3976 - Instructions
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Freezer hinge was worn
6 of 6 people
found this instruction helpful.
-
Wilbur from Waynesboro, PA
- A Bit Difficult
- 30 - 60 mins
-
Nutdriver, Wrench (Adjustable)
Shut off water and disconnected at factory joint at bottom hinge. Unplugged the electrical at the top hinge. Removed the door and installed new bottom hinge and cam assembly. Reinstalled the door and hooked water and electric back up. Part worked fine.
Was this helpful?
Thank you for voting!
Cams on Hinge assembly broken, door didn't close properly
7 of 9 people
found this instruction helpful.
-
Stephen from Lafayette, NY
- Really Easy
- 15 - 30 mins
-
Socket set
I supported door with 2* 6 scrap wood. I used cedar shingles to raise door to correct height.
Using a socket wrench, I removed the hinge from the fridge and the cam assembly from the door.
I installed the new hinge and cam using the shims thatwere behind the original parts.
I removed the 2*6 supports and the door now works ... Read more perfectly.
Using a socket wrench, I removed the hinge from the fridge and the cam assembly from the door.
I installed the new hinge and cam using the shims thatwere behind the original parts.
I removed the 2*6 supports and the door now works ... Read more perfectly.
Read less
Was this helpful?
Thank you for voting!
Left Side Veggy Drawer Slide Rail Broken . Drawer Drops Down
6 of 6 people
found this instruction helpful.
-
Daniel from Mingo Jct., OH
- Easy
- 15 - 30 mins
-
Screw drivers
Empty veggy drawer. And slide out top glass shelf of drawer. Using philips screwdriver, remove (2) screws that hold rail to side wall of fridge. Replace with new slide . Slide glass shelf back in and then veggy drawer. 15 - 20 Minutes tops to fix. Tell wife if drawer doesent shut don't force it closed! (Overload it)
Was this helpful?
Thank you for voting!
Refrigerator would begin to lose it's cool and we saw ice caking on the bacjk panel of the freezer section.
7 of 9 people
found this instruction helpful.
-
Charles from Edison, GA
- Easy
- Less than 15 mins
-
Nutdriver, Screw drivers
We had to empty the freezing section, remove the 4 screws that held the back panel and defrost the coils. Then with the diagram we got from the internet, we removed the defroster and easily installed the new one and put the back panel back on. We did find later that it was still icing over so I ordered the thermostat and we installed it
... Read more
today.
It too was easy to install. We spliced the wires and hooked the new thermostat to the old wires and reinstalled the back panel. Hopefully this will solve the problem for us now.
It too was easy to install. We spliced the wires and hooked the new thermostat to the old wires and reinstalled the back panel. Hopefully this will solve the problem for us now.
Read less
Was this helpful?
Thank you for voting!
broken fan blade in the freezer compartment
7 of 9 people
found this instruction helpful.
-
John from Cumberland, MD
- Really Easy
- Less than 15 mins
-
Pliers
Unplugged frige, removed top shelf, pulled broken fan blade off. Replaced with fan blade just purchased from PartSelect. Very simple repair. Orderd and recieved the right part.
Was this helpful?
Thank you for voting!
door would not close, had dropped down.
6 of 6 people
found this instruction helpful.
-
bert from Spartanburg, SC
- Really Easy
- Less than 15 mins
-
Screw drivers, Wrench (Adjustable)
Was able to pull the door up to the normal position, then blocked in place with 2 2x4's. Easily removed the hinge assemble and the door closing cam, which had broken in two.
bolted on the replacement parts in 10 mionutes and the door was a good as new: peice of cake!!!
bolted on the replacement parts in 10 mionutes and the door was a good as new: peice of cake!!!
Other Parts Used:
Was this helpful?
Thank you for voting!
Refrigerator would not defrost
7 of 10 people
found this instruction helpful.
-
Thomas from Dresden, OH
- Really Easy
- Less than 15 mins
-
Nutdriver
When it was discovered there was a cooling problem in the refrigerator, I went to parts select web site and went through the troubleshooting section. Then I tested the defrost timer and the defrost element as directed by the web site. I then found out doing this, that is was the defrost timer. I ordered the part online and it was delivere
... Read more
d THE NEXT DAY! I removed the bottom panel of the fridge, removed the screw holding the old timer, removed the wires, and reversed the procedure to install the new one. It has been 1 week, and everything is working great. Thank you PartSelect.
I have since then recommended you to a relative who was having the same problem. Thanks again.
I have since then recommended you to a relative who was having the same problem. Thanks again.
Read less
Was this helpful?
Thank you for voting!
