8077 - Parts

This ball joint is an authentic OEM component designed for use in lawnmowers and lawn tractors. It is found near the transmission assembly and is responsible for securing the drive system transfer link to the transmission assembly. Over time, the ball joint may experience wear and tear due to continuous use, exposure to dirt and debris, o...Read morer lack of lubrication. The drive system transfer link may disconnect from the transmission assembly, resulting in a loss of power transmission. As a result, the lawnmower may not move forward or backward when the engine is running. Remove the nut on the transfer link and the fasteners on the inside of the hex shaft shield. Carefully detach the ball joint. Secure the new ball joint to the transfer link and hex shaft shield to complete the repair.

Retainer, ring, 3/4

This part is available as an individual replacement part and is made of plastic. The bushing goes between the worm shaft support bracket and the worm shaft. It will need to be replaced if it breaks. A set of pliers might be necessary during the installation of this item. This is a Snapper replacement part directly sourced from the manufacturer for use in snow throwers.

This is an authentic item that is supplied by the original manufacturer for use with Snapper lawn and garden equipment. The spring is utilized to apply tension on the latch. Over time the part can wear out and stretch eventually requiring a replacement. Please note this high-quality metal extension spring is sold individually. You may nee...Read mored pliers to perform this repair. Refer to the appropriate diagrams for your model when replacing this component.

It is an authentic part which is supplied directly from the original equipment manufacturer for use with Snapper lawn mowers. This is the handle that the clutch cable attaches to. It is made of durable metal and is sold individually. Note, the grip for the handle is sold separately. Make sure to check the appropriate diagrams of your mode...Read morel for the correct installation procedure. To perform this repair a screwdriver will be needed.

This part is an authentic manufacturer-sourced replacement part which is specially designed for trimmers, brushcutters and blowers. This part is sold individually and made of metal. The return spring helps return the starter pawl back to the regular position after you are done starting the engine with the recoil starter.

This is a genuine manufacturer-approved part which is made for use with Murray and Snapper riding lawn mowers and garden tractors. It is one of the special bushings that are utilized on the equipment. This part acts as a lining for components helping to provide a tight fit. Make sure to check the appropriate diagrams of your model for the...Read more correct application of this hardware. It is made of durable material and is sold individually. You may need a screwdriver and pliers to replace it.

Sold individually. This knob accepts a D-shaped shaft.

An authentic item that is supplied directly from the original equipment manufacturer. This replacement side chute is a high-quality item designed for use with Snapper and Simplicity lawn mowers. It is mounted to the side of the mower deck for the cut grass to be expelled out of. This part is made of durable plastic and it is sold individually, please note the hardware to secure it is sold separately.