ATG15 Frigidaire Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Freezer Worked Fine, Refrigerator Was 47 Degrees
-
Allan E from Manhattan, IL
- Really Easy
- Less than 15 mins
-
Screw drivers
I went on partselect put in make and model number, a list showed the probable cause. I watched the how to video. When I received the part in short order I loosened 2 screws disconnected the wiring plug (sprayed it with contact cleaner) pluged it in, removed screws from old part put them in new one. Put timer back in its location and ti
... Read more
ghtened the screws. Very eazy, works fine.
Read less
Was this helpful?
Thank you for voting!
Overheat coils at the bottom inside of the freezer
-
Costas from new hyde park, NY
- Really Easy
- Less than 15 mins
-
Screw drivers
I pick up very fast at these kind of small jobs but because of my very busy schedule I decided to call (2 times) technicians about my problem but none of them had any idea. About my repair, I removed the grill at the bottom of the refrigerator, unscrew a small plate (located on the bottom left side) that's holding the defrost timer. I plu
... Read more
g on the new part, screw back the plate with the defrost timer and that was it. Don't forget to turn clockwise with your finger the timer until you hear a "click" and then turn it slightly more to the right. There is also a video on U-tube.
Read less
Was this helpful?
Thank you for voting!
fridge side was getting warm.
-
Darryl from Russellville, KY
- Really Easy
- Less than 15 mins
-
Screw drivers
open freezer door two screws just below unscrew slide piece to side unplug reinstall very simple.
Was this helpful?
Thank you for voting!
door shelf end cap hooks broken
-
Rochelle from Big Lake, MN
- Really Easy
- Less than 15 mins
Previously I glued them on with epoxy and Taped them. Often redoing. So I needed to clean the surface with goo gone. And to clean out the slots I used a utility knife. I had a small bump on the new end cap so I removed it with the utility knife. Simply put the end caps on the rail on each end. Then put the hooks in the slots and slide dow
... Read more
nward until it is secure. I should have thought of parts before! When the rail broke off I had cherries in a jar on that shelf. It crashed to the floor. I had a sticky mess every where.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!
Freezer was cold bit the refrigerator was warm.
-
Christopher from Wilmington, DE
- Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
Based on the diagnosis on this site I thought the 66% odds of the problem being the Defrost Timer looked pretty good, $30 including shipping versus a Sears tech phone estimate of $250-300. BINGO! Just follow the online installation instructions and don't forget to use the reset switch as described. Works like new! THANK YOU
Was this helpful?
Thank you for voting!
Freezer & fridge warm / condenser coils iced over
-
Daniel from North Plains, OR
- Easy
- Less than 15 mins
-
Screw drivers
Problem not consistent. OK for 2-3 weeks, then freeze coils. Mark and observe the defrost timers manual rotating adjuster. Timer would stop mid cycle. One revolution equals 8 hours of compressor run time followed by 30 minutes of defrost. Replacing timer took 5 minutes.
Was this helpful?
Thank you for voting!
Refrigerator too Warm
-
Raymond from Yorktown Heights, NY
- Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
tested the thermostat, cleaned the coils, checked seals all clean. defrost timer did not cycle so replaced it but issue not resolved. even though freezer was working while refrigerator was problematic, proceeded to open freezer panel. discovered that fan was not pushing cold air into refrigerator compartment due to ice build up in conne
... Read more
cting tubes. cleaned ice and replaced panels to positive result
Read less
Was this helpful?
Thank you for voting!
Faulty defrost timer. Freezer would not maintain temperature
-
Steve from Nineveh, IN
- Easy
- Less than 15 mins
-
Nutdriver
Watched the video once. Removed four 1/4 inch screws with a nut driver unplugged the unit, took out two screws securing the timer. Replaced did all of this in about 10 minutes. It was "exactly" as the video showed and it's worked perfectly since the replacement of the faulty timer. I saved a $75.00 service call minimum and the part was mo
... Read more
re than likely cheaper from Part Select than from the repair facility. Although I'm a pretty good handy man, you would not need any experience to make this repair. The instructions are precise and the part fit perfectly.
Read less
Was this helpful?
Thank you for voting!
Freezer and main compartment had wide temperature variations
-
Joseph from Tullahoma, TN
- Really Easy
- Less than 15 mins
-
Screw drivers
I first thought the defroster heater broke - took the back wall of the freezer off and cooling fins were fine. Then took the defroster timer out and opened it up. The contacts were badly burnt so the compressor and fan ran during only part of the cooling cycle. Replacing the timer took less than 5 minutes - turn off the power, remove o
... Read more
ne screw to take out the control box, cut the ground wire (new timer housing is plastic and does not have a ground connection), remove two screws to unmount the timer, unplug the old timer, plug in the new timer, fasten with two screws, put the control unit in and fasten with one screw, turn power back on.
Read less
Was this helpful?
Thank you for voting!
Refrigerator Ran Constantly, Was not Cooling as well.
-
Mark from Hertford, NC
- Really Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
Looked up troubleshooting info on your web site. Decided to replace the defrost timer. Ordered it using Paypal. Received the Shipment in about 1.5 days in Rural NC. Watched Your Video, cut off power to the fridge, removed the top self and unbolted the panel, removed the defective defrost timer, installed the new one and re-installed the
... Read more
panel and top shelf. Set the timer to defrost to check the operation (looked inside the freezer to see that the defroster was glowing red - it was) waited about twenty minutes to ensure that the fridge started cooling again. Fixed!
Read less
Was this helpful?
Thank you for voting!
shelf end caps both broke and the rack came off
-
Ingrid from Fitzgerald, GA
- Really Easy
- Less than 15 mins
inserted shelf caps into rack strip then into openings and hit them with my fist (gently) till they 'seated' and locked
Other Parts Used:
Was this helpful?
Thank you for voting!
Refrig would not defrost
-
Robert from Jacksonville, FL
- Really Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
Diagnosis: used wiring diagram attached to frig and determined cause could be wiring, heater element, thermostat or timer. After completely defrosting the frig (turned it off) I removed the rear cover in the freezer and looked for an obvious problem. None seen. Removed temperature select pod from the frig box and looked for obvious pro
... Read more
blems. None seen but defrost timer appeared poorly made. Repair: Since I had no practical way of checking the defrost cycle in operation, I checked probable failures on the Part Select website and saw defrost timer as most probable. I ordered the timer. Installed it. Waited a few days to make sure the frig went through a few defrost cycles then removed the freezer rear cover. There was no excessive frost buildup so I'm reasonably sure the repair was successful.
Read less
Was this helpful?
Thank you for voting!
Not defrosting and then warm up do to ice
-
Bryan from Red Oak, IA
- Really Easy
- Less than 15 mins
-
Screw drivers
replaced the defrosting timer and saved a lot of $ by doing it my self.
Was this helpful?
Thank you for voting!
Refridgerator not geting cold.
-
VINCENT from DEPTFORD, NJ
- Really Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
Just followed the online instruction video .It was very easy.
Was this helpful?
Thank you for voting!
freezer cold--frig was warm
-
Robert from Chicago, IL
- Really Easy
- Less than 15 mins
-
Screw drivers
You guys at Partselect are the best!!! Went to your site, typed in my appliance symptoms, and received possible fixes. Ordered the suggested parts (under $50) on a Sunday night and got em Tuesday am. Installed the easiest one first and Voila!!!! Frig is working great. Thanks Bob S
Was this helpful?
Thank you for voting!