3146 - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
door shelf end cap broke off
-
Leonard from Niagara Falls, NY
- Really Easy
- Less than 15 mins
easily popped the new one in.
Was this helpful?
Thank you for voting!
Both the fridge aqnd freezer would not get cold.
-
Mary from Farmingdale, NY
- Easy
- Less than 15 mins
-
Screw drivers
Easy. Followed the video instrucations. the part was right there next to the compressor.
Was this helpful?
Thank you for voting!
Refrigerator and freezer too warm
-
Paul from Andrews, NC
- Easy
- Less than 15 mins
-
Screw drivers
1) This is a built-in refrigerator with the compressor, coils, etc. at the top. Turn off the breaker to the fridge. 2) Remove the front panel off the top (just push up and pull out). 3) Removed 2 screws to the old timer and carefully remove the plug. Plug the new timer in and screw in. 4) Since our fridge was heavily frosted up, we moved
... Read more
everything to another refrigerator and coolers and kept the refrigerator off until all panels were room temperature. 5) If you haven't cleaned the coil in a while, vacuum it with a soft brush attachment. 6) Turned back on and the refrigerator is cooler than ever!
Read less
Was this helpful?
Thank you for voting!
Smelled electrical/plastic burning. Pulled out refrigerator and noticed small flame near compressor.
-
MARTIN from RIVER FALLS, WI
- Easy
- Less than 15 mins
Unplugged refrigerator. Removed relay by unclipping wire and pulling relay off compressor. Looked-up part number and ordered part. Replaced part and plugged in refrigerator.
Was this helpful?
Thank you for voting!
light would not stay on
-
Kenneth from Leavenworth, KS
- Easy
- Less than 15 mins
First I flipped breaker to off position for refigerator, Pulled down on socket and broke it free. Then took needle nose piars to pull wire and plug out from hole, so I could conect to new light socket then snaped it in place . Hardest part was getting wire and plug out of hole.
Was this helpful?
Thank you for voting!
Refrig would not cool, freezer worked fine
-
Edward from McKinney, TX
- Easy
- 30 - 60 mins
-
Pliers, Screw drivers
Barry G was right on with instructions and expectations of the process to trouble shoot parts and how to replace. Barry also provide the right part numbers for replacement items. Thanks again Barry.
Was this helpful?
Thank you for voting!
Freezer work refierator compartment is warm
-
KIRK from Malibu, CA
- Easy
- 1- 2 hours
-
Screw drivers
Defrost timer is hidden in the control panel in the refrigerator top middle. Turn to off and remove two screws which are hidden behind white tabs. I had to pry the old timer from the plug with a screw driver because it was tight. Try not to short across the terminals. Plug in the new timer. Replace it in the clip where you got old one and
... Read more
reinstall the controls. The freezer was still all frosted up so I had to remove the cover and defrost it with a hair dryer to get it to work. Then I turned it on and it works great.
Read less
Was this helpful?
Thank you for voting!
the new motor was slightly larger than the old one and the bracket does not fit
-
Patricia from Oxford, MI
- Easy
- 1- 2 hours
-
Screw drivers
Had to get behind the refrigerator and clean the drain out first and that took at least and hour. Just unplug the old motor. Took the old parts of the old motor, put them on the new one and plugged it back in.
Was this helpful?
Thank you for voting!