6054 - Instructions

Snapped new wheels into place on the axel. New wheels were exactly like the old ones

Replaced the part and everything worked fine

I snapped on the new roller and bingo! problem solved.

Two rollers on the lower rack were missing and one was flattened. I popped off the bad roller and snapped the three new rollers in place, all by hand. Took about 60 seconds.

So easy it shouldn't even count as a repair, really. The dishwasher, there when I bought the place, had a lower rack that wouldn't roll out as it should. That's because there were no wheels on the left side.

The rack lifts out easily. These wheels snap on to small protrusions from the wire rack.

First I pulled out the old gasket, used this to measure for the new gasket, cut to right length, pushed new gasket into the track and washed a load of dishes. No leaks! This took about 2 minutes to complete.

Watching the video showed an easy, unscrew and screw back on process while connecting the wires back. It was really that simple. Once it was complete (not even 10mins), plugged it back in, and its been working great since.

This could not have gone easier! As long as you get the proper parts it's a piece of cake. I wish everything was this easy!

Removed front panel and eased out screws holding the dishwasher in place. Lowered the door and removed old springs. Replaced the springs and sit the unit back in place. When they are this old it is best to replace both springs. Rated easy...,

The 'kick plate' had to be removed, and the feet had to be raised to lift the unit over the floor. the old spring could not be found, and while lying on the floor my husband had to 'feel' for the attatchments to hook up the new spring. The unit was then pushed back and the legs dropped and the unit attatched to the counter. All fixed - ... Read more - thank you PartSelect for having the right spring.

Both heating element brass nuts had a split in them. They had fallen off the heating element and were hanging on the electrical wires. I removed the wires from the heating element and removed the brass nuts from the wires. I then screwed the new nuts on the heating element and reattached the wires. problem solved. I want to thank you for ... Read more having the parts I needed as Sears had discontinued them for this Kenmore appliance.

Had a leak, due to the factory gasket was 1/2 " to short. Pulled out old one, installed new one, and trimed to fit. Took less the 5 minutes.

Orderd new gasket which arrived extremely fast, old gasket just pulls out , installed new one same direction as the old gasket fit, stopped leak. Thanks!

Installed New rollers onto bottom rack. Part order & delivery were top notch from Partselect. Will definitely order from them again.

Fisrt, I opened dishwasher door. I then pulled out the lower rack & put new part in place and pushed in lower rack. Last, I closed dishwasher door.