TC522Q (P1135701W) Amana Refrigerator - Instructions

Popped the old one out with a kitchen knife and popped the new one back in. It tool less than 15 seconds!!

I pried the old one out with a screw driver and pushed the new one in. I expected instructions in the box it came in but there were none.

Took the old handle off and put the new one on.

One good thing was that I had read reviews of replacing door handles on this model, so I knew to pry off the little plastic piece to find the bottom screw. The repair consisted of unscrewing the old screws, removing the old handle, and screwing the new handle in place. Very easy!

My owners manual said to unplug fridge from elec outlet, use a kitchen knife to gently pry off the switch plate
(manual had a pictoral example), unclip the two wire, replace with on new switch and replace the switch. Close
door and plug back in. Open door to check that the lite
works. Walla! It did. Thanks!

Sin ... Read more cerely, Ron Marshall, Billings, MT

I unscrewed the initial door handle and replaced it with the new one. It took 5 minutes. I wish all repairs were so easy. Thanks

This was a cinch! I removed the old handle (which had previously been super-glued and duct-taped), used a little Windex to clear away the accumulated crud, and reused the screws to attach the new handle. This improvement took 10 minutes tops, and while it didn't exactly change my life, it was a real ego boost for the refrigerator.

Went to PartsSelect. Put in Dishwasher model number. Chose the screws for that model number. Ordered the screws. Can't get any easier than that!

Please bear in mind I am 65 years old & it was harder to get up & down off the floor then to change the switch. Was very easy - watched video, unplugged unit. I used the putty knife at the right front corner to work loose, when it came loose had to loose the left side a little. The unit pulled out easily. detached the wired that had a ... Read more single plug with 2 prongs on it. Attached the plug, pushed new switch into place. There was no way you could place wires on wrong prong. When done, plugged refrigerator back in & checked if working. I CAN SEE THE LIGHT and the food in the freezer now. Thank you for making an easy repair.

The gentlemen on the phone was very helpful and great to talk to. He looked up the part for me and it was delivered really quickly and was easy to install...which was a first for me. A++

1)pry out the old/defective light rocker switch with a screw driver (flat head) and pull out the cables 2)unplug two connectors at the end of light rocker switch 3) connect new light rocker into two connectors 4)push the wires inside and put back new light rocker switch

I did exactly as the video showed. I popped out the old switch, disconnected the two terminals, connected the new switch and put it back. The light now works! The refrigerator is over 25 years old and the switch works! What a great website this is. Couldn't of done the job without Partselect's help.

Unscrewed the old door handle, two screws by the handle. The other screw was down at the other end. Simply unscrewed the screws in the left handed direction and off they came. I just simply screwed on the new handle. Same way, moving the screws towards the right side this time. I took all of 2 minutes, and the refrigerator looks bra ... Read more nd new as opposed to old and worn out.

We tried repairing with a new switch which was very easy to install but it didn't fix the problem.

removed damaged parts and installed new.