BCS42ELE General Electric Refrigerator - Parts

This valve comes with 1/4" compression inlet. NOTE: This part comes with new quick connections. To install - cut retaining nuts off of existing plastic water lines and gently push them into new valve. To remove - depress ring that the tube slides into.

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. This part has been updated by the manufacturer and may appear different than the original, but should function the same.

This evaporator fan motor operates in a counter clockwise fashion. This motor's shaft is 3/8 of an inch and the motor has two right side terminals. NOTE: Harness wires NO longer come with the part.

This part comes with 3 round pin connection terminals. This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan.

This refrigerator defrost timer will cycle for thirty minutes after every ten hours of run time.

This heavy-duty cord has a three-pronged plug (2 electrical, 1 grounding). The power cord supplies power to your refrigerator, allowing it to keep the contents inside cool. There could be an issue with your cord if you notice that the refrigerator will not turn on, or intermittently turns on and off. Check the cord for fraying, or other v...Read moreisible damage. If the power cord shows any signs of damage, replace the cord immediately as it could become an electrical or fire hazard. Before you begin this repair, ensure that the power is disconnected from the unit, and that all food that could ruin is stored away while the power is off.

The mounting grommet is black in color, made of plastic, measures 1 inch in diameter, and is sold individually. It is collared around the edge to keep it in place. This part is used to help hold the compressor in place and prevent vibration. This part is generally found in refrigerators, washers, freezers, and dehumidifiers. This is a genuine OEM part that comes right from the manufacturer.

The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed.

This defrost thermostat kit comes with the installation with wires, mounting brackets, and wire connectors. L45-20.

This part should be installed by an appliance repair person as it could be dangerous. This part may be used to help prevent your evaporator fan from becoming blocked with ice. This part also insulates the evaporator coil area so you don't get a buildup of ice in the damper area.