Official Maytag Ice Maker Parts | Order Today, Ships Today | PartSelect

Popular Maytag Ice Maker Parts

Your Price
$113.02
Replacement Ice Maker
(66)
PartSelect Number PS2121513
Manufacturer Part Number D7824706Q
This is a replacement ice maker. This assembly includes the ice mold and the control device. The water inlet valve pumps water into the mold, which stays there until it is frozen solid and ejected into the storage bucket. The process continues until the bucket is full. This replacement part does not include the cover, shut off arm, wire harness, or the mounting hardware. You will need to use the existing pieces, or order those separately. You will need a nut driver to successfully install this part. Unplug your appliance before you begin any repair work.
Fixes these symptoms
Ice maker dispenses too little ice
Ice maker dispenses too much ice
Ice maker not making ice

See more...
Installation Instructions
Bernie from Diamond Bar, CA says,

Icemaker producing few or no cubes and often leaving "kling-ons" on ice tray
Interior surface of ice tray felt rough & flaky (coating deteriorated) so cubes would not release.
Unplug appliance.
Remove timer cover by hand pressure @ edge.
Remove single attachment...read more

Your Price
$115.12
Condenser Fan Motor Kit
(30)
PartSelect Number PS1957416
Manufacturer Part Number W10124096
This condenser fan motor kit includes a motor, fan blade, wire harness, and screws. Used in a refrigerator, the condenser fan motor moves the condenser fan blade to direct and move air across the condenser coil. Please note: The manufacturer has changed the appearance of the product from the original. The kit still functions the same as the original part. It is an OEM factory replacement. Make sure to unplug the refrigerator from the power source and wear gloves to protect your hands. Also, a helpful tip is to store food to prevent deterioration when the power is off.
Fixes these symptoms
Clicking sound
Freezer section too warm
Fridge and Freezer are too warm

See more...
Installation Instructions
Josue from Jacksonville, NC says,

Seven year old condenser fan was making noise when it was running.
The process to repair was very simple, I removed the back of the refrigerator to expose the motor area. I then removed three screws that held the condenser motor in place. once it was loose I detactch...read more

Your Price
$22.28
Water Fill Cup and Bearing
(5)
PartSelect Number PS11743318
Manufacturer Part Number WP628356
This refrigerator ice maker fill cup dispenses the water into the ice cube mold during the fill cycle. Replacing the water fill cup is a possible solution if you notice that the ice maker is leaking, or not making/dispensing ice. If you notice the fill cup has been damaged or cracked; replace the part straight away. This water fill cup is a genuine OEM part and will fit most refrigerators, but check the list of compatible brands to make sure yours is included before purchasing.
Fixes these symptoms
Ice maker dispenses too much ice
Ice maker not making ice
Ice maker won’t dispense ice

See more...
Installation Instructions
David from Chester, CA says,

The Bearing Cup Assembly was broken and ice would jamb against it during the ice making cycle.
I removed the ice maker from the refrigerator, by removing one screw on the underside bracket and loosening the two screws at the top side, then lifting the ice maker off the loosened screws. I then ...read more

Your Price
$33.13
Cycling thermostat
(1)
PartSelect Number PS11743313
Manufacturer Part Number WP627985
The ice maker thermostat, also known as the cycling thermostat, controls and regulates the ice maker ejection cycle by monitoring the temperature inside the freezer to determine when to release the ice into the bin and start the ice making cycle again. If your ice maker is making unusual noises, or if the ice maker is not making or dispensing ice, there could be an issue with the thermostat. Before you begin this repair, make sure the power is disconnected from your refrigerator, and that any food that may spoil is safely stored. This is an OEM part and is sourced directly from the manufacturer. This thermostat is sold individually, and comes with two attachment clips.
Fixes these symptoms
Ice maker not making ice
Ice maker won’t dispense ice


Installation Instructions
Wayne from Leesburg, FL says,

No ice in ice trey
The easiest thing to do was pull the ice make off. After taking the 3 screws out of the wall of the freezer, take a screwdriver (flathead) and push on the tab for the electrical plug and wiggle the co...read more

Your Price
$6.46
Compression Nut
PartSelect Number PS11743305
Manufacturer Part Number WP627018
The compression nut is used as a connection between the water supply line and other components in your refrigerator such as your ice maker and your water dispenser. Tools required for this repair include a pair of pliers and a socket set. Before installing this part you should take all perishable foods out of your refrigerator and store them somewhere cool, unplug the refrigerator from the power source, and shut off the water supply. This repair may require you to wear work gloves to protect your hands, and is considered an easy do-it-yourself fix.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
harry from murfreesboro, TN says,

