TC522Q (P1135701W) Amana Refrigerator - Instructions

Had to "pop" off little plastic cover w/ flat blade screwdriver. Then just unscrewed 3 screws and replaced handle. Did both handles in about 15 minutes. Looks like new.

Took the old one off and put the new one on. Took
much longer to order and pay for the part than it did to repair the door. Everything went just like it was supposed to go and I thank you for your assistance in this matter, but I really don't have time to write stories about my refridgerator door. Sincerely, Roy Casteel

Great service. Unpluged old switch and pluged in new one. Works great

I removed the old door handle by unscrewing 3 screws. I ordered a new handle on the internet and when it came three days later, I attached the new handle with the screws that I had used on the old handle. Really easy!!

Very simple job. Be careful taking off the small plastic cover for the screw at the bottom of the handle.

I ordered the part and it literally came the next day! Very easy to install but make sure when you take off old handle you save the bottom cover piece before you remove the lower screw. Also save original screws to use again.

I am very happy with Part Select and would highly recommend them. Thank you!!!

Removed old part and replaced. Very easy.

Received new part in 2 days. Outstanding Service!!!!!!

Three screws removed and replaced handle. Replaced screws and it was just like new.

unscrewed old handle and screwed the new one on. New handle works much better than the old one that was patched up with duct tape.

Thanks!

Went together like a breeze. Only problem now is need to clean rest of frig really well to match handle.

After disconnecting the electricity. I followed the instructions as indicated in the "HOW TO" article on the website. I used a steel putty knife and pried the light switch out of its retaining hole. I worked the right side the most since this is the side with the retaining clip. After I removed the switch I transferred the two electrical ... Read more outlets to the new switch and easily snapped it into place. Engaged the electric power and tested the switch.

disconnected el. power to fridge. pried out broken switch with small screwdriner and pulled out w/water pump pliers. installed new switch and pressed into opening.

First removed the screws holding the broken handle in place, then placed the new handle in position and attached with the new screws. The part arrived the day following online ordering - very quickly!

A staff member at the group homes installed the handles with no problems at all, other than the original screws were quite well seated, and took some time to remove them. The replacement was easy and faultless.

The only problem was that we received Freezer Door handles instead of Refrigerator Door handles. But it's all good - ... Read more the freezer handles were looking a bit shabby anyway.

A very cold and brittle switch in a 17 year old fridge. Used screwdrivers to pry out with some resistance Had to cut the molded plug in half and split wires, because replacement contacts were farther apart than the original. End result, works great.