8077 - Parts

This assembly is the tub, felt seal and 3 baffles in the tub.

This moisture sensor wire harness connects the sensor bars to the dryer’s control board, enabling accurate detection of fabric dampness to prevent over-drying and improve energy efficiency. Designed for a precise fit, this single harness ensures proper communication between the sensors and the control system, restoring optimal drying perf...Read moreormance when the original part fails. Common signs of failure include clothes remaining too wet or becoming over-dried. For safety, disconnect power before installation and follow manufacturer guidelines.

This grey drying rack fits inside your front load dryer. It is an accessory used to dry items that should not tumble, like shoes, stuffed animals, pillows, or other delicate items. It provides a stationary surface for these items to rest on while air circulates. The rack is 27 inches wide and can be attached inside the dryer drum. This genuine OEM rack is sold individually.

This OEM Fuel Filter is a white and silver, steel part, sold individually. It requires a pair of pliers to install and is ranked as Easy to repair by our customers. This part attaches inside of the fuel tank, and is used to clean the fuel of debris. This part should be changed regularly as part of good engine maintenance. If the engine ...Read moresounds like it is not getting enough fuel or is underperforming, remove the filter to heck for a blockage. If there is a blockage or the part is leaking, then it likely needs a replacement.

This cotter pin is an OEM part that is 1.25 inches long, gold in color, and sold individually. Made of metal, it can have a range of applications on a variety of lawn and garden equipment. Generally, you will need to replace this part if it becomes broken due to age and wear, or if you need to remove it for making other repairs. This is...Read more an easy repair that only requires a pair of pliers to carry out. You need to bend one end around the shaft or bolt and bend the other around the back end of the bolt to complete the repair.

This is a original manufacturer sourced replacement part used on Snapper lawn mowers. This is the ground drive belt that connects the engine crankshaft pulley to the transmission pulley. This part is made out of rubber and it is sold individually. Clean the pulleys off before installing the new belt to ensure top performance and longevit...Read morey with your new belt. Inspect belts periodically and replace them when worn to maintain peak performance. To replace this belt you would need a wrench and a screwdriver.

Also known as a belt switch.