4625 - Parts

It is an authentic high quality hardware that is supplied from original equipment manufactured for use with Murray lawn tractors. This cotter pin fits through the axle helping to secure the mower wheel. Please note one durable metal pin is included per order. You will need pliers to install or remove this item.

This hex bolt is sourced from the original equipment manufacturer. The bolt is designed to fasten two individual parts together in your lawn and outdoor equipment. It is made of steel to withstand harsh environmental conditions and measures 0.25 inches in diameter and 0.62 inches in length. The hex bolt gets its name from its hexagon-shap...Read moreed head, which makes it easy to grip with a wrench or socket. Before installing the new bolt, first clean the threaded hole where the bolt rests to remove any dirt or debris in the area. Once the area is clean you can place the bolt in position using your hands and tighten it using a wrench or socket. It is important not to overtighten as this could damage the area and the bolt. Sold individually.

This washer is designed for use within lawn tractors, lawn mowers, edgers and snow blowers, and is a genuine OEM part that is sold as an individual. This washer has an approximately .54-inch inner-diameter and .81-inch outer-diameter and is made of high-quality metal, but can wear down due to exposure to heat, friction, and fuel. Due to t...Read morehe versatility of this washer, it can be used in a multitude of settings and applications and is not used for one specific purpose, so check the user manual for your equipment for the exact installation locations of this washer.

This is an authentic manufacturer sourced replacement blade. It is commonly used on Murray lawn mowers/tractors. This blade can be used to mow, mulch and discharge grass. Over time blade would become dull or bent. This would cause uneven cuts and could damage the mower. This part is made out of metal and it is sold individually. To replace it you would need a wrench to remove the nut that secures the blade.

This is an original replacement part manufactured for use with small engines. The metal hose clamp is used to secure the vacuum hose. One clamp is required for each end of the hose, this clamp is sold individually.

It is an authentic OEM sourced item which is specially produced for use with Murray lawn tractors. The spindle bearing goes between the washer and the cast iron axle and helps to reduce the friction. During the installation process, a screwdriver and a set of pliers might be needed to replace this part. It is made of plastic and will requ...Read moreire replacing if it becomes broken. This is available as an individual replacement part.

This Washer (.40.81 16g Flt) is a black, metal part, requiring a socket set to install. Installation is rated as "Easy". This washer can be used to provide a tight fit between connected components. It attaches onto the bell crank between the adjusting nut and cotter pin. Refer to your make, model and diagrams to check if this model is right for you.

This is a genuine OEM sourced hardware, it is not an aftermarket equivalent. This high quality item is specially designed for use on Murray riding lawn mowers and tractors. This screw has multiple applications depending on the model. Please make sure to check appropriate diagrams for correct location and use of this hardware. You will need a wrench to install or remove this screw. One item is included per order.