Kenmore Microwave Filters
Find your part
Enter your model number or a part number and click "Search"
Popular Kenmore Microwave Filters
Your Price
$40.48
Charcoal Filter
PartSelect Number PS3527523
Manufacturer Part Number 5230W1A003A
This is an authentic LG charcoal filter for your microwave, sourced directly from the manufacturer. It is designed to remove odors from the air that circulate through your microwave vent. It measures approximately 11 inches in length, and 2.5 inches in width.
Installation Instructions
George from FALL RIVER, MA
Loss of controls and no heat.
Assisted experienced and knowledgeable local repair shop technician. Had no issues during repairs. Microwave worked properly after repairs were completed.
Read more...
Your Price
$30.64
Grease Filter
PartSelect Number PS1957060
Manufacturer Part Number W10113040A
This grease filter, used in microwaves, can be located underneath the microwave. The filter traps grease from the exhaust air and removes it from the air stream. This helps prevent grease sticking to the inside of the exhaust hood. Please note that most microwaves require two grease filters and they are both sold separately. This is an easy replacement done by simply pulling out old filters and sliding in the new ones. For further instructions and guidance, refer to the manual provided by the manufacturer. Unplug the microwave from the power source before starting this installation.
Installation Instructions
M. Rose from Miami, FL
The grill-vent broke and the grease filters needed to be replaced.
I simply placed the grill-vent in hood area, pulled out the dirty grease filters and slid in the replacement ones.
Read more...
Your Price
$29.07
Grease Filter
PartSelect Number PS1847969
Manufacturer Part Number 6802A
If the microwave exhaust fan is not circulating air properly, there could be an issue with the grease filter. A dirty filter will cause your microwave to run less efficiently and can alter the taste or smell of your food. Filters should be changed every six months for maximum performance. These silver, aluminum filters are sold separately, and are approximately 13 3/8 inches long x 5 7/8 inches wide. Measure your current filter to assure correct replacement. Check your grease filters regularly for particles and grease buildup to see if cleaning is necessary. If there is any visible damage to the filter, it should be replaced straight away.
Fixes these symptoms
- Exhaust fan not working
- See more...
Installation Instructions
Joseph from Las Vegas, NV
Dirty Grease Filter
Slide grease filter about 1/2 inch to right (or left) using the d-ring attached to one side and then pull down and out. Push charcoal filter frame slightly to rear and pry down from front. Install new charcoal and grease filters by reversing process. No tools - 5-minutes max!!
Read more...
Your Price
$65.21
Microwave Grease Filter
PartSelect Number PS12071287
Manufacturer Part Number 5304509444
Sold individually. This grease filter is for microwaves.
Grease filter traps grease from the exhaust air.
Follow the instructions in the owner's manual when installing this part.
Your Price
$25.97
Charcoal Filter
PartSelect Number PS1957304
Manufacturer Part Number W10120840A
The charcoal filter, used in microwaves, removes food odors from the air. If your filter is damaged or you notice strong odors coming from your microwave, it is best to replace it. This part is metallic and measures about 12 inches wide and 6 inches deep. The tool required for this repair is a Phillips screwdriver. First, remove screws at the top of microwave to access the filter. Next, remove the old filter and insert new filter by pushing it all the way back, so the edges connect to the two tabs. The front edge of the filter should rest at the bottom of the cavity. Do not forget to replace the grill after installing new filter. Remember to unplug your microwave from the power source before installation process.
Fixes these symptoms
- Exhaust fan not working
- See more...
Installation Instructions
duane from san diego, CA
Fire in microwave melted several parts
Remove the filters and use a Torx driver to remove two screws holding the motor. The wires on on the motor are held in place by a plastic clamp that must be pried open on one side. That's all it takes to replace the drive motor. Everything else that makes the turntable spin lifts off from inside the microwave.
Read more...
Your Price
$25.02
Charcoal Air Filters
PartSelect Number PS382960
Manufacturer Part Number 6800
The charcoal filter is used in microwaves to remove food odors from the air. If your filter is damaged or strong odors are coming from your microwave, it is best to replace this part. The only tool needed for this repair is a Phillips screwdriver. First, remove screws at the top of microwave to access the filter. Next, remove filter and insert new filter by pushing it all the way back, so the edges hit the two tabs. The front edge of the filter should rest at the bottom of the cavity. Make sure to replace the grill after installing the new filter. Remember to unplug your microwave from the power source before the installation process. This part is metallic and measures about 12 inches wide and 6 inches deep.
