F401K2AC2 Honda Tiller - Parts

This flange bolt is a genuine OEM replacement part for use in lawn and outdoor equipment. It has a diameter of 6mm and a length of 12mm. The bolt has a wider circular area that protrudes out from the bolt head, known as a flange. The flange prevents the bolt from moving or loosening during use. Over time the bolt may corrode, crack, or it...Read mores threads may wear down. In this case the bolt will need to be replaced. Visually inspect the other bolts in your equipment to ensure your order the correct number, as each bolt is sold individually. Use a wrench to remove any faulty bolts and install the new bolts in place. Be careful not to overtighten your bolts as you may risk damaging the equipment and the bolt.

This is a genuine Honda replacement part that is intended to be used with small engines. The metal lock pin is used to secure a part assembly like a ball bearing to a shaft like the governor arm. The lock pin is sold as an individual replacement part.

This is a genuine OEM supplied replacement part that is specially designed for Honda engines that are commonly installed on a variety of lawn and garden equipment. The ignition coil which is also known as an armature-magneto provides current for the ignition system by producing pulses of high voltage electricity for the spark plugs. While...Read more there are various reasons for ignition module failure, the primary symptoms usually manifest in the form of extreme difficulty starting your equipment, and eventually, a no-start condition. It is made of high-quality metal with rubber insulated cord and is sold as an individual component. A wrench set will be needed to replace this coil assembly.

This authentic component is supplied directly from the original equipment manufacturer for use with Honda engines commonly installed on lawn and garden equipment. It is an identical replacement for a missing or a faulty ratchet-starter that was installed on a new unit, please make sure to check the appropriate diagrams of your model for t...Read morehe correct location and application of this item. Keep in mind this high-quality part is made of durable plastic and is sold individually.

This is an original Honda replacement part. The carburetor insulator is commonly found in small engines. This part is made of high-quality plastic, and is used to protect the carburetor from the heat of the engine. You may require a screwdriver when replacing this part. This item is sold individually.

This is an OEM part sourced directly from the manufacturer. The drain plug bolt is commonly found in Honda small engines. This part is made of metal, and is used to keep the oil inside the crankcase. You will require a screwdriver when replacing this part. This item is sold individually.

This is an 8mm hex nut, which is a six-sided piece of hardware that connects two parts together in your lawn equipment by keeping screws, bolts, or studs in place. Hex nuts are commonly used in areas of your machine that undergo high stress like in the blade assembly, engine or wheels. If a hex nut is broken, it may be cracked or corroded...Read more, and you may find that you cannot tighten it enough to hold parts in your machine together. If it is not replaced, the parts of your machine may come apart. To remove a hex nut, use a wrench to turn it counterclockwise. Before purchasing this OEM replacement part, keep in mind that this part is sold individually and consult your instruction guide to find out how many nuts your machine needs and where they are located. It is best to replace all the hex nuts at once because they wear out at the same time.