3351001 Weber Grill - Overview

This is an authentic Weber replacement part that has been sourced from the original manufacturer to be used with natural gas grills. The brass coupler is used to connect the fuel hose to the natural gas supply. This quick disconnect is sold as an individual replacement part, tools may not be needed to install this item.

This is a Genuine Manufacturer Sourced replacement part used on a variety of Weber Grills. This is a Metal (Aluminum) assembly used to prevent drippings and food particles from marring your deck or patio.

This is an authentic OEM sourced replacement part designed for use with Weber grills. These rails are used to hold the grease/drip funnel tray to the underside of the grill so you can slide the tray in and out for easy cleaning. This set includes two (2) aluminum bottom tray rails with four (4) screws used to mount rails. To complete this repair you will need a screwdriver.

This is an authentic kit made for the lid on Weber grills. This is a 14-part set that includes two posts, two retaining clips, and ten hex nuts. The posts are used to secure the lid to the body of the grill while allowing it to swing freely as a hinge. The ends of the posts have small holes that the retaining clips slide into to keep them in place.

This is an authentic Weber replacement part, sourced from the original manufacturer for use with outdoor gas grills. The special hardware pack is commonly used to secure the gill's lid. This hardware pack is sold as an individual replacement part.

This is an original Weber part manufactured for use with outdoor grills. The control panel plugs with screws fasten the control panel to the side frame. Only two plugs are required to secure the control panel, and this set will include both plugs, and two screws, please note the set is sold individually.

This replacement burner tube set is supplied directly from original equipment manufacturer. It is commonly use on Weber grills. Burners are a key component of a gas grill because, it is where the flames would rise from. They are connected to control valves. This set includes three (3) stainless steel burner tubes, one (1) carry over tube ...Read moreand the hardware to secure the burners. Replacing burners is a simple task that should only require a wrench. • Make sure gas tank is disconnected • Remove screws securing the old burners • Disconnect old burners from control valves and replace them with a new burners • Secure burners using the included hardware and • Secure the carryover tube • Connect the gas tank and test the burners

This is a Genuine Weber replacement part designed for their Grills. Kit includes: push-button igniter, gas-catcher ignition chamber, white wire, black wire, and instruction sheet. Hassle-free installation enabled by easy-to-follow instructional guide

This kit (Medium Cam Agitator Repair Kit, Washer Agitator Cam Repair Kit, Cam Agitator) is used to repair the agitator. These parts are located inside the agitator auger near the top. You will need to remove the softener dispenser first if your model is equipped with one. This part is driven by the output shaft of the transmission to mov...Read moree the clothes during a wash cycle. The agitator auger rotates one way but not the other, which forces the laundry down and out for a constant tumbling during the wash cycle. The agitator is subjected to a lot of force during the washer wash cycle. Constant and frequent use of the appliance can cause damage, especially during heavy loads. If you’re experiencing a noisy agitator, or an agitator that spins freely in both directions, then it may be in need of repairs. If your agitator is no longer agitating properly, your clothes will not tumble, and will not be washed properly. The agitator repair kit includes an agitator cam, 4 directional cogs, a bearing, thrust spacer, inner cap seal, and a washer. It is constructed of plastic and rubber, and comes in black/white.