AFC1 - Instructions

Removed the access panel on back of unit located the Run Capacitor on the compressor and removed the bad one and put the new one on and pugged refrigerator back in and it started up and works fine now

Put it in the hole.

inst said,"50 pct of the time this calls for new capacitor," so we changed the capacitor. Same prob. It also said,"25 pct of the time it's the bi-metal thermostat" So we ordered it. We removed the plastic rear panel from inside the freezer comp. using small nut driver. Here we found much ICE surrounding the defrost unit, three inches thic ... Read more k. We thawed the whole mess. and the freezer has worked fine ever since. I think my habit of getting ice cubes from the inside container rather than from the ice cube dispenser, had kep t the freezer door open too much, interfering with the normal defrost cycle and allowing ice to build up over time so that it finally defeated the system. My new rule, "get ice cubes only from the front."

Used the suggested problem list here to narrow down that the repair was most likely the run capacitor. Poped the new one in and I now have better control of my compartment ranges. I have a temperature gauge in each compartment. Check them every opening of the doors.

No store carried this model of my garbage disposal splash gaurd. When I got it open the package and put it in the sink and pushed it down towards the disposal and that was it. So simple.

Pulled the old one out put new one in

This part DID fit easily using no tools. This is replacement splash guard for GE disposal GFC325F-00. I also received quick response from your chat rep when I asked for a part number for this disposal. Part arrived quickly! All in all, a great experience!!!

Like you video

Was told capacitor was problem 90% of the time.Capacior was not the problem.Bad start relay.

Not so good that was not the problem. Fan is not seized and all the lights work and display is not on but lights up as well. No start once plugged back in after 15 minutes of being unplugged. Nothing same no change.

just put it in the drain

I simply inserted the new splash guard in the opening

Opened package, pulled out old splash guard, inserted new rubber splash guard. Perfect fit. No tools needed. Completed in under1 minute.

Found the proper GE Splash Guard and slipped it
into place. The repair was a snap but finding the part was difficult until I found it on PartSelect.

Removed new guard from package and slipped it right into place, no problems.