- Home
- RTG216NLD1
- Instructions
RTG216NLD1 Frigidaire Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Refer iced up and would not keep the bottom cool. It was 70 Farenheit inside.
2 of 5 people
found this instruction helpful.
-
Larry from Newton, KS
- Really Easy
- 15 - 30 mins
-
Screw drivers, Socket set
I simply removed 4 screws holding the casing and then 2 more holding the timer. It was very easy. I then replaced the timer by unplugging and plugged the new one in. I replaced all the screws and the job was done. Less than 30 minutes. I was very impressed with the shipping time. When I ordered the part, I had it the next day.
Was this helpful?
Thank you for voting!
light bilb went out
2 of 6 people
found this instruction helpful.
-
Denise from Landover, MD
- Really Easy
- Less than 15 mins
replaced it
Was this helpful?
Thank you for voting!
Freezer built ice, fridge not cold enough and running constantly.
1 of 4 people
found this instruction helpful.
-
LUIS from CENTENNIAL, CO
- Really Easy
- Less than 15 mins
-
Screw drivers
Removed front low grill, removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the wires. Reversed process to install new timer.
Was this helpful?
Thank you for voting!
frezzer iceing over and not cooling the refrigerator
1 of 4 people
found this instruction helpful.
-
Marcus from Pine Hill, AL
- Really Easy
- Less than 15 mins
Just removed the two screws and unpluged it.
Then I pluged the new one in and replaced the screws. It runs like a brand new reffrigerator.
Thanks for the fast delevery. Will do busness with you in the future.
Then I pluged the new one in and replaced the screws. It runs like a brand new reffrigerator.
Thanks for the fast delevery. Will do busness with you in the future.
Was this helpful?
Thank you for voting!
Support was broken.
0 of 1 people
found this instruction helpful.
-
Charles from Fairborn, OH
- Really Easy
- Less than 15 mins
Removed broken and installed nw part.
Was this helpful?
Thank you for voting!
loud noise fan blade broke,off balance
0 of 1 people
found this instruction helpful.
-
EDWIN from ELWOOD, IN
- Really Easy
- 15 - 30 mins
-
Nutdriver
take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .
Was this helpful?
Thank you for voting!
freezer worked frig was warm. Ice maker is still not working
0 of 1 people
found this instruction helpful.
-
steve from Kirkland, WA
- Really Easy
- 15 - 30 mins
-
Screw drivers
Removed two screws to get to defrost time pull panel down remove two screws holding time and reinstall
Was this helpful?
Thank you for voting!
leaking water down into fridge
0 of 2 people
found this instruction helpful.
-
Ronald from Defiance, OH
- Really Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers
just like the video showed...it was excellent!!!
Was this helpful?
Thank you for voting!
coil Iceing up
0 of 2 people
found this instruction helpful.
-
Thomas from Stuart, FL
- Really Easy
- 15 - 30 mins
-
Nutdriver, Screw drivers
took 4 screws out of the discharge vent on top of the refrigerator section and unpluged the wiring harness and put the section on the counter and unscrewed the timer and put the new one in and reinstalled the assembly and plugged the Jack and put the 4 screws back in, and rotated the timer and put it on defrost removed the back and check
... Read more
the heaters and drain .
Read less
Was this helpful?
Thank you for voting!
fridge not blowing cold
-
wayne from marietta, GA
- Easy
- 15 - 30 mins
-
Nutdriver
bottom left cornerof fridge defrost timer replaced two bolts and a wire
Was this helpful?
Thank you for voting!
ice buil up on freezer,not defrosting
-
Ed from Glendale, CA
- Really Easy
- 15 - 30 mins
-
Nutdriver, Pliers, Screw drivers
first I replaced the timer control hoping thats the problem,unfortunately situation the same ice build up on the freezer.so I replaced the defrost thermostat.right now I'll still observing the condition if still the same.may be in couple days.so far its good.and to replace the parts is not difficult and easy.
Was this helpful?
Thank you for voting!
Fan Motor was making noise and freezing up.Fan was missing one blade.
-
Eric from San Angelo, TX
- Really Easy
- 15 - 30 mins
-
Socket set
Removed screws that fastened bracket to fridge. Next, I replaced the motor and carefully lined the brackets up so the motor would rotate smoothly. Put the fan blade on the motor and screwed the brackets back on the fridge. Motor kept popping out of alignment while I was screwing the brackets back in but I kept snapping it back in till it
... Read more
stayed.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
Failure of temperature control
-
Barbara from Marcellus, NY
- Easy
- 15 - 30 mins
-
Screw drivers
Unplugged refrigerator. Removed control knob and cover. Unwired control and removed same. Removed plastic tube from old capillary tube and placed on new unit. Installed and wired in new unit, making sure new unit was in the "off" position. Plugged in refrigerator, turned control knob to the first numerical setting, and was rewarded with t
... Read more
he startup of the refrigerator compressor. Voila!
Read less
Was this helpful?
Thank you for voting!
Fan Motor Noisy
-
Dana from Bloomington, IN
- Really Easy
- 15 - 30 mins
-
Screw drivers
Emptied freezer, removed fan motor cover (2 screws), removed fan and motor (2 screws), removed old motor from bracket and reassembled with new motor, transferred fan blade from old motor to new), re-installed new fan/motor (2 screws) and reinstalled cover...
Was this helpful?
Thank you for voting!
bottom of fridge quit cooling
-
doug from Franklin, TX
- Really Easy
- 15 - 30 mins
-
Nutdriver, Pliers
dismantled the top rear panel of the freezer and found I had the wrong part. Hand started the fan motor and it has been working fine since.
Was this helpful?
Thank you for voting!