3VET2 Whirlpool Refrigerator - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Cracked Evaporation tray was leaking water on kitchen floor
26 of 34 people
found this instruction helpful.
-
Jerrel from REDDING, CA
- A Bit Difficult
- 30 - 60 mins
-
Socket set, Wrench (Adjustable)
I emptied refrigerator contents and tilted the refrigerator to the right so as to access the metal panel upon which the evaporation tray was resting. The metal panel is on the left side underneath the refrigerator and the evaporation tray is resting on the panel. I removed 4 screws that were holding the metal panel, pressed down on the
... Read more
panel, slid out the old, cracked plastic evaporation tray, inserted the new plastic evaporation tray, raised the metal panel to its original position, replaced the 4 screws, being careful not to pinched the water line that feeds the ice-maker. VOILA! Un-tilt the frig and re-stock it. It took a day for the temperature to stabilize, due to tilting, I think. New tray $45.
Read less
Was this helpful?
Thank you for voting!
I knocked the drawers off the counter when cleaning them and they shattered.
24 of 31 people
found this instruction helpful.
-
Kel from Boulder, CO
- Really Easy
- Less than 15 mins
The only tricky part of ordering replacement drawers for this fridge is that the bottom ones are two different sizes so you have to be sure you order the right one. Measure the width and look closely at the exploded drawing to be sure you are getting the right one.
Other Parts Used:
Was this helpful?
Thank you for voting!
Broken glass shelf
22 of 27 people
found this instruction helpful.
-
Frank from Brookfield, IL
- Really Easy
- Less than 15 mins
Took out glass shelf to clean. Shelf exploded into a billion little pieces for no apparent reason. Received replacement shelf the next day (with the 3 - 5 day shipping). Cleaned glass, placed in ice box. Viola!
Was this helpful?
Thank you for voting!
Water leaking from under refrigerator.
17 of 18 people
found this instruction helpful.
-
Ronald from DELRAN, NJ
- Difficult
- 1- 2 hours
-
Nutdriver, Screw drivers, Socket set
Water leaking from under refrigerator. Initially believed leak was from filter assembly. Removed filter and shut off water supply but leak appeared at different intervals again. Large puddle of water coming out from under refrigerator. Removed back lower panel and checked for leak, but didn't find any. My wife was also checking for le
... Read more
ak and found a crack in drip tray. Only way we could get the drip tray out was to first remove front lower panel, disconnect and remove wiring harness in front of drip tray, unbolt water filter assembly, and unbolt water solenoid unit at rear of refrigerator. Their water lines connect to filter assembly. My wife controlled the water solenoid unit to give me play as I pulled the filter assembly out as much as I could from the front. I could now wiggle the cracked drip tray out from under the filter unit. Replaced drip tray and reinstalled wiring harness, water filter unit w/new filter, and re-bolted water solenoid unit at back of refrigerator. Replaced back lower panel after turning water back on and checking for leaks. Replaced front lower panel.
The reason still had leak after initially turning off water supply was because the drip tray is used to catch the water when refrigerator goes into the defrost cycle. Since the original drip tray had cracked, water only appeared on floor after defrost cycle.
The reason still had leak after initially turning off water supply was because the drip tray is used to catch the water when refrigerator goes into the defrost cycle. Since the original drip tray had cracked, water only appeared on floor after defrost cycle.
Read less
Was this helpful?
Thank you for voting!
We broke the rail. :(
17 of 19 people
found this instruction helpful.
-
heather from union bridge, MD
- Really Easy
- Less than 15 mins
We decided to use our crisper drawers to store sodas. Duh..bad plan. The rail that holds the drawers up cracked in half. So we just had the drawers sitting on the bottom of the fridge. So, I got the new rail THE DAY AFTER I ORDER IT! I just recycled the old one, and slid the new one in. Presto. Perfect fit. Actually, better then perfect.
... Read more
There must have been a defect with my old one, because the new one actually SNAPPED into place, instead if just sitting in the frame. So..I am really pleased.
Read less
Was this helpful?
Thank you for voting!
the door trim was bent and broken and would not hold items in place
18 of 23 people
found this instruction helpful.
-
patricia from collinsville, IL
- Really Easy
- Less than 15 mins
I only needed to set the endcap and trim piec es in place, no tools involved
Other Parts Used:
Was this helpful?
Thank you for voting!
front roller wheel broke
19 of 29 people
found this instruction helpful.
