22314 (1988) Kenmore Range - Instructions

they come off real easy. then you just plug the new range top in.

removed old cartridge and inserted new cartridge, less than 10 seconds. Wish I had replaced this cartridge several years ago. I have ordered a second one to replace the remaining old one.

Easy as pie. Just wiped off and plugged in.

replaced stove top switch

Well I was just guessing the controll switch was bad so I ordered a new one. So I cut off the power and held the switch close to the old one and changed the wires one at a time matching the connection terminals and cut the power back on and presto it WORKED..The service man wanted to charge me 65.00 dollars just to check it out. I figure I saved about 100.00 dollers plus I learned something.

took old burner out and put in new burner. No problem. Easy greasy

I pulled out the old cartridge, cleaned the stove top and inserted the new cartridge. No problem!

Not much to tell about installing a new grill grate.
Partselct.com was very prompt and efficient in sending out the part.

easy...opened box and plugged it in.....

I've ordered parts from you twice now, and both times the service has been absolutely amazing!!!!!

Now, on to how I did this without fire or electrocution:

Turned off breakers.
Grabbed a beer.
Removed two screws holding in plate.
Removed electrical connectors.
Removed two screws holding switch.
Put new switch in place with screws.
Reattached connectors.
Reseated plate & screws.
Turned on power & tested.
Finished beer and felt very manly.

The hardest part was getting the plate to re-seat.

plugged the new one in and it was ready to use

We took out the old element cartridges, and plugged in the new cartridges. It was easy, and made our cook top look fantastic!

When I called to inquire if a new cartrige would fit in my 1985 model range the gentleman walked me through unplugging the old cartrige to see how it connected. I did this while on the phone with him and I then explained the connection; he told me that a new cartrige would just plug into the same place....and it did!
You had a great person at your service desk.
Thank you

Replaced one of the four burner control switches on my Jennair cooktop. One of the tricks I use to prevent mistakes is putting the new switch along side the existing one and swap one connector at a time over to the new switch preventing any confusion and negating any need to mark the wires. This differs from your video assistant who disconnected all the wires at once.
gc.

It was jus a matter of unwrapping the cartidge, unplug and remove old and plug in. What a difference, should have done this years ago.



I will use this company again.