MWX2 Washer - Parts

The capacitor is used on the washer motor to help the motor get up to speed quickly before transferring power to the run capacitor.

This is the bolt (screw) that holds the agitator in place.

This water inlet hose is used in washers. The hose connects the washer water inlet valve to the water supply in your home. There are two solenoids on the valve, which are referred to as coils, and there are two wires attached to each solenoid that should be labelled to ensure they are properly reconnected after replacing the new hose. Ove...Read morer time, your hose can begin to leak which can lead to floods. Replacing your hose earlier on can prevent this problem. Refer to the diagram provided by the manufacturer for installation instructions. Remember to unplug your appliance from the power source before beginning this installation project.

This friction snubber pad is an inch and a half long.

Use in conjunction with the agitator screw.

This clip is less than an inch long.

This seal goes to bottom of the transmission to stop oil from leaking at the bottom of the appliance.

The tub ring seal or splash cover seal is used for washers. This part seals the tub cover to the outer one and prevents water leakage from around the tub ring. If your seal is damaged and you are experiencing water leakage, it is best to replace this part. Refer to the manual provided by the manufacturer for further installation instructi...Read moreons. Remember to unplug your washer from the power source before starting this installation process.

This part helps with the spinning and agitating cycles.