4625 - Parts

This part provides protection for the compressor motor against excessive current and excessive temperature use.

This centerlock nut, or lock nut, is sold individually and locks itself in place when inserted, to prevent it from backing out due to vibration. Over time, due to its strenueous job, it may become loose or break due to wear and tear, and will need to be replaced. This lock nut is made of metal and is silver in color. When it will no longe...Read morer lock, you will need to complete this easy repair, which requires a wrench or socket and torque wrench. Ensure you torque the lock nut to your manufacturer specifications; this nut can have a range of different applications for a variety of equipment, so please check your model number or owners manual to be sure it is the right fit for your model.

Sold individually.

The Shoulder Bolt (size: 3/8 16 x 3/4) is a black, metal, individually sold part. It can be installed using a wrench or socket. This part is used to secure other parts in place. You'll know if it needs to be replaced if the part is coming loose. This means it is damaged, likely due to fatigue/wear/damage. Refer to your make, model and diagrams to ensure you're picking the right part.

This insulation measures 2.5" thick, 33" wide and 70" long.

This part helps to maintain the proper temperature in the appliance.

This is a Genuine Manufacturer Approved replacement Belt used on Murray Lawn Tractors. This part is made out of Rubber and it is Sold Individually. This is the the Smaller Belt that drives Blades on your unit. Clean pulleys before installing the new belt to ensure top performance and longevity with your new belt. Inspect belt periodical...Read morely and replace it when worn or stretched to maintain peak performance. You would need a Wrench set and Pliers to replace this belt. • For your safety make sure to disconnect the spark plug wire. • Fist you would need to lower the mower deck to the lowest position • Then move the blade engagement lever to the Off position. • Roll the belt off the engine pulley from between the belt guide and pulley. • Remove mower deck by removing the bow-tie pins securing the left and right lift arms • Disconnect the blade engagement cable from the mower deck • Remove the bolts from the mower deck belt pulley covers and pull the covers off. • Loosen but don't remove the nuts on the top of the idler pulleys. • Install the new mower deck belt through the belt guides and around the pulleys. • Tighten the nuts on the top of the idler pulleys. • Re-Assemble the Deck