Magic Chef Range Elements and Burners | Replacement Parts & Accessories | PartSelect

Popular Magic Chef Range Elements and Burners

Your Price
$36.73
Bake Element
PartSelect Number PS11744404
Manufacturer Part Number WP74010750
This bake element is for the bottom of your oven. The bake element supplies heat for baking. If you find there is little to no heat when baking, a burned out bake element, or food is taking too long to cook, these symptoms could be solved by replacing the bake element. Before starting this replacement, make sure the range is unplugged from the power source or shut off from the house circuit breaker. The tools needed is a Phillips screwdriver. For safety reasons, make sure to wear gloves.
Fixes these symptoms
Element will not heat
Little to no heat when baking
Oven is too hot

See more...
Installation Instructions
Heather from Huntsville, AL says,

The element broke in two pieces after food dried on it.
First, I unplugged the oven. Then, I removed the two screws that hold the element in place. After that, I gently pulled the element toward the front of the oven until the wires were exposed. I disc...read more

Your Price
$8.14
Surface Burner Receptacle Kit
PartSelect Number PS1570190
Manufacturer Part Number 12001676
The tools you will need to replace the surface burner receptacle kit on your range include a Phillips screw driver, and a pair of wire strippers. Before doing this repair, make sure to disconnect your appliance from the power supply and wear work gloves to protect your hands. The surface burner receptacle kit comes with a ceramic block, high temperature wire nuts, a metal bracket, and wires. Plastic parts can over heat and melt in your range, that is why this part includes ceramic and high temperature wiring. This part functions as the connection between the wire harness and the surface element in your range.
Fixes these symptoms
Element will not heat
Will Not Start


Installation Instructions
Richard from Carthage, NC says,

Stove top element not working due to bad receptacle.
Turned off the power at the breaker box, cut the wires approximately 5 inches from the bad receptacle and removed it after removing one screw. Stripped back the wires about 1/2 inch and attached the n...read more

Your Price
$48.87
Oven Bake Element
PartSelect Number PS11752501
Manufacturer Part Number WPW10308477
This bake element is located at the bottom of the oven to supply heat and it has push-on terminals. If your baking element is burnt out, the heat is not consistent, or is defective, then replacing the element could be a solution to your appliance problem. The tools needed for this replacement are: a screwdriver and needle-nose pliers. The first step in is to unplug the range or shut off the house circuit breaker before starting. Unscrew the black of the oven cavity to pull out wires from the defective element. Reconnect wires to the new element and screw it back on. Make sure the element is sitting flat.
Fixes these symptoms
Element will not heat
Little to no heat when baking
Oven not heating evenly

See more...
Installation Instructions
Esther from San Antonio, TX says,

heating element burnt up
first I pulled the stove from the wall. Then unplugged the stove from the wall (electric stove) for safety. then I removed the middle back panel screws(2) and then the panel. I then pulled the wire...read more

Your Price
$61.23
Bake Element
PartSelect Number PS11752540
Manufacturer Part Number WPW10310274
This bake element is found on the bottom of the oven. his bake element (part number WPW10310274) is for ranges. Bake element WPW10310274 is at the bottom of the oven and supplies the heat for baking. Unplug the range or shut off the house circuit breaker for the range before installing this part. Wear work gloves to protect your hands.
Fixes these symptoms
Element will not heat
Little to no heat when baking
Oven not heating evenly

See more...
Installation Instructions
Elaine from Orfordville, WI says,

needed new element. Old one burnt in two
unscrewed and unplugged the old one and plugged in and screwed in the new one. EASY!...read more

Your Price
$21.07
Standard Y-Frame Range Surface Burner
PartSelect Number PS11743366
Manufacturer Part Number WP660532
The standard y-frame surface burner provides heat to your range. If you notice that your element will not heat, you may need to replace your surface burner. This product is 6 inches in diameter, and 1500W. The manufacturer suggests replacing the receptacle at the same time that you replace the surface burner. Many of our customers have rated this repair as very easy, and you will not need any tools. To complete the repair, simply lift out the old burner and replace it with the new one. Check that the burners are turned off before you begin this repair.
Fixes these symptoms
Element will not heat


Installation Instructions
Laurie from Tequesta, FL says,

Burner element broke and drip bowls needed to be replaced.
I went to the local discount mart and bought drip bowls. The ones available at that store did not fit, so I decided to buy directly from the stove's manufacturer distributor.

