EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

MRS1 Refrigerator - Instructions

All Instructions for the MRS1
106 - 120 of 213

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
compressor not running
  • wilson from indialantic, FL
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Wrench (Adjustable)
thanks to all of the people who had the same problems I was able to make a quick fix on my fridge. I pulled the back cover off and found the compressor not kicking on so I replaced the start cap. and im back in bussiness.
Was this helpful?
Thank you for voting!
freezer frosted up and air could not circulate to the food section, causing the temperature to get warm, 55 degrees
  • PAUL from WEIRTON, WV
  • Really Easy
  • Less than 15 mins
  • Nutdriver
I followed the procedure online and found the thermostat was ok, it had continuity when cold, and the heater coil was also ok, it too had continuity, therefore the problem was a bad defrost timer. the refrigerator works great, thanks parts select!
Was this helpful?
Thank you for voting!
broken side on the the crisper drawer.
  • Mary from Brook Park, OH
  • Really Easy
  • Less than 15 mins
It was do easy I removed the front of the drawer pleced on the new one and I was done .no tools needed.
Was this helpful?
Thank you for voting!
awasome
  • chris from springfield, GA
  • Really Easy
  • Less than 15 mins
After reading reviews I was not sure but I ordered part on Wensday in the AM and I had the correct part Thursday evening this company rocks thank you by the way i paid for regular shipping I will order again in a heartbeat
Was this helpful?
Thank you for voting!
Freezer and main compartment had wide temperature variations
  • Joseph from Tullahoma, TN
  • Really Easy
  • Less than 15 mins
  • Screw drivers
I first thought the defroster heater broke - took the back wall of the freezer off and cooling fins were fine. Then took the defroster timer out and opened it up. The contacts were badly burnt so the compressor and fan ran during only part of the cooling cycle. Replacing the timer took less than 5 minutes - turn off the power, remove o ne screw to take out the control box, cut the ground wire (new timer housing is plastic and does not have a ground connection), remove two screws to unmount the timer, unplug the old timer, plug in the new timer, fasten with two screws, put the control unit in and fasten with one screw, turn power back on.
Was this helpful?
Thank you for voting!
Broken shelfe supporrt
  • B from PEPPERELL, MA
  • Really Easy
  • Less than 15 mins
  • Screw drivers
real easy with the help of the video , made the difference
Was this helpful?
Thank you for voting!
Refrigerator Ran Constantly, Was not Cooling as well.
  • Mark from Hertford, NC
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Looked up troubleshooting info on your web site. Decided to replace the defrost timer. Ordered it using Paypal. Received the Shipment in about 1.5 days in Rural NC. Watched Your Video, cut off power to the fridge, removed the top self and unbolted the panel, removed the defective defrost timer, installed the new one and re-installed the panel and top shelf. Set the timer to defrost to check the operation (looked inside the freezer to see that the defroster was glowing red - it was) waited about twenty minutes to ensure that the fridge started cooling again. Fixed!
Was this helpful?
Thank you for voting!
frig side not cool/freezer coils not defrosting
  • daryl from n.las vegas, NV
  • Really Easy
  • Less than 15 mins
unplugged frig,removed bottom front cover and loosend 2 screws at bottom front left and slid defrost timer out from behind metal panel,unplugged the old and plugged in the new.frig works great.
Was this helpful?
Thank you for voting!
freezer was freezing and no refrigerator
  • Michael E from Uniontown, PA
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Followed instruction vedeo from partselect. THANKS!!!!!
Was this helpful?
Thank you for voting!
Broken Draw Sliders
  • Maurice from Bonita Springs, FL
  • Really Easy
  • Less than 15 mins
Exchanged the front panel of the existing drawer to the new drawer.
Was this helpful?
Thank you for voting!
the compressor capacitor overheated
  • Bart from goldsboro, NC
  • Really Easy
  • Less than 15 mins
  • Screw drivers
it was great. I ordered the capacitor for my frigidaire frig and it arrived
in 3 days. plugged in the part to the compressor and my frig has been
working ever since. I spent 3 minutes ordering the part and 30 seconds
attaching it to the frig. Easy, very easy. saved myself a 75 dollar repair
visit. thanks
Was this helpful?
Thank you for voting!
Freezer Worked Fine, Refrigerator Was 47 Degrees
  • Allan E from Manhattan, IL
  • Really Easy
  • Less than 15 mins
  • Screw drivers
I went on partselect put in make and model number, a list showed the probable cause. I watched the how to video. When I received the part in short order I loosened 2 screws disconnected the wiring plug (sprayed it with contact cleaner) pluged it in, removed screws from old part put them in new one. Put timer back in its location and ti ghtened the screws. Very eazy, works fine.
Was this helpful?
Thank you for voting!
Overheat coils at the bottom inside of the freezer
  • Costas from new hyde park, NY
  • Really Easy
  • Less than 15 mins
  • Screw drivers
I pick up very fast at these kind of small jobs but because of my very busy schedule I decided to call (2 times) technicians about my problem but none of them had any idea. About my repair, I removed the grill at the bottom of the refrigerator, unscrew a small plate (located on the bottom left side) that's holding the defrost timer. I plu g on the new part, screw back the plate with the defrost timer and that was it. Don't forget to turn clockwise with your finger the timer until you hear a "click" and then turn it slightly more to the right. There is also a video on U-tube.
Was this helpful?
Thank you for voting!
fridge side was getting warm.
  • Darryl from Russellville, KY
  • Really Easy
  • Less than 15 mins
  • Screw drivers
open freezer door two screws just below unscrew slide piece to side unplug reinstall very simple.
Was this helpful?
Thank you for voting!
Refridgerator not geting cold.
  • VINCENT from DEPTFORD, NJ
  • Really Easy
  • Less than 15 mins
  • Nutdriver, Screw drivers
Just followed the online instruction video .It was very easy.
Was this helpful?
Thank you for voting!
All Instructions for the MRS1
106 - 120 of 213