Water leaking from bottom of fridge
The line going from the ice maker fill valve ruptured and leaked water on the floor. The outlet fitting for the ice maker water inside the freezer was plugged with ice which caused the pressure to bui...read more

Your Price
$47.21
Single Outlet Water Valve Kit
(9)
PartSelect Number PS358631
Manufacturer Part Number 4318047
This part is a solenoid-operated switch located at the bottom of the refrigerator. When the water inlet valve is turned on, water is released from the supply line through the water valve and into the compact icemaker mold. The kit includes the mounting hardware and bracket plastic tubing fittings. The retaining nut must be cut off the plastic water line and gently pushed into the new valve. To remove, press down on the ring that the tube slides into. Refer to the installation instructions for further guidance. Please note: the manufacturer has redesigned this part and it can appear different than the original. It has a new quick connection.
Fixes these symptoms
Ice maker not making ice
Leaking


Installation Instructions
Kevin from Boston, MA says,

no water getting to ice maker
The ice maker had been slowly dying and one day just stopped making ice. No water was getting to the trays.

I read that this could be caused by a failure of the valve, even though the cont...read more

Your Price
$95.12
Recirculating Pump - 60Hz
(5)
PartSelect Number PS11740331
Manufacturer Part Number WP2313628
A recirculating pump is used with standalone ice cube makers. It circulates the water over the top of the evaporator plate, which produces a layer of ice that is then broken down into ice cubes. If you notice that your ice maker is no longer producing ice or there is no water flowing over the cooling plate, this could be due to the recirculating pump not working. Be sure to keep the pump clean and free of build-up. This pump is 5.75 inches in length, 4.75 inches in width, 4.25 inches in height and weighs 0.81 lbs. This is a genuine OEM appliance part that comes directly from the manufacturer.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
Richard from North Wilkesboro, NC says,

was not making ice
diagnosed no water flow over evaporator checked voltage into pump then checked pump with ohm meter ordered pump and installed by removing access cover and water holding assembly installed new pump rep...read more

Your Price
$18.30
Door Light Switch
(10)
PartSelect Number PS11738900
Manufacturer Part Number WP2149705
The purpose of the light switch in your refrigerator is to automatically turn on the light when the door is opened. If the light does not come on automatically when you open the door, the contacts inside the light switch may be burned out, meaning it is time to replace the switch. This package contains both the new light switch and a small plastic spacer. To complete this repair, you will need to remove the control panel section of your refrigerator. The only tools you will require for this repair are a 1/4-inch nut driver and maybe a small flat blade screwdriver. Be sure to disconnect the power source from the refrigerator before completing this repair.
Fixes these symptoms
Light not working


Installation Instructions
Randy from Hays, KS says,

Broken light switch
Took all the screws out of the plastic shroud that encloses the switch .There only four that I needed to remove, were the two in front where the switches that go,they go in horizontally and two in the...read more

Your Price
$46.87
Ice Maker Bin Thermostat
(10)
PartSelect Number PS11740332
Manufacturer Part Number WP2313633
This is a bin thermostat made for standalone ice makers to activate the ice maker shut-off when bin is full. It senses how much ice is in the bin to determine if it should produce more ice or activate shut-off. The bin thermostat may need to be replaced if bin is overfilled, underfilled, or not producing ice. Thermistor can be tested with an ohm meter. This part is made of plastic and metal, and is white in color. This is an authentic part sourced from the original manufacturer.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
Ray from Terry, MS says,

Ice maker overfilling with ice and would not stop production when full.
Very easy to replace. Down load the Manual online for a completely operating manual. Thermistor can be tested with an Ohm Meter. Proper values are listed in operating manual....read more

Your Price
$4.40
Inlet Hose Washer
(1)
PartSelect Number PS11757437
Manufacturer Part Number WPY013783
This inlet hose washer, also known as a high pressure inlet hose washer, is used in washing machines, refrigerators, freezers, and dishwashers. The function of this part is to create a watertight seal in the appliance. If your gasket gets dry and brittle over time it will start to crack and will lose its function. In this case, it is important to replace it. Refer to the manual provided by the manufacturer for further installation instructions and accurate guidance. As a safety precaution, remember to unplug your washer from the power source before beginning.
Fixes these symptoms
Leaking


Installation Instructions
Roger from Lore City, OH says,

(Portable ) The Hose Hook up from the dishwasher to the kitchen faucet would not seal. After replacing the hoses the connection hoses sealede.
tilted the dishwasher back so the bottom was exposed and unhooked the old hoses, then removed old hoses through the back side of the dish washer then fed the new hoses through the back and hooked them...read more