8288 - Parts

(s) bearing & fitting

This is a genuine replacement part manufactured for use with riding lawnmowers. This metal nut is used in a variety of applications to fasten different assemblies. Please see model diagram and part list for part location and usage. This nut is sold individually.

The washer goes next to the switch mounting nut and is made of metal. It is an OEM from Murray and Snapper for use in grass trimmers and lawn tractors. This item is available as an individual replacement part. If this part becomes broken it will need to be replaced and may require a wrench during the installation.

This is an OEM replacement part for use in rear engine riders made by Snapper and Simplicity. The lube fitting attaches to the front-axle assembly. During the installation process, a wrench might be needed to replace this item. It is made of metal and will require replacing if it breaks. This is available as an individual replacement part.

The skid shoe attaches to the blower. This is an OEM from Murray and Snapper for use in snowblowers. Keep in mind this part is made of metal and is sold individually. If this part becomes broken it will need to be replaced and may require a wrench during the installation.

This 0.25-inch-diameter washer with internal lock teeth is an authentic manufacturer replacement fastener used in outdoor power equipment. It has a flanged base, which provides even load distribution and protects the mounting surface from damage during installation and removal. The washer also has inward-facing teeth, providing additional...Read more grip to prevent the secured components from falling off the equipment. Over time, the washer will corrode, crack, or wear down its teeth, leading to equipment instability, noise, and vibrations. Inspect all the washers in your equipment and replace those that are no longer functional. Use a wrench or socket to loosen and remove the old washer, and then position the new one on the mounting surface. Tighten the washer until the flange rests flush against the surface. Each washer is sold individually.

This is an original Snapper replacement part. The screw is designed by the manufacturer for use in riding mowers, snow throwers, and tillers. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different screws used in the machine. Refer to the parts diag...Read moreram to be sure of ordering the correct part. You will require a wrench when replacing this item. This part is sold individually.