EasyApplianceParts is now PartSelect! We've merged our sites to provide a better shopping experience for you.   Full Details
✖

Find Parts

Parts Departments

Top Model Types

Top Brands

Repair Help

Expert Repair Videos

Keep typing for more specific results...

35HG Magic Chef Range - Instructions

All Instructions for the 35HG
91 - 105 of 111

Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!

Search filter:
Clear Filter
Your search term must have 3 or more characters.
Drip bowls tarnished.
  • Jennifer from Albion, NE
  • Really Easy
  • 15 - 30 mins
Remove heating element coils. & old drip pans. Install the new drip pans and reinsert the heating elements and insure all elements were level. For aesthetic reasons I replaced all the drip pans - 2 x 8" & 2 x 6".
Was this helpful?
Thank you for voting!
Broken Door Spring
  • Matthew from Chippewa Falls, WI
  • Really Easy
  • 15 - 30 mins
  • Pliers, Screw drivers
Slid oven out from counters. On each side there are 3 screws on the front and three screws on the back holding the side piece on. Once off, the spring was very easy to get at and replace. I had only one broken, but replaced both anyways. I think it took longer to clean the sides of the oven that haven't been touched in years than to r eplace the springs. This job was very simple and easy.
Was this helpful?
Thank you for voting!
Broil element burned out
  • Wallace from Lowell,, AR
  • Easy
  • 15 - 30 mins
  • Screw drivers
Removed the oven door, removed old burned element, installed new element. Turned CB back on and tested oven. Reinstalled oven door. Straight forward and easy to follow directions with new element.Local appliance part house said the element was no longer available. Thanks to you I did not need a new oven. Very easy replacement job with nor mal tools.Thanks
Was this helpful?
Thank you for voting!
The original bake element burned out
  • William from Florissant, MO
  • Really Easy
  • 15 - 30 mins
  • Pliers, Screw drivers
1. Removed racks 2. Removed two screws holding in the bake element. 3. Gently pulled out the element exposing the two wires connected to it. 4. The two wires were held by a clip connection. 5. Removed the wire clips holding the wires. 6. Attached the clips to the new element and re-installed the element. New problem: The eleme nt did not heat up. A repairman informed me that the selector switch was damaged during the burnout- that switch was no longer manufactured and was discontinued. Whirlpool company was checked and indicated that there was a new part # 7403P023-60 but that was discontinued too. I was able to get the element working by moving the selector switch to the "Bake" position and then moving the switch about 1/4" in the clockwise direction. The element heated and the oven works at least for now as I search for a replacement part. PartSelect was an invaluable aid and helpful all along the process.
Was this helpful?
Thank you for voting!
I had a power serge and it burned the Plug at the termial block and melted a few wire.
  • Robin from Vanderbilt, PA
  • Really Easy
  • 15 - 30 mins
  • Socket set
After we got the part in the mail my husband put it on and shortened the wires and put new plugs on the ends of the wires and we had to get a new plug put it on and it was fixed.
Was this helpful?
Thank you for voting!
All Instructions for the 35HG
91 - 105 of 111