EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

GDF520PSJ0SS General Electric Dishwasher - Instructions

All Instructions for the GDF520PSJ0SS
91 - 105 of 151

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Old tray was rusting.
3 of 3 people found this instruction helpful.
  • Lynn from TOPEKA, KS
  • Very Easy
  • Less than 15 mins
Simply pulled the new one out of the box and put it into the dishwasher.
Was this helpful?
Thank you for voting!
Dish washer wasn't getting the water hot to wash or dry
3 of 3 people found this instruction helpful.
  • Daniel from WATERBURY, CT
  • Really Easy
  • Less than 15 mins
  • Nutdriver
In did the drain screen, undid two nuts on top, removed panel, undid plastic ring, undid two screws with but driver, pulled sensor up, dried up any water at bottom, installed new sensor and follow steps in reverse. It worked!!!
Was this helpful?
Thank you for voting!
The dishwasher was filling normally, but was not heating the wash water nor heating the dishes for the final dry. Dishes were not being properly cleaned and were not at all dry after the cycle.
4 of 6 people found this instruction helpful.
  • Benjamin from VIENNA, VA
  • Really Easy
  • 15 - 30 mins
  • Nutdriver, Pliers
I replaced the flood switch following instructions shown in readily available YouTube videos. In short, you remove the coarse and fine filters, then take out the bracket holding in the flood switch and finally the switch itself. After replacing the switch, the dishwasher works normally again.
Was this helpful?
Thank you for voting!
Dishwasher would not sense door was latched
3 of 3 people found this instruction helpful.
  • Robert from CASEVILLE, MI
  • Very Easy
  • Less than 15 mins
  • Screw drivers
Super easy repair, just removed the old latch and replaced it with the new one.
Was this helpful?
Thank you for voting!
Replaced damaged upper and lower rack assembly
3 of 3 people found this instruction helpful.
  • Jacob from Welsh, LA
  • Very Easy
  • Less than 15 mins
Upper rack I had to reuse the old power was assembly but it just snaps into place. Lower rack literally just place on roller track and it was done. No tools required. Extremely satisfied with my purchase. 10/10 recommend!!
Was this helpful?
Thank you for voting!
Loud banging sound when dishwasher was on.
3 of 4 people found this instruction helpful.
  • Joseph from KENNEDALE, TX
  • Very Easy
  • Less than 15 mins
The base of the spray arm literally just spins a little bit into place like a luer lock. Takes two seconds to replace.
Was this helpful?
Thank you for voting!
The soap dispenser was not opening during the washing cycle
4 of 7 people found this instruction helpful.
  • Stephanie from Huntsville, AL
  • A Bit Difficult
  • 1- 2 hours
  • Nutdriver, Pliers, Screw drivers
Took off the door and separated the two door pieces. Unscrewed the old dispenser and replaced it with the new one.
Was this helpful?
Thank you for voting!
Door gasket needed to be replaced
3 of 5 people found this instruction helpful.
  • Corinna from MOUNT AIRY, MD
  • Very Difficult
  • More than 2 hours
Simple answer- do not try to do this. GE makes you replace the entire door to replace this $3 part or call them and pay $100s to fix it. We decided to replace the entire dishwasher after we went through disassembly (there are no instructions on this) only to find out we could not fix without a brand new door.
Was this helpful?
Thank you for voting!
Dishwasher dead
2 of 2 people found this instruction helpful.
  • Richard from AMARILLO, TX
  • A Bit Difficult
  • More than 2 hours
  • Nutdriver, Screw drivers
Board did not work. The socket for the jumper pins wasn’t installed on the board. Not sure if it was the correct unit. Decided to forget about doing a repair and just replaced the unit
Was this helpful?
Thank you for voting!
No boost in water temperature; water temperature during wash cycle not hot enough; dishes not drying
2 of 2 people found this instruction helpful.
  • David from CARY, NC
  • Easy
  • 1- 2 hours
  • Nutdriver, Screw drivers
Had to trouble shoot to isolated the true fault condition. Checked heating element was good
Researched symptoms on YouTube
Removed and inspected float switch part
Ordered and replaced part.
Was this helpful?
Thank you for voting!
roller wheel was melted.
2 of 2 people found this instruction helpful.
  • Julian T from Dalton, GA
  • Really Easy
  • 30 - 60 mins
I removed the old roller wheels and the new roller wheels snapped together and the simple instructions made the repair quick and simple..
Was this helpful?
Thank you for voting!
Dishwasher was not drying
2 of 2 people found this instruction helpful.
  • Larry from STERLING, CO
  • Really Easy
  • 30 - 60 mins
  • Nutdriver
I followed the U tube instructions already put out part select.
Was this helpful?
Thank you for voting!
Dishwasher wouldn't start.
2 of 2 people found this instruction helpful.
  • Dennis from JACKSON, MS
  • Easy
  • 30 - 60 mins
  • Nutdriver, Pliers, Screw drivers, Wrench (Adjustable)
YouTube search indicated the common problem was the Dishwasher Electronic Control Board, part # WD21X10537. YouTube was wrong. $83.76 mistake. (not Parts Selects fault)
I continued my search and stumbled on JustAnswers.com for $38.00.
They diagnosed the issue by me describing the lights that were blinking and for how long, an d quickly told me the door latch is not registering. However, said it is rarely the door latch, but rather the Electronic Control Board, part # PS12726419 for $105.90. What the heck, I'll bite.
Bought both parts at Parts Select, quick shipping, solid packaging and good return policy (learned from previous experience). I did not return the 1st part, figured it probably wasn't long for this world anyway.
Dishwasher is running fine again. The combination of JustAnswers.com and PartSelect.com is far better than an extended warranty. Extended warranties last 3 yrs in most cases and cost as much as I spent. Someone with smaller hands could have done both repairs much quicker.
Was this helpful?
Thank you for voting!
would not drain water
2 of 2 people found this instruction helpful.
  • Ed from Cassopolis, MI
  • Easy
  • 30 - 60 mins
  • Pliers, Screw drivers
2 hose clamps, connect the wire with the wire adaptor suppled
Was this helpful?
Thank you for voting!
Upper rack rusted out
2 of 2 people found this instruction helpful.
  • James from OMAHA, NE
  • Really Easy
  • 30 - 60 mins
  • Screw drivers
Took out the old and swapped out the parts from the old one and put them on the new rack. Looks great and works great.
Was this helpful?
Thank you for voting!
All Instructions for the GDF520PSJ0SS
91 - 105 of 151