Weber Grill Parts

When the lower panel of a gas grill rattles or pulls away from the cabinet, worn mounting hardware may be responsible. This hardware pack provides the fasteners and washers needed to hold a compatible bottom panel securely in position. Check for loose screws, damaged threads, missing washers, panel distortion, and rust around the mounting points before ordering. A badly corroded panel or frame may also require replacement. Use the grills full model and serial details to confirm fit. Shut off and disconnect the fuel source, then wait until every surface is cool. Support the panel during installation and start all screws loosely before tightening them evenly.

The bottom panel attaches to the rear panel and the side frames. This panel is an OEM from Weber for use in grills. It is available as an individual replacement part. If this item becomes broken it will need to be replaced and may require a wrench set and a screwdriver during the installation.

This genuine OEM Weber part is sold individually. If the magnets are rusted or damaged they will not keep the doors shut and would need to be replaced. To prevent your frame or magnets from rusting it is recommended to always cover your grill after use and store in in a dry environment.

Genuine Manufacturer Approved Stainless steel burner tube used on some Weber Gas Grills. This part is Sold Individually. The burners are the part of the grill that the flame rises from. Depending on your grill you may have 3, 4, 6 or more of these.

This is a genuine manufacturer sourced replacement thermometer designed for use with Weber grills. It can be used to measure temperature inside the grill and the temperature of the food. Mounting tab fits into slot in the bezel to secure the position of the gauge. This part is made out metal and it is sold individually. Please note the, bezel is sold separately. Dial reads 150 - 700 degrees F.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Weber grills. It is an identical replacement for a missing or damaged bottom panel for 4 burner that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for the correct location and application of this component. Keep in mind this high-quality item is made of durable metal and is sold individually.

This replacement bottom plate is designed to fit select outdoor propane grills and provides stable support for the propane tank at the base of the grill frame. Constructed from coated sheet metal for durability, it resists wear from heat, moisture, and outdoor exposure. The plate includes mounting hardware for secure attachment to the rear and side panels (sold separately). Over time, the original plate may warp or rust, compromising safety and stability—making replacement essential for maintaining your grill’s performance.

Connect the grill hose and regulator to the main gas line with this bulkhead assembly for select gas grills. It includes a metal connector, mounting bracket, screw, and washer. Replace it if the connector is corroded, damaged, or leaking. Turn off the gas supply before repair. Have all connections checked for leaks before using the grill. Confirm fit with the exact model number.

This is an authentic OEM part. The RHS tool holder with hardware is compatible with several Weber grills, and is sold individually. This metal component is fastened to the side of the grill, and used to hold grill tools. A wrench and a screwdriver may be required for the repair. Please refer to the manual for further safety and repair instructions.