F401K2AC2 Honda Tiller - Parts

It is an identical replacement for a missing or a faulty item that is supplied directly from the original equipment manufacturer for use with Honda engines commonly installed on lawn and garden equipment. This is a replacement cap-fuel with a metal mesh filter on top, it will help to catch any large contaminants from the fuel. Please make...Read more sure to refer to the appropriate diagrams of your model for the correct location and application of this component. Keep in mind this high-quality item is made of durable metal and is sold individually.

This part is a genuine OEM item that has been sourced to be used with Honda small engines. This spacer is used as a link between the carburetor and the air cleaner elbow. The carburetor spacer is priced as an individual part, please note associative parts are available separately.

This is an original part from Honda that is used in a small engine. The key sits in the keyway and keeps the flywheel from free spinning when turned. This part is half mooned shaped and is made of metal. This part is sold as an individual replacement part.

The fuel hose attaches to the tube clip and the fuel filter. This part is available individually. It is a genuine OEM sourced part which is specifically designed for use with Honda and Toro engines. You may need a set of pliers when replacing this part. This item is made out of rubber and will need to be replaced if it breaks.

This is an authentic manufacturer-sourced component which is designed for use with Honda engines that are commonly installed on a variety of lawn and garden equipment. It is an identical replacement for a damaged or a missing clutch cam that was installed on a new unit. Over time the material will wear out and it may begin to crack eventu...Read moreally requiring a replacement. It is made of high-quality rubber and is sold individually.

The noise suppressor cap assembly, also known as the spark plug cap/boot is responsible for connecting the spark plug to the ignition coil, and helping to reduce the amount of noise created when running outdoor power equipment. This OEM replacement part includes a rubber cap with a metal contact inside. It is found at the end of the spark...Read more plug wire and has a threaded center shaft which allows you to easily screw it into position. Over time the metal contact may corrode, or the cap may dry out and crack or break. If your equipment is misfiring, running poorly, or has interference with other electronic equipment, the cap assembly likely needs to be replaced. To remove the old cap assembly, use your fingers or a set of pliers to carefully pull it off the end of the wire. Place the new cap assembly onto the end of the wire and fasten it securely. Please note this part is sold individually.

The flange bolt is used to secure parts together in a variety of lawn and garden outdoor equipment. It is sourced directly from the manufacturer and has a diameter of 6mm and a length of 12mm. The bolt is made of metal and has a ring-shaped rim on one end known as a flange. This flange helps to secure the bolt in place and prevents it fro...Read morem falling off during use. Inspect all the bolts on your equipment as you may need more than one. If you note that any of them are deformed, corroded or the threads are worn down, you will need to replace them as each bolt is sold individually. Remove the damaged bolt and thread the new one on with your hands before tightening with a wrench.