The drip pans ...read more

Your Price
$110.63
Dual Surface Element - 2500w/1200w
PartSelect Number PS11764902
Manufacturer Part Number W10823692
This is the replacement large surface element for your cooktop or range. It is approximately 10-inches in diameter and is 1200/2500 watts. The large surface element is installed under the cooktop and heats up the area directly above it. You will need to replace the element if it does not heat up properly. As you will be working around electricity, be sure that your range is disconnected from power before you begin this repair. This is an OEM part sourced directly from the manufacturer.
Fixes these symptoms
Element will not heat
Will Not Start


Installation Instructions
GEORGE from NEWNAN, GA says,

Radiant element, 2400 watt, under Ceran glass cok top needed replacement.
turned off power
removed ceran top from cabinet
removed element
installed new element
replaced top
powered up and was done...read more

Your Price
$50.46
Oven Bake Element
PartSelect Number PS11744014
Manufacturer Part Number WP74003019
This is a 2800 watt, 240 volt Whirlpool oven bake element that is sourced directly from the original manufacturer for stoves, ovens, cooktops, or range ovens. This part should be replaced if the element is not heating, heating unevenly, or is too hot. It has a terminal distance of 16 inches with a terminal depth of 3 inches. Disconnect power to the oven before replacing the bake element. Unscrew the Phillips screws directly above the element brackets to remove the existing element, and remove the wire harness without losing the wires. It is recommended to inspect the wire terminals to ensure they are not arced or burnt while the element is removed.
Fixes these symptoms
Element will not heat
Little to no heat when baking
Oven is too hot

See more...
Installation Instructions
mike from gold bar, WA says,

burned in half
put the new element in the oven pushed wire onto connector on element held it up to match holes and put the screws back in, very easy to change. I really like the fast way I receive a part from you....read more

Your Price
$57.97
Range Bake Element
PartSelect Number PS11757472
Manufacturer Part Number WPY04000066
The bake element is the heating element that is found at the bottom of the oven and is responsible for 90 percent of the bake heating. This spade style bake element is 16 inches wide, and connects with push-on wire terminals. It has a terminal depth of three inches and a total element length of nineteen inches. You may need to replace the heating element if your oven produces little to no heat, the oven will not heat evenly, or the element will not heat at all. This element comes with an instructions sheet and is intended for use with electric ovens. To see if this part will fit your oven, please check the list of compatible brands below.
Fixes these symptoms
Element will not heat
Little to no heat when baking
Oven not heating evenly

See more...
Installation Instructions
DENISE from GERMANTOWN, TN says,

bottom heating element in oven disintegrated
First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. I threw away the old pieces.

Then I connected th...read more

Your Price
$111.87
Element with Limiter 6 Inch - 1200W
PartSelect Number PS11764915
Manufacturer Part Number W10823711
This is a radiant surface element with limiter, and it works in conjunction with your range. The function of this part is to give heat to the surface directly above it, on cooking area stove top.This model is sold individually and is 1200 watts. The main reason for needing to replace this part is if your element will not heat. Before ordering, make sure to test your stove top radiant element for continuity to make sure it is the problem. To make this installation you will need a Phillips screwdriver, and a 14-inch nut driver.
Fixes these symptoms
Element will not heat
Will Not Start


Installation Instructions
Mark from Loxahatchee, FL says,

Right rear burner went bad
Turned the breaker off, I removed 2 screws securing the range top to the range, opened the top and secured it in the up position, Removed the 2 screws securing the element ,one at a time I swapped the...read more

Your Price
$27.74
Surface Burner - 8" - 2600W
PartSelect Number PS11743367
Manufacturer Part Number WP660533
The surface burner or element on your range provides the heat that you cook with. If your element will not heat, you may need to replace the surface burner. This surface burner is 8 inches in diameter and 2600 watts. The burner element is made of metal and has two prongs that connect it to the range. The manufacturer recommends you replace the burner receptacle at the same time that you replace the surface burner. Many of our customers have rated this repair as very easy. To complete the repair simply lift the old burner up and out, and replace it with the new one. Be sure to disconnect power to the range before beginning this repair.
Fixes these symptoms
Element will not heat


Installation Instructions
Jonathan from Lilburn, GA says,

8 inch burner wouldn't come on. Wires shorted out
One screw holds the block onto the stove top. Had to clean out fitting for phillips screwdriver or screw would have stripped because it was old with lots of buildup. Even cleaned out, this screw requi...read more