Frigidaire Microwave Motors

Your Price

$77.55

Frigidaire Microwave Motor

★★★★★

5 Reviews

PartSelect Number PS12071283

Manufacturer Part Number 5304509440

This motor rotates the glass turntable in the microwave and accepts a D- shaped shaft.

Fixes these symptoms

Tray won’t turn
See more...

Your Price

$32.62

Frigidaire Microwave Motor Synchronous

★★★★★

20 Reviews

PartSelect Number PS3529208

Manufacturer Part Number 6549W1S011B

This AC synchronous motor is a genuine OEM replacement part specially made for microwaves. It operates on an alternating current, and it is responsible for rotating the turntable to ensure even heating of your food. The motor can fail due to physical damage or malfunctioning internal components such as the bearings. If your turntable is not rotating, you will need to replace the motor. You can find it underneath the microwave cavity, near the center. Disconnect the microwave from the power source and remove the cover. Turn the microwave over and remove the bottom panel to access the motor. Disconnect the motor from its mounting location, and then insert the new motor in its place. Ensure the new motor is securely attached before reassembling the appliance.

Fixes these symptoms

Noisy
Tray won’t turn
See more...

Installation Instructions

Steven from Oak Forest, IL

Motor Burned Out On Turntable

My 8 year old daughter cleaned the inside of the microwave with enough water to rival a tsunami. Resulted in a clean microwave with a fried out motor that no longer revolved. Part came quickly. Took cover and bottom off to get to the part. One screw held it on and a plug. Removed those, put on new part and she was good to go. No trip to home depot today. Read more...

Your Price

$64.95

Frigidaire Microwave Turntable Motor

★★★★★

2 Reviews

PartSelect Number PS979515

Manufacturer Part Number 5304440021

This turntable motor is used in microwaves. This is what rotates the glass tray so that your food is heatied evenly. The specs for this synchronous motor are 120 Volts, 60Hz, 3rpm, and 2.1 Watts. It features two 3/16-inch male spade terminals, which is what attaches to the internal wiring of your appliance. The motor also includes mounting holes; there are two mount holes on either side of the part. This replacement motor is approximately two inches in diameter, and it is sold individually. Before you attempt this repair make sure you unplug your microwave.

Fixes these symptoms

Tray won’t turn
See more...

Installation Instructions

steve from New Bern, NC

Turntable stoped working

Removed the 3 screws to drop the lower panel and, removeed the turn table plate and ring. Then removed the 2 screws holding the motor, the 2 wires attached to the motor and removed the old motor.Replaced the new motor in the reverse order. DO NOT FORGET TO UNPLUG THE MICROWAVE FIRST. Read more...