Ryobi Multi-Tool Parts

Sleeves, also known as tool holders/adapters, are used to allow you to connect other accessories to a multi-tool, holding and securing them in the process. This sleeve has an approximately 3/4-inch outer diameter and 1/4-inch inner diameter/bore and is compatible with different models of multi-tool. Because this part is a high-use part, it is recommended that you order multiple to avoid running out in the future. To avoid having to replace it as often, make sure to clean the sleeve after each use and handle it with care. If you notice high wear on the sleeve or have difficulty keeping attachments connected, it likely needs to be replaced. To replace it, you may need an Allen wrench, screwdriver or other tools.

This is a manufacturer-supplied component which is specially designed for use with Ryobi power handles. It is an identical replacement for a faulty or a missing motor assembly that was installed on a new unit. The motor is the central component that drives the shaft. To ensure the correct installation of the new part refer to the owners manual and the diagrams of your model. Note, this high-quality motor assembly is sold individually. Keep in mind, the #562408002 Rubber Gear Cap is sold separately.

This is an OEM part sourced directly from the manufacturer. The spline shaft assembly is found in multi-tool heads from Ridgid and Ryobi. This part is made of metal, and is used to attach the tool head to the base and transfer power from the motor to the tool head. You may require a screwdriver when replacing this item. The spline shaft assembly is available as an individual replacement part.

This is a Genuine OEM replacement part used on Multi-Tool Head. This part is made out of Rubber and is sold individually. The purpose of this O-Ring is to provide an air tight seal between the Sleeve and Adapter Blade.