Fixes these symptoms
- Exhaust fan not working
- See more...
Installation Instructions
Joseph from Las Vegas, NV
Dirty Grease Filter
Slide grease filter about 1/2 inch to right (or left) using the d-ring attached to one side and then pull down and out. Push charcoal filter frame slightly to rear and pry down from front. Install new charcoal and grease filters by reversing process. No tools - 5-minutes max!!
Read more...
Your Price
$22.87
Filter - Single
Grease and filters where manually replaced.
Door on microway has allignment issues, that can't be repair unless I change entire door assembly Read more...
PartSelect Number PS1957036
Manufacturer Part Number W10112514A
Sold individually.
Installation Instructions
Alberto from Chula Vista, CA
Broken Grill-Vent legs
Removed manually grill vent and replace it with new one.Grease and filters where manually replaced.
Door on microway has allignment issues, that can't be repair unless I change entire door assembly Read more...
Your Price
$13.48
Screen
1st I removed both water hoses
2nd I removed 1 hex head screw that released a backing plate & removed the plate holding the water inlet valve.
3rd I pulled the 4 electrical connections & loosened a clamp to remove a small water hose.
4th I removed 2 hex head screws that held the water valve to the backing plate.
-----------that was a whole 5 - 10 minutes!------------
Next I reversed the process
4th I attached the inlet valve with the 2 hex head screws
5th re-attached the 4 electrical connections(had slip on spades) pushed on the hose & tighterned the clamp.
6th replaced the backing plate with the inlet valve attached & tightened the single hex head screw.
7th re-attached the hot & cold lines................................DONE
15 minutes tops Read more...
PartSelect Number PS11746894
Manufacturer Part Number WP96160
Found on the water inlet valve.
Installation Instructions
Peter from Aurora, IL
The fill cycles would start then stop suddenly
This was an easy repair. 1st I removed both water hoses
2nd I removed 1 hex head screw that released a backing plate & removed the plate holding the water inlet valve.
3rd I pulled the 4 electrical connections & loosened a clamp to remove a small water hose.
4th I removed 2 hex head screws that held the water valve to the backing plate.
-----------that was a whole 5 - 10 minutes!------------
Next I reversed the process
4th I attached the inlet valve with the 2 hex head screws
5th re-attached the 4 electrical connections(had slip on spades) pushed on the hose & tighterned the clamp.
6th replaced the backing plate with the inlet valve attached & tightened the single hex head screw.
7th re-attached the hot & cold lines................................DONE
15 minutes tops Read more...
Your Price
$28.75
Air Filter
PartSelect Number PS1957303
Manufacturer Part Number W10120839A
Sold individually.
Installation Instructions
Papkin from Glendale, CA
Surface lights and filters needed replacement
By pulling the filter screens units down and out with a pair of pliers I had access to the surface lights. Pulled the lights out of their sockets and replaced the bulbs. Real easy. Since the filter units were out, replaced the filters and reinstalled the filter units. The whole operation took less than 15 minutes.
Read more...
Microwave Grease Filter
PartSelect Number PS3527528
Manufacturer Part Number 5230W1A012B
Sold individually.
Related Parts
- All Kenmore Microwave parts
- Kenmore Microwave Brackets and Flanges
- Kenmore Microwave Caps and Lids
- Kenmore Microwave Circuit Boards and Touch Pads
- Kenmore Microwave Doors
- Kenmore Microwave Ducts and Vents
- Kenmore Microwave Electronics
- Kenmore Microwave Elements and Burners
- Kenmore Microwave Fans and Blowers
- Kenmore Microwave Fuses
- Kenmore Microwave Glass Tray and Supports
- Kenmore Microwave Grates
- Kenmore Microwave Grilles and Kickplates
- Kenmore Microwave Handles
- Kenmore Microwave Hardware
- Kenmore Microwave Insulations
- Kenmore Microwave Knobs
- Kenmore Microwave Latches
- Kenmore Microwave Lights and Bulbs
- Kenmore Microwave Motors
- Kenmore Microwave Panels
- Kenmore Microwave Racks
- Kenmore Microwave Seals and Gaskets
- Kenmore Microwave Springs and Shock Absorbers
- Kenmore Microwave Switches
- Kenmore Microwave Thermostats
- Kenmore Microwave Trays and Shelves
- Kenmore Microwave Trims