Frezer frozenin ,no icemaker working
6 of 7 people
found this instruction helpful.
-
zoltan from New York, NY
- Really Easy
- 30 - 60 mins
-
Screw drivers
Lets start with the hard part:
Convince wife to get a couple of her girl friends
to go to a movie and see the Reader,after that
visit a cafe or pub (remembered years ago the
English Patient). Drove to get a six pack,removed the back panel-2 min, set a hair drier to position,
had a couple beers , removed the defros ... Read more t heater unit
1 min. replaced it 1 min. back panel1 min,enjoyed the rest of the afternoon,finished the beer
Killed two birds with one stone
Zoltan L Petho
Convince wife to get a couple of her girl friends
to go to a movie and see the Reader,after that
visit a cafe or pub (remembered years ago the
English Patient). Drove to get a six pack,removed the back panel-2 min, set a hair drier to position,
had a couple beers , removed the defros ... Read more t heater unit
1 min. replaced it 1 min. back panel1 min,enjoyed the rest of the afternoon,finished the beer
Killed two birds with one stone
Zoltan L Petho
Read less
Was this helpful?
Thank you for voting!
Refridgerator quit cooling because the defrost element had burned out and the refridgerator coils were totally covered with ice.
6 of 8 people
found this instruction helpful.
-
sherry from runaway bay, TX
- Easy
- 30 - 60 mins
-
Screw drivers
I defrosted freezer. Removed cover from back of freezer. Removed screws from element disconected wires. I connected wires to new element installed screws and reinstalled cover.
Was this helpful?
Thank you for voting!
Refrigerator to warm
5 of 5 people
found this instruction helpful.
-
Lloyd from PITTSBURG, CA
- Easy
- 15 - 30 mins
-
Screw drivers
Instructions say run capacitor is by motor, but on this frige its in the refrigerator compartment. The capacitors looks different, one square and the other long
Was this helpful?
Thank you for voting!
Refrigerator door would not shut
5 of 5 people
found this instruction helpful.
-
Bobby from SENECA, SC
- Very Easy
- 15 - 30 mins
-
Socket set
Removed old hinge assembly, bolted on new assembly-door shut like new
Was this helpful?
Thank you for voting!
light not working
7 of 11 people
found this instruction helpful.
-
robert from FRANKLIN SQ, NY
- Very Easy
- Less than 15 mins
-
Pliers, Screw drivers
I used pliers to pull lightly on the head of the switch, while I inserted a small flat head screw driver into the base of switch and gently worked around the edges to free it from the panel.
Was this helpful?
Thank you for voting!
Freezer kept freezing up
6 of 8 people
found this instruction helpful.
-
Wesley from Hattiesburg, MS
- Really Easy
- 15 - 30 mins
-
Screw drivers
Removed the cover for the evaporater coils and let them defrost. Then took the old heating element out by removing two screws on the bottom element and two screws on the top element. Unplugged it and removed it from the unit. Then repeated the reverse of the procedure, installing the new unit, no wires to splice only one plug and four
... Read more
screws.
Read less
Was this helpful?
Thank you for voting!
Fresh Food section door made a click noise on closing
5 of 6 people
found this instruction helpful.
-
Charles from Renton, WA
- Easy
- 15 - 30 mins
-
Screw drivers, Socket set
Since the cam riser was obviously broken I obtained a replacement.
It also broke. The door hinge cam needed to be replaced also.
To repair Remove the hinge cover using a #2 phillips driver. Than remove the Hinge using an 8mm socket. Turn the door upside down and, using an 8mm socket remoge the cam riser and the door hinge cam. ... Read more r />Replace in reverse order.
Be sure to inspect all parts and order all required.
It also broke. The door hinge cam needed to be replaced also.
To repair Remove the hinge cover using a #2 phillips driver. Than remove the Hinge using an 8mm socket. Turn the door upside down and, using an 8mm socket remoge the cam riser and the door hinge cam. ... Read more r />Replace in reverse order.
Be sure to inspect all parts and order all required.
Read less
Was this helpful?
Thank you for voting!
door wouldn't close
5 of 6 people
found this instruction helpful.
-
Linda from Manorville, NY
- Easy
- 15 - 30 mins
-
Socket set
First I propped up the door. Then I removed the 2 screws that hold the hinge on. AT this point you do need someone else because the door swings loose. I attached the new bracket and lowered the door. It went verey smooth. I ordered the new bracket after reading the installation stories from others who just repaced the plastic pieces. Its
... Read more
worth the extra money to just put on a new bracket
Read less
Was this helpful?
Thank you for voting!