Admiral Washer Hinges
Popular Admiral Washer Hinges
Your Price
$11.17
In Stock
Admiral Washer Lid Hinge
PartSelect Number PS11741780
Manufacturer Part Number WP35-2044
The lid hinge on your washer is connected to the lid and allows it to open and close. If you find you cannot open or close the lid to your washing machine properly, you may need to replace the lid hinge. This lid hinge is an inch and a half long, all white in color, and it is made entirely of plastic. To complete this repair, you will need a Phillips screwdriver and a putty knife to remove the top of the washer, in order to access the screws that hold the lid hinge in place. Be sure to disconnect the power to the washing machine before beginning this repair.
Fixes these symptoms
- Lid or door won’t close
- Will Not Start
- See more...
Installation Instructions
Allen from North Little Rock, AR
One of the plastic hinge pins brroke
I used a flat screw driver to push in on the releases so I could raise the top of the machine. I then used a torx tool to remove both parts of the hinge, and then used a #2 phillips screw driver, on the new screws I'd also ordered, to re-attach both of the hinge parts. Every thing went just as anticipated.
Read more...
Your Price
$22.22
In Stock
Admiral Washer Lid Hinge Pin
PartSelect Number PS11741781
Manufacturer Part Number WP35-2045
This lid hinge pin allows a washing machine lid to pivot open and closed properly. The hinge pin may need to be replaced if the lid will not open or will not close. The part is white and made of plastic. This lid hinge pin is just over an inch long, is sold individually, and does not include the mounting screw (consider ordering mounting screw if it rusted or stripped). It is recommended to check the opposite lid hinge pin before ordering because hinges may wear at the same rate. Be sure to not tighten the mounting screw to pin too tightly to avoid breaking the new part.
Fixes these symptoms
- Lid or door won’t close
- Will Not Start
- See more...
Installation Instructions
Allen from North Little Rock, AR
One of the plastic hinge pins brroke
I used a flat screw driver to push in on the releases so I could raise the top of the machine. I then used a torx tool to remove both parts of the hinge, and then used a #2 phillips screw driver, on the new screws I'd also ordered, to re-attach both of the hinge parts. Every thing went just as anticipated.
Read more...
Your Price
$7.95
In Stock
Admiral Washer Lid Bumper
PartSelect Number PS11747040
Manufacturer Part Number WP9724509
This gray and white washer lid bumper contains a rubber bottom and is sold individually.
Installation Instructions
Nicola from Centreville, MD
Washer would not run, lid switch broken
Repair was easy. Removed two side panels on the control plate. Removed two phillips screws that hold the control panel to the body of the washer. Disconnected the electic connection to the wires leading to the lid switch. Three sided of the lower cover lift over and removed from the washer frame. Access to the lid switch and wire retainers was easy. Removed two screws holding the remaining parts of the switch and replaced with new. Re-routed the wires through the retainers. Set the sides back on making sure the set all the way back in the frame and fit properly into the plastic strips on the back of the washer. Reconnected wires, screws and end caps.
Read more...
Your Price
$11.09
In Stock
Admiral Washer Lid Hinge Bearing
PartSelect Number PS11738874
Manufacturer Part Number WP21258
This is the bearing for the lid hinge. Sold individually.
Fixes these symptoms
- Lid or door won’t close
- See more...
Installation Instructions
Enrique from Miami Shores, FL
spin cycle did not activate
Replaced hinge switch. Still no spin cycle. Noticed hinge bearing cracked & if hinge forced into switch, spin activated. Ordered new hinge bearings.Spin cycle still didn't engage. On further examination, observed that hinge was bent. Straightened hinge & worked like a charm. Didn't really need new switch or bearings. NOTE : Avoid having washer door bang shut.Took longer than expected, but each procedure was simple.
Read more...
Your Price
$10.82
In Stock
Admiral Washer Lid Hinge Pad
PartSelect Number PS11738862
Manufacturer Part Number WP21097
Sold individually.
Installation Instructions
Ellen from NYACK, NY
machine wouldn't turn on when lid closed
replaced missing screw and pad and now machine works perfectly
Read more...
Your Price
$16.00
In Stock
Admiral Washer Lid Hinge
PartSelect Number PS11746862
Manufacturer Part Number WP91770
Right Side - This lid hinge is for washers.
Lid hinge connects the lid to the top panel and allows the lid to pivot open and closed.
Wear work gloves to protect your hands when installing this part.
Your Price
$35.22
Special Order
Your Price
$56.09
In Stock
Your Price
$25.93
Special Order
Admiral Washer Lid Hinge - Right Side
PartSelect Number PS11742837
Manufacturer Part Number WP54583
Hinge only.
Installation Instructions
Edward from GALLOWAY, NJ
Rusting Washer Lid
Removed existing lid, two hinges and two rubber spacers. Installed new lid and hinges. Spacers were not mentioned on replacement parts needed. Existing spacers in bad shape but reuseable. Would like to have replaced the right and left spacers.
Read more...
Your Price
$9.88
In Stock
Related Admiral Washer Parts
- Admiral Washer Agitators
- Admiral Washer Caps and Lids
- Admiral Washer Hardware
- Admiral Washer Hoses and Tubes
- Admiral Washer Knobs
- Admiral Washer Seals and Gaskets
- Admiral Washer Springs and Shock Absorbers
- Admiral Washer Switches
- Admiral Washer Transmissions and Clutches
- Admiral Washer Wire Plugs and Connectors
- All Admiral Washer parts