8019 - Parts

This is a genuine Black and Decker replacement part, it is sold individually. This is the part of the mower that turns the motor on and off. It is actuated by pulling on the switch lever. It has four terminals on the back for slide on spade connectors.

It is a genuine OEM sourced replacement screw which is specially designed for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. Please refer to the appropriate diagrams of your model for the correct location and application of this hardware. This durable metal screw is sold individually, you will need a wrench to secure or remove it.

This genuine Primer Cover, or Primer Pump Cover, is a silver, individually sold, steel part with dimensions of around 1x1 inch. This part is installed using a screwdriver, and is rated as Easy to install by our customers. This part secures the plastic primer bulb to the air purge body assembly, and must be replaced if damaged or bent.

This manufacturer approved replacement part is specially produced for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. It is utilized to keep the oil in the tank. Please note this durable plastic oil fill cap is sold individually.

This is an authentic manufacturer made replacement part which is specially designed for use with Craftsman lawn mowers. The engine crankcase gasket seals the crankcase cover and to keep out dirt and debris from compromising the engines components. This part is sold individually though it is a common wear part, so we do recommend ordering ...Read morea spare. For installation, you will need a screwdriver to remove any covers and shrouds and a socket wrench to aid you.

This OEM Hex Socket Bolt is a black, 5x12mm, individually sold, metal part. A Hex Socket and Torque Wrench can be used to secure the part in place by torqueing to the manufacturer specifications. The part must be replaced when damaged (likely due to fatigue), for example if it is rounded off, has stripped threads, or is missing altogether.

This is an original Shindaiwa replacement part manufactured for use with outdoor power equipment. The joint is used to connect fuel lines and is commonly used to connect the return fuel line to the fuel tank grommet. This joint is sold individually, please seem model diagram for associative parts.

This is a genuine Shindaiwa replacement part manufactured for outdoor power equipment. This kit is OEM, not an aftermarket imitation. The kit includes the diaphram, and gaskets between the air purge body, and carburetor body. It is recommended to replace the gaskets when reassembling the carburetor after a repair, the kit is sold individually.

This authentic manufacturer-supplied washer is specially designed for use with Briggs and Stratton engines that are commonly installed on lawn and garden equipment. It is a special hardware that helps to provide a tight seal between connected components. This is an identical replacement for a missing or a damaged packing-needle valve that...Read more was installed on a new unit. One durable rubber part is included. Refer to the appropriate diagrams for your model to ensure the proper replacement procedure.