSelect Number PS389977
Manufacturer Part Number 8169572
Exterior frame only. Handle not included. This is NOT the complete door assembly.
Installation Instructions
Leonard from Brooklyn Park, MN
old plastic door frame was cracked
Removed two screws on side of door; removed old frame. Romved handle. Installed handle to new frame. Removed old window and shield. Installed old window and shield into new frame.
Installed assembly to front of microwave with two screws.
Trick is to make sure new frame hooks to door by the hinge side. Read more...
Your Price
$148.88
Your Price
$46.65
Your Price
$9.00
Cover,Choke
PartSelect Number PS3520498
Manufacturer Part Number 3552W1A032J
Installation Instructions
Kyle from LANCASTER, CA
The major plastic frame was broken at the screw hole support. I was sent the wrong part and found out the part I needed was no longer made and would have to buy a new door for $150.
The wrong part was under $20. When I found out I had to replace the whole door for $150. I decided DYI was the way to go. I used JB weld and the door looks and works like a charm. Give plenty of time to cure all water needs to be cured out if exposed to microwaves. No problems so far.
Read more...
Your Price
$9.78
Your Price
$106.07
Inner Door Glass (middle)
PartSelect Number PS2378854
Manufacturer Part Number 316117502
Installation Instructions
Mitch from Fernandina Beach, FL
Cracked oven door inner glass
Repair was quite easy, as long as you have the instructions for removing the door. The screws that hold the bottom of the door to the fixed hinge are placed into the side of the hinge assembly after removal; this holds the door at a 45 degree angle for easy removal. After that, just place the door on a flat surface and dismantle the door from the inside. The inner glass is contained in a metal frame with another piece of glass; this frame comes apart easily using the clips in each side. The door assembles easily after the glass is replaced; just take your time and give yourself enough room to lay out the parts as you go. Good luck!
Read more...
Door Hinge Receptacle
PartSelect Number PS2203371
Manufacturer Part Number 318328010
Sold individually.
Fixes these symptoms
- Door won’t close
- See more...
Window Pack Assembly
PartSelect Number PS4257789
Manufacturer Part Number 12470
This window pack is also known as an oven door window pack assembly and is a part for your range. The window pack forms a see-through heat barrier within the oven door glass. Before making any repairs to your oven, make sure to turn off the power source, and wait until the range surface is cool to the touch. We recommend wearing work gloves to protect your hands. Caution: The oven door is heavy. Two people may be required to safely lift the oven door off the range, and onto a stable surface for proper servicing.
Related Parts
- All Kenmore Microwave parts
- Kenmore Microwave Brackets and Flanges
- Kenmore Microwave Caps and Lids
- Kenmore Microwave Circuit Boards and Touch Pads
- Kenmore Microwave Ducts and Vents
- Kenmore Microwave Electronics
- Kenmore Microwave Elements and Burners
- Kenmore Microwave Fans and Blowers
- Kenmore Microwave Filters
- Kenmore Microwave Fuses
- Kenmore Microwave Glass Tray and Supports
- Kenmore Microwave Grates
- Kenmore Microwave Grilles and Kickplates
- Kenmore Microwave Handles
- Kenmore Microwave Hardware
- Kenmore Microwave Insulations
- Kenmore Microwave Knobs
- Kenmore Microwave Latches
- Kenmore Microwave Lights and Bulbs
- Kenmore Microwave Motors
- Kenmore Microwave Panels
- Kenmore Microwave Racks
- Kenmore Microwave Seals and Gaskets
- Kenmore Microwave Springs and Shock Absorbers
- Kenmore Microwave Switches
- Kenmore Microwave Thermostats
- Kenmore Microwave Trays and Shelves
- Kenmore Microwave Trims
