03021 - Parts

This is sold as a kit that contains the bushing and the seal. These are genuine replacement parts sourced from the original manufacturer for use with engines, snowthrowers, lawn mowers, and blower-vacuums made by Briggs & Stratton and Toro. When replacing these items a set of pliers might be required during the installation process. They are made of metal and plastic and will require replacing if they become broken.

It is a genuine item that is supplied directly from the original equipment manufacturer for use with Briggs and Stratton generators and pressure washers. The purpose of this component is to reduce the vibration of a working unit, unfortunately, over time it may begin to fail eventually requiring a replacement. Please make sure to refer to...Read more the appropriate diagrams of your model for the correct location and application of this part. Keep in mind this high-quality vibe mount with a washer is sold individually.

This is an authentic OEM sourced replacement part, it is specially produced for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. This is a standard hardware which has multiple applications based on the model of your unit, please refer to appropriate diagrams for the correct and use of this item. T...Read morehis Torx screw is made of high-quality metal and it is sold individually, it includes one washer.

This is an authentic Briggs & Stratton replacement part that has been sourced from the original manufacturer to be used with small engines. The gasket is used to seal the connection between the muffler and the muffler adaptor. A torx driver is needed to install this part, the gasket is sold individually.

This is an authentic replacement part that has been sourced from the original manufacturer to be used with small engines from Briggs & Stratton and Toro. The metal screw is used to secure the muffler deflector or to secure the starter clutch to the flywheel. This item is available as an individual replacement part.

This is an authentic OEM part from Briggs and Stratton and Toro for use with garden equipment engines. The stop wire connects the ignition coil to the stop switch to ground the spark voltage to the engine block when you release the bail control bar. This part is sold individually. The tool that you will need to replace the stop wire is pliers.

This rewind starter housing kit includes components used to support manual engine starting. Designed for durability and smooth operation, it helps restore reliable recoil action and consistent starting performance.

This is a genuine Briggs & Stratton part sourced directly from the manufacturer for use in generators. The outlet is made of metal and plastic and attaches to the control panel. A screwdriver may be necessary during the installation of this item. It may become broken and will need to be replaced. This is available as an individual replacement part.

This is an original replacement part manufactured for use with small lawnmower engines. The pick-up tube is commonly used to pull fuel into the carburetor to mix with air to be sent into the engine's combustion chamber. This special pick-up tube is available as an individual replacement part, please see model diagram for associative parts.

This replacement part is a genuine manufacturer-sourced designed for use with Briggs and Stratton engines commonly installed on Toro lawn and garden equipment. It provides an air-tight seal for the cylinder head, over time the material may begin to deteriorate and crack eventually requiring replacement. This part is made of high-quality composite material and it is sold individually.