PCL430 Ryobi Multi-Tool - Overview

Sleeves, also known as tool holders/adapters, are used to allow you to connect other accessories to a multi-tool, holding and securing them in the process. This sleeve has an approximately 3/4-inch outer diameter and 1/4-inch inner diameter/bore and is compatible with different models of multi-tool. Because this part is a high-use part, i...Read moret is recommended that you order multiple to avoid running out in the future. To avoid having to replace it as often, make sure to clean the sleeve after each use and handle it with care. If you notice high wear on the sleeve or have difficulty keeping attachments connected, it likely needs to be replaced. To replace it, you may need an Allen wrench, screwdriver or other tools.

Genuine OEM replacement part, this item is sold individually. The purpose of the 661379002 Screw is to secure the accessories to the output shaft assembly on the tools shown below. It is a Hex Head Screw The part number 6800201 Hex Wrench can be ordered to remove and install the screw.

This is a Genuine OEM replacement part used on Multi-Tool Head. This part is made out of Rubber and is sold individually. The purpose of this O-Ring is to provide an air tight seal between the Sleeve and Adapter Blade.

A genuine replacement part that is sourced directly from original equipment manufacturer for use with Ryobi multi-tools. The sanding pad is used to secure the sandpaper, for the correct application make sure to check appropriate diagrams of your model. It is made of durable plastic with metal and it is sold individually.

This is a genuine manufacturer approved replacement part designed for use with power handles. This is the gear cap for the motor. It is made out of rubber and it is sold individually. To complete this repair you would need a screwdriver.

This 120 grit sanding sheet is a genuine OEM sourced item, it is not an aftermarket imitation. It is specially designed for use with Ridgid and Ryobi multi-tools. This is a PSA hook and loop sandpaper. The rough side is called hook and soft side is called loop. The hooks engage into the loop and provide the closure mechanism. Please note, one sheet of sandpaper is included per order.

This sandpaper sheet is a genuine OEM sourced replacement part, not an aftermarket substitution. It is specially designed for use with Ridgid and Ryobi sanders. This 80 grit sandpaper is commonly used for sanding off paint and other materials. One sheet is included per order.

This is a genuine OEM sourced sanding sheet designed for use with Ryobi/Ridgid multi-tool. It is made out of abrasive minerals with paper backing. It is sold individually. To replace this item you would need a screwdriver.