-
Anoop from Diamond Bar, CA
- A Bit Difficult
- 30 - 60 mins
-
Screw drivers, Socket set
its not that hard to replace. may need help to tilt fridge on one side so you can get to the bottom to remove wheel.Had to undo all four corner screws/bolts to loosen bottom section and slowly pull out base frame which holds the 4 wheels. this frame is also holding the compressor and fan so be careful.replace wheel and slowly put frame ba
... Read more
ck to position and screw back bolts. pull back fridge to upright position. leave unplugged for a day or two to allow gas to come back to normal level as we had tilted it.plug it back and it works.
thanks
Anoop
thanks
Anoop
Read less
Was this helpful?
Thank you for voting!
I have a fridge in one of my rentals that was missing 2 crisper drawers
17 of 24 people
found this instruction helpful.
-
kevin from macedon, NY
- Really Easy
- Less than 15 mins
I ordered the crispers and they came the next day.I took them out of the box and had them installed in about 30 seconds.It doesn't get any easier than that.The lady on the phone was very helpful when I placed the order.The fact that they came the very next day was amazing to me.
Other Parts Used:
Was this helpful?
Thank you for voting!
light inside fridge was flickering and clicking
20 of 35 people
found this instruction helpful.
-
bill from escondido, CA
- Easy
- 15 - 30 mins
-
Nutdriver
tested bulb good ,replaced door switch first(least expensive)then ordered light socket and circuitboard.If clicking sound is heard replace circuitboard first to save on return shipping because the switch and socket where ok
Was this helpful?
Thank you for voting!
broken crisper drawers & tempered glass
14 of 17 people
found this instruction helpful.
-
Sherri from Willoughby, OH
- Really Easy
- Less than 15 mins
took out broken with no tools req replaced new with no tools req
Other Parts Used:
Was this helpful?
Thank you for voting!
Crisper Cover that holds veggie bins were broken
15 of 20 people
found this instruction helpful.
-
Jean from St. Louis, MO
- Really Easy
- Less than 15 mins
Too simple! I removed the crisper bins, took off the broken crisper cover and replaced with new crisper cover then inserted the bins under it. Viola! Ordering a part from this site was so easy. My frig is 10 years old and I didn't think I would be able to find a part, but it did.
Was this helpful?
Thank you for voting!
Condensation in fresh food area
14 of 18 people
found this instruction helpful.
-
Larry from Goffstown, NH
- Easy
- 30 - 60 mins
-
Nutdriver
I just removed the old seal cleaned the area and simply installed the new seal. The instructions were easy to follow and project was completed in less than 1 hour.
Was this helpful?
Thank you for voting!
cracked bins
12 of 13 people
found this instruction helpful.
-
David from Media, PA
- Really Easy
- Less than 15 mins
Two bins were cracked. I simply unhooked the broken bins and put the new ones in their place.
Was this helpful?
Thank you for voting!
Broken glass shelf
13 of 16 people
found this instruction helpful.
-
MELISSA from CUMBERLAND, MD
- Really Easy
- Less than 15 mins
While cleaning the refrigerator I had taken the bottom glass shelf out to clean it in my sink and unfortunately it broke into thousands of little pieces. After clean up the mess and my cut thumb, I went online to see about replacing it. First went to Whirlpool site, they had the broken shelf but for considerably more than I found on you
... Read more
r site. Your website was easy to use and the part and the shipping was much more reasonable. I ordered on a Sat afternoon and the shelf, which was exactly the same as the one that had broken, was on my front porch by Tues @ 9:00 am. You never know when you make a purchase online with a company you are not familiar with, but I can say this was a great experience.
Read less
Was this helpful?
Thank you for voting!
Freezer compartment iced over, food thawing,
12 of 13 people
found this instruction helpful.
-
Lawrence from New Bern, NC
- Easy
- Less than 15 mins
-
Nutdriver
I deenergized the refigerator, removed the storage tray, three screws that hold the ice maker, two screws that hold the lower portion of the freezer, two screws tjhat hold the back portion of the freezer. Removed the ice maker and disconnected the wire connector and ground, Removed lower portion of the freezer which allowed the back porti
... Read more
on to be lifted out. Once the back was out the bimetal defrost thermostat was located in the upper right corner clipped to a copper line. Using an ohm meter, I found the bimetal defrost thermostat to be electrically open, ordered part from information found on part, Once part arrived I deenergized the refrigerator and replaced bimetal thermostat by cutting the old thermostat wires (pink and brown), stripping the wires back about 5/8 inch and wire nutting the replacement parts like colored wires, clipped the bimetal part on the copper tube, replaced the covers in reverse order, and reenergized the refrigerator. Testing and replacing the part took about 15 minutes, waiting for the ice build up to thaw took considerably longer.
Read less
Was this helpful?
Thank you for voting!