AD02 - Parts

This part is for your dehumidifier. The bucket water level switch is used to prevent water overflow when the bucket is full. You will not be able to tell if the switch has failed just by looking at it. You will need to perform a continuity test. This will determine if a continual electrical path is present. If you notice that dehumidifier...Read more will not run even when the bucket is empty, it might be due to the switch needing to be replaced. To access the part, you will need to remove all the outer housing. The switch is located in a plastic holder found on the inside wall.

Sold individually.

Sold individually.

The float clip works in a humidifier to ensure the float functions properly. The float is located near the humidifier bucket and monitors the water level as it rises and the clip keeps it in place. The float makes sure the water level is balanced and does not over flow. This float triggers the flow switch to shut off. If there is a defect...Read more with the clip, it can be a safety hazard as it might not be able to detect and stop an overflow. Make sure to unplug the dehumidifier from the power source before starting this replacement project as a safety precaution.

Sold individually.

This part is found in your dehumidifier or air conditioner appliance. The dehumidifier reduces the humidity level in your home by pulling in the air through the unit. The condensation then builds up and lands into this bucket. The bucket catches the water that drips from the evaporator. This bucket is dark brown in color and weighs approx...Read moreimately 5 lbs, is 13 inches in length, 5 inches in width, and 9 inches in height. No tools are necessary for its replacement, it simply slides into place. This product is a genuine OEM product that comes directly from the manufacturer.

A zip tie, also known as a cable tie or a wire tie, is a fastening device that holds wires or tubing together. If a machine has wires or tubing that are easily shifted, you need to hold them tightly together using a zip tie. It is a flexible, plastic strip that has serrated teeth and a locking mechanism. If the zip tie is damaged, it shou...Read moreld be replaced. Freely moving wires may rub against surfaces, causing them to break over time. Zip ties are single-use and may not be reused after they are removed from a machine. To release the locking mechanism, you will need to insert a small flat tool into the head of the zip tie, between the tongue and the serration, and depress the bar. You can then pull the teeth out of the mechanism to loosen the cable tie. This part is produced by the original equipment manufacturer and is sold individually.

Full bucket switch.

Also known as wheel or roller. This part is sold individually.