Ridgid Compressor Parts

This is a genuine OEM sourced replacement part designed for use with air compressors. This breather acts as a valve for the fuel tank, it allows for the air to enter the fuel tank but it won't allow fuel or fuel emissions to leave the tank. It is made out of plastic and it is sold individually. No special tools are needed to replace this Breather Assembly, simply screw it in the opening on the crankcase.

This is a genuine replacement part sourced from the original manufacturer for use with edgers, sanders, and miter saws. The special ball bearing is commonly used to reduce friction between a rotating shaft and fixed part assembly. This ball bearing is available as an individual replacement please see model diagram for associative parts.

This genuine manufacturer-sourced part is specially designed for use with Campbell Hausfeld and Ridgid air compressors. The purpose of a pressure switch is to control when the compressor should start and stop building up pressure. There are several reasons it could be leaking air, unfortunately, over time components will wear out and may begin to fail eventually requiring a replacement. Note, this pressure switch cuts in at 120psi and cuts out at 150psi. Keep in mind this high-quality part is sold individually, Please refer to the appropriate diagrams of your model for the correct location and application of this pressure switch.

A genuine OEM supplied anti-vibration pad that is specially designed for use with Ridgid air compressors. This special replacement pad is attached to the main frame helping to support the unit and it also helps to reduce vibrations from a working engine. It is made of durable rubber material and it is sold individually, please note the hardware to secure this part is sold separately.

This replacement regulator knob is a genuine Campbell Hausfeld item designed for Ridgid air compressors. It is a genuine part that allows user to regulate the air pressure in the compressor tank. Please note, this is only the plastic knob not the regulator itself. Includes one item per order. No tools needed to replace this knob, it simply fits over the metal connection fitting.

The relief valve attaches to the discharge T. This item is available as an individual replacement part. It is a genuine OEM sourced part which is specially designed for use with Ridgid compressors. A wrench set may be needed during the replacement of this part. The valve is made out of metal and will need to be replaced if it breaks.

This is a genuine manufacturer sourced replacement anti-vibration mount which is specially designed for use with Ridgid air compressors. It is one of the mounts which helps to secure the pump to the main frame, the rubber material will help to reduce vibrations from a working unit. Over time the part may wear out and crack eventually requiring a replacement, please note this high-quality component is sold individually.

This is a genuine Ridgid replacement part that has been sourced from the original manufacturer to be used with pressure washers. The pressure switch attaches to the regulator and is used to turn the motor on and off based on the pre-set level of air pressure. This item is sold as an individual replacement part.

The female end elbow attaches to the outlet tube. This part is sold individually. This authentic item is supplied directly from the original equipment manufacturer for use with Ridgid compressors. A wrench might be helpful during the installation of this part. It is made out of metal and will require replacing if